Cornelius The Profile PR150 BC Bedienungsanleitung

IMPORTANT:

TO THE INSTALLER.

It is the responsibility of

the Installer to ensure that

the water supply to the

dispensing equipment is

provided with protection

against backflow by an air

gap as defined in

ANSI/ASME A112.1.2-1979;

or an approved vacuum

breaker or other such

method as proved effective

by test.

Water pipe connections

and fixtures directly

connected to a potable

water supply shall be

sized, installed, and

maintained according to

Federal, State, and Local

Codes.

Operator’s Manual

THE PROFILE ICE/DRINK DISPENSER

Model: PR150 BC

IMI CORNELIUS REMCOR INC 500 REGENCY DRIVE GLENDALE HEIGHTS, IL 60139–2268

Telephone (800) 551–4423 Facsimile (800) 519–4423

Specifications

Width: 31.88”

Depth: 27.81”

Counter cutout width: 30.00”

Counter cutout depth: 26.25”

Height above counter: 21.25”

Depth below counter: 29.00”

Ice storage capacity: 150 lbs

Weight empty: 285 lbs

Weight full: 435 lbs

Equipment #: 608

Page 1

INSTALLATION INSTRUCTIONS

COUNTER HEIGHT

(INCHES)

DISPENSER

DEPTH

(INCHES

AVAILABLE SPACE

BELOW DISPENSER

(INCHES)

USE KIT NO.

30 29 1 CONSULT FACTORY

31 29 2 CONSULT FACTORY

32 29 3 620517502

AND

629087406

33 29 4 629087406

34 29 5 629087406

34–1/2 29 5–1/2 629087412

AND

620517502

35 29 6 629087412

36 29 7 629087412

COUNTERTOP INSTALLATION

IMPORTANT: It is the responsibility of the installer to ensure that the drains from the dispensing

equipment is installed and maintained according to Federal, State, and local laws.

1. Locate the dispenser indoors on a level countertop.

The dispenser must be sealed to the countertop. The MOUNTING TEMPLATE (see Figure 1) indicates the

opening that must be cut in the countertop. Locate the desired position for the dispenser, then mark the

outline dimension on the countertop using the dimensions given or use the full size template enclosed.

Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent) approxi-

mately 1/4 inch inside the dispenser outline dimensions and around all openings. Position the dispenser on

the countertop within the outline dimensions. All excess sealant must be wiped away immediately.

2. The drain tube is routed through the large opening in the bottom of the dispenser. See the MOUNTING

TEMPLATE (see Figure 1) for locating the required clearance hole in the countertop for these utility lines.

The power cord is routed through hole in the side of the dispenser electrical control box.

3. SINK DRAIN ASSEMBLY: Connect the drain tube to an open drain. Additional drain tubing is provided with

the Dispenser. The drain tube must continuously pitch downword and contain no “traps” or improper drain-

age will result.

A. Use 3/4–inch nominal plastic pipe.

B. To assureproper drainage, do not allow a “trap” to form in the drain line. Be sure drain line runs flat

with bottom of the dispenser.

IMPORTANT: This dispenser must be installed with adequate backflow protection to comply with

Federal, State, and Local Codes.

4. Clean the hopper interior (See CLEANING INSTRUCTIONS).

Equipment #: 608

Page 2

5. Electrical specifications: 115V/60Hz/5.2A

Connect dispenser power cord to 120 VAC 60Hz 15-Amp 34-wire grounded receptacle.

FOOT PRINT OF UNIT

ON COUNTERTOP

THE ABOVE FIGURE SHOWS THE REQUIRED CUTOUT FOR PLACING THE ICE DISPENSER INTO A COUNTERTOP. THE DASHED

LINE IS THE ACTUAL CUTOUT DIMENSIONS WHILE THE SOLID LINE SHOWS THE AMOUNT OF OVERHANG FOR THE DISPENSER.

COUNTER CUTOUT

FOR DROP IN UNIT

FRONT OF COUNTERTOP

F IGUR E 1. MOUNTING T E MPL AT E

Equipment #: 608

Page 3

30”

31-7/8”

26-1/4”

27-3/16”

Equipment #: 608

McCann's Engineering & Mfg., Co.

