Cooper Lighting Sure-Lites LEM Bedienungsanleitung

SURE-LITES LEM

page 1

Installation Instructions for the Sure-Lites LEM Emergency Light

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD

ALWAYS BE OBSERVED INCLUDING THE FOLLOWING

1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS

2. 2. Do not use outdoors.

3. Do not use in hazardous locations, or near gas or electric heaters.

4. Do not let power supply cords touch hot surfaces.

5. Do not use this equipment for other than the intended use.

6. Installation is to be performed only by qualified personnel.

7. Install in accordance with National Electric Code and local regulatory agency requirements.

8. The use of accessory equipment not recommended by the manufacturer may cause an

unsafe condition.

9. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

10. SAVE THESE INSTRUCTIONS

INSTALLATION

Step 1 De-energize the circuit at the junction box (J-box) where the emergency light is to be installed.

Step 2 Open the emergency light by inserting a screwdriver in the two slots at the bottom of the unit, then

tipping the cover up off of the backplate.

Step 3 To mount to a junction box - Drill out the appropriate mounting pattern and the wire pass hole in

the backplate to fit the J-box being used.

Step 4 To mount to conduit – Cut out the U shaped knockout on the cover using snips, then attach the

½” conduit hub to the backplate

Step 5 Once the backplate is secured, the housing can be held in place during installation using the EZ

Hang feature. (see Fig. 1)

Step 6 Connect the incoming wires to the LEM power supply wires using the wire nuts provided.

Connect the white wire to neutral. If using 120V, connect the black wire to the hot lead. If using

277V, connect the orange wire to the hot lead. Cap the unused lead. Secure the emergency light

to the wall and/or junction box using installer supplied hardware.

Step 7 Snap the cover onto the backplate.

Step 8 Remove the EZ key battery disconnect.

Step 9 Energize AC supply. The test button should illuminate, and LED heads will illuminate briefly when

the test button is pushed.

Step 10 Adjust the heads as needed. The LEM heads utilize a highly directional beam, so the head is

adjustable in 3 axes, not the usual 2. (see Fig. 2)

Step 11 If the LEM is to be powered down for an extended period after initial installation, replace the EZ Key. This will prevent the battery from discharging

when AC power is removed. However, it will also prevent the battery from charging when AC power is restored, so it must be removed once the

unit is ready for regular operation.

Risk of Electric Shock

Disconnect power at fuse

or circuit breaker before

installing or servicing.

Risk of Fire/Electric

Shock

If not qualiﬁed, consult an

electrician.

Figure 1

Figure 2

Slide snaps

through holes

in housing for

temporary mount

when wiring

SURE-LITES LEM

page 2

OPERATION

Depress the test switch. The LED heads will light and the charge LED will extinguish. LED heads will illuminate as long as the button is

pushed. Release the test switch. The charge LED will illuminate and the LED heads will turn off.

MAINTENANCE: None required. Replace the batteries as needed according to ambient conditions. However, we recommend that the

equipment be tested regularly in accordance with local codes.

NOTE: Servicing of any parts should be performed by qualified personnel. Only use replacement parts supplied by Cooper Lighting Solutions.

CAUTION: This equipment is furnished with a sophisticated low voltage battery dropout circuit to protect the battery from over discharge after its

useful output has been used. Allow 24 hours recharge time after installation or power failure for 90 minute testing.

TROUBLE SHOOTING GUIDE

If LED heads or charge indicator LED does not illuminate, check the following:

1. Check AC supply – verify that unit has 24 hour AC supply.

2. Unit is shorted or battery is not connected.

3. Battery discharged. Permit unit to charge for 24 hours and then re-test.

4. If following the above trouble shooting hints does not solve your problem, contact your local Cooper Lighting Solutions representative for

assistance.

SCHEMATIC

JMP12

JMP11

JMP10

JMP9

JMP8

JMP7

JMP6

JMP5

JMP4

BATT

LAMPS

TDI

ICSP

277

JMP13

JMP14

LED/SW

CN4

JK1

LED1

MOV1

MOV2

PR1

R10

R13

R15

R18

R30

SW1

120

CN5

WHITE LEAD - TO NEUTRAL

BLACK LEAD - TO 120V

ORANGE LEAD - TO 277V

CHARGER/DRIVER PCB

BATTERY

LED HEADS

Cooper Lighting Solutions

1121 Highway 74 South

Peachtree City, GA 30269

770.486.4800 Fax: 770.486.4801

7/20/12 049-220

Andere Cooper Lighting Beleuchtungsausrüstung Handbücher

Cooper Lighting

Cooper Lighting Portfolio LD4A Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO LAZER LZR204 Bedienungsanleitung

Cooper Lighting

Cooper Lighting AMETRIX ADY071480 Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting ADH080901 Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO ALL-PRO AL3050LPC Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting LINEA Series Installationsanleitung

Cooper Lighting

Cooper Lighting PROfile AR60S Bedienungsanleitung

Cooper Lighting

Cooper Lighting MIGHT LIGHT LED130 Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo TGS3S401DSRB Bedienungsanleitung

Cooper Lighting

Cooper Lighting MS80 Bedienungsanleitung

Cooper Lighting

Cooper Lighting MS245R Bedienungsanleitung

Cooper Lighting

Cooper Lighting FAIL-SAFE CFE-4 Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting W35HPC Bedienungsanleitung

Cooper Lighting

Cooper Lighting Iris E-5 Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting ATLANTIC PLUS Bedienungsanleitung

Cooper Lighting

Cooper Lighting SURE-LITES HR87 Series Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo L611 Bedienungsanleitung

Cooper Lighting

Cooper Lighting RFM300 Bedienungsanleitung

Cooper Lighting

Cooper Lighting ALL-PRO MST18920L Bedienungsanleitung

Cooper Lighting

Cooper Lighting IRIS MH4CFL42E Bedienungsanleitung

Cooper Lighting

Cooper Lighting HALO MWP20FSUNVDBZ Bedienungsanleitung

Cooper Lighting

Cooper Lighting TopTier LED Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo LZE800SL Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung