Cornelius ED150 "K" Style Lid Kit Bedienungsanleitung

ED150 “K” Style Lid Kit Installation Instructions

INSTALLATION INSTRUCTIONS

ED150 “K” STYLE LID KITS (P/N 08008, 02390)

THE FOLLWING ICE MAKER UNITS

WARNING:

Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the

user. Verify that all the power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

WARNING:

All ice baffle plates and bin stats, if included or recommended in this kit, must be installed as directed in this manual or

the equipment manufacturer’s instructions.

Failure to comply could result in serious injury, death or damage to the equipment.

WARNING:

All of the attachment screws and plates must be installed as directed in this manual.

Failure to comply could result in serious injury, death or damage to the equipment.

Perform the following procedure to install the lid kit.

Table 1. Applicable Ice Maker Models

ICEMAKER MODELS SIZE (WIDTH)

Cornelius 322/522 (includes AC/WC 322) 22”

Crystal Tips 200/300/400 22”

Ice-O-Matic GC 300/550 22”

Manitowoc 320/420 22”

Scotsman SLC 300/400 22”

Servend S2/4 22”

Table 2. Loose Shipped Parts

Item No. Part No. Name Qty.

152994 Cover, Gray - 08008 1

52934 Cover, Black - 02390 1

2 15506 Lid Assembly 1

3 29565 Bracket 2

4 70217 #8 Screw 6

5 50904 RTV 1

6 90221 Label 1

7 92111 Installation Instruction 1

8 620701902 Acorn Nut, 8-32 Nylon 2

9 620701901 Sealing Washer 2

10 620042928 Baffle, Ice DF/ED150 1

11 620701903 #8 Nylon Washer 2

12 620505804 Insulation Strip 1

Release Date: October 22, 2010 www.cornelius.com Revision: B

ED150 “K” Style Lid Kit Installation Instructions

1. Unpack kit.

2. Place insulation strip (item 12) over studs on the ice baffle (item 10) and insert ice baffle into the lid assembly

(item 2).

3. Place (2) sealing washers (item 9) over studs and (2) flat washers (item 11), then fasten in place with (2) plastic

acorn nuts (item 8).

4. Set ice maker lid assembly on the top of the dispenser.

5. Using the slotted holes in the lid as a template, drill four (4) 0.140" diameter (9/64") holes at the bottom of the slots

(see detail A). Use extreme care not to drill into the hopper. Fasten the lid assembly to the dispenser with two (2)

#8 sheet metal screws (item 4), one on each side.

6. Seal the ice maker to the top of the dispenser as follows:

7. Run beads of RTV (item 5) around the opening in the lid assembly and inside of the perimeter of the ice maker

outline so that the ice maker will set on the RTV.

A. Set the ice maker onto the lid assembly and position it as required.

B. Wipe away the excess RTV.

8. Drill 9/64diameter holes into the ice maker cabinet using the bracket (item 3) as a template. Use extreme care

not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using four (4) #8 sheet

metal screws (item 4).

9. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the bin ther-

mostat if so equipped or required.

10. If the plastic ac or rn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to make

small notches in the back flange of the cover to clear the acorn nuts.

CAUTION:

Bin Thermostat must not interfere with the agitator rotation.

ED150 “K” Style Lid Kit Installation Instructions

Figure 1. ED150 Kit

ED150 “K” Style Lid Kit Installation Instructions

Figure 2. Dispenser Assembly

Andere Handbücher für ED150 "K" Style Lid Kit

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Cornelius Eiswürfelbereiter Handbücher

Cornelius

Cornelius XAC1444 Installationsanleitung

Cornelius

Cornelius Nordic CCM1530 Bedienungsanleitung

Cornelius

Cornelius 1000-Series Bedienungsanleitung

Cornelius

Cornelius Starbucks UC100 Bedienungsanleitung

Cornelius

Cornelius WCC1401-A Series Bedienungsanleitung

Cornelius

Cornelius Enduro-300 IntelliCarb Bedienungsanleitung

Cornelius

Cornelius ID-90 Series Handbuch

Cornelius

Cornelius The Profile PR150 BC Bedienungsanleitung

Cornelius

Cornelius Xtreme 322 Series Bedienungsanleitung

Cornelius

Cornelius "I" Series 227 Bedienungsanleitung

Cornelius

Cornelius CONTINUOUS FLOW ICEMAKER 1400R Bedienungsanleitung

Cornelius

Cornelius FlavorFusion P/N 629088673 Bedienungsanleitung

Cornelius

Cornelius XTREME 631805001 Einrichtungshandbuch

Cornelius

Cornelius 15303 Bedienungsanleitung

Cornelius

Cornelius 500 - Series Bedienungsanleitung

Cornelius

Cornelius AC-300 Bedienungsanleitung

Cornelius

Cornelius TS-061 Bedienerhandbuch

Cornelius

Cornelius 2306 Bedienungsanleitung

Cornelius

Cornelius Xtreme ICE Series Betriebsanleitung

Cornelius

Cornelius Flavor Fusion 620053922 Bedienungsanleitung

Cornelius

Cornelius Nordic CCM1848 Leitfaden

Cornelius

Cornelius Nordic CCM1448 Leitfaden

Cornelius

Cornelius IMD300-15A Bedienungsanleitung

Cornelius

Cornelius I Series Bedienungsanleitung

Beliebte Eiswürfelbereiter Handbücher anderer Marken

Hoshizaki

Hoshizaki KMD-460MWJ Bedienungsanleitung

Sub-Zero

Sub-Zero 315I Gebrauchsanweisung

Unold

Unold 48945 Bedienungsanleitung

Kenmore

Kenmore 2217402A Bedienungsanleitung

GE XPIO43SCSS Bedienungsanleitung

Hoshizaki

Hoshizaki KMD-901MAH Bedienungsanleitung

Whynter

Whynter FIM-450HA Bedienungsanleitung

U-Line

U-Line UMCR014-SC01A Installationshandbuch

Andrew James

Andrew James AJ000522 Bedienungsanleitung

Scotsman

Scotsman CME1356 Bedienungsanleitung

Scotsman

Scotsman ACM 25 Bedienungsanleitung

Kärcher

Kärcher IP 120 Bedienungsanleitung

U-Line

U-Line SS1095 Bedienungsanleitung

Maytag

Maytag MIM1554WRS - Ice Maker Bedienungsanleitung

Hoshizaki

Hoshizaki KM-630MAH Bedienungsanleitung

Princess

Princess Yonanas Bedienungsanleitung

Unold

Unold 48946 Bedienungsanleitung

Electrolux

Electrolux E15IM60GP Bedienungsanleitung