C AR B O N AT O R

SPECI FI CATI ONS

-Brass Water Pump with I ntegral Strainer,

100GPH, 250 psi By-Pass

-1/4 MF Co2I nlet, 3/8 MF Water I nlet,

(2) 3/8 MF Soda Water Outlets

-Stainless Steel Base, Rubber Feet for Sound I solation

ELECTRI CAL

-115 VAC 60 Hz Single Phase, 7 amps, 1/3 HP

FEATURES

-Two-Piece Probe Design - Reduces Service Time

-Right Angle Probe Service Cord

-Heat Sink Probe Cap

-I mproved Probe Electronics

E2000 Series

Big Mac

10 1

/2"

12 3

/4"

13 1

/2"

Page 4

Andere Handbücher für The Profile PR150 BC

Inhaltsverzeichnis

Andere Cornelius Spender Handbücher

Cornelius

Cornelius IDC 255 Bedienungsanleitung

Cornelius

Cornelius SUBWAY PEPSI SPIRE 3.0 Konfigurationshandbuch

Cornelius

Cornelius NITROPRO MINI Bedienungsanleitung

Cornelius

Cornelius VIPER Bedienungsanleitung

Cornelius

Cornelius PRISM Bedienungsanleitung

Cornelius

Cornelius HELIX Bedienungsanleitung

Cornelius

Cornelius IDC 255 PROGATE DRIVE THRU UNIT Bedienungsanleitung

Cornelius

Cornelius VENTURE Bedienungsanleitung

Cornelius

Cornelius IDC PRO 255 Bedienungsanleitung

Cornelius

Cornelius Millenium II 4000 Bedienungsanleitung

Cornelius

Cornelius QUEST ELITE QLT 2000 Handbuch

Cornelius

Cornelius Cascata180 Handbuch

Cornelius

Cornelius Enduro-200 Bedienungsanleitung

Cornelius

Cornelius ED22 Series Bedienungsanleitung

Cornelius

Cornelius IDC PRO 255 Bedienungsanleitung

Cornelius

Cornelius QUEST 4000 Bedienungsanleitung

Cornelius

Cornelius 2232 Bedienungsanleitung

Cornelius

Cornelius UltraFlow Bedienungsanleitung

Cornelius

Cornelius FCB POST-MIX DISPENSER Beilage

Cornelius

Cornelius Flavor OverLoad CG5017-1007 Bedienungsanleitung

Cornelius

Cornelius CNB BIB Bedienungsanleitung

Cornelius

Cornelius Remcor TJ45-D Bedienungsanleitung

Cornelius

Cornelius JT20D Bedienungsanleitung

Cornelius

Cornelius Universal 750 2849949xxx Einrichtungshandbuch

Beliebte Spender Handbücher anderer Marken

Silver King

Silver King Majestic SK12MAJ Kurzanleitung

Franke

Franke F3Dn Twin Bedienungsanleitung

STIEBEL ELTRON

STIEBEL ELTRON UltraHot Plus Bedienungsanleitung

DAN DRYER

DAN DRYER 282 Bedienungsanleitung

Essity

Essity Tork 473208 Bedienungsanleitung

CBS

CBS SD300BU-88 Einrichtungshandbuch

Sealey

Sealey MK77 Bedienungsanleitung

Fluid Management

Fluid Management Accutinter 1600 Bedienungsanleitung

Franke

Franke DVS SD99-010 Bedienungsanleitung

Graco

Graco Dispensit 1053-10C Fehlerbehebungshandbuch

ITALTINTO

ITALTINTO i50 Bedienungsanleitung

Coca-Cola

Coca-Cola FREESTYLE 9000 Bedienungsanleitung

Graco

Graco ProMix 2KE Bedienungsanleitung

TECHCON SYSTEMS

TECHCON SYSTEMS TS1251 Bedienungsanleitung

Wayne

Wayne GLOBAL VISTA CNG Bedienungsanleitung

clarsen

clarsen H133 Bedienungsanleitung

PicoBrew

PicoBrew Zymatic Bedienungsanleitung

BOWMAN

BOWMAN BP-007 Bedienungsanleitung