Installation Manual | CMA-795-AEN | Page 4
Preface
Safety Instructions
All the following “Safety Precautions” must be observed during the entire installation and operation of the Everon™ 6200 system.
The Everon™ 6200 system components are designed for maximum safety and reliability when they are installed, used,
and maintained by trained and qualified technicians in accordance with the procedures and instructions contained in this
manual. To assure the safe operation of your system, always follow the safety and operational recommendations in this
manual.
1. M2RU is not a consumer product. Please install and use M2RU in accordance with the instructions.
2. Before installing or modifying any M2RU equipment, read and fully understand the entire instructions in this guide.
3. Only qualified personnel are authorized to install and maintain the M2RU.
4. Changes or modifications to the M2RU equipment not expressly approved by the manufacturer could void the
product warranty and the user’s authority to operate the equipment.
5. The shells of the device have protective ground terminals. During installation, connect the ground terminals securely
to the protective building ground with yellow and green conductors or with braided ground wire. The aerial and feeder
must be adequately grounded.
6. The power source must be within the required range of the device. The rated voltage range for the AC power supply
system is 100 ~ 240 VAC, and the rated frequency range is 50 Hz / 60 Hz. The rated power of the AU, EU, and
M2RU is 80 W, 50 W, and 150 W, respectively. The ground terminal of the three-core power socket used at the
device installation site must be securely connected to the protective building ground.
7. To avoid injuries or damage, use care, and obtain assistance before lifting any heavy system components or
equipment.
8. While fiber optic power levels used in this system are very low, it is advisable to avoid exposing the human eye to the
laser light emanating from a fiber port or plug.
9. Signals coupled from the BTS shall be no greater than +15 dBm, otherwise, the device will not operate normally, and
damage may occur to the circuit.
10. Reserve at least 40 mm of height above the radiation fins during device installation; otherwise, the device
temperature may rise and affect the service life of the device.
11. Follow Electro Static Discharge precautions to avoid any damage to PCB, PSU, etc.
12. Keep equipment powered-off during installing or modifying.
13. Low path loss cables connected to antennas are highly recommended.
14. This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED
INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC License to operate this device.
Unauthorized use may result in significant forfeiture penalties, including penalties in excess of $100,000 for each
continuing violation.
15. This is NOT a CONSUMER device. It is designed for installation by an installer approved by an ISED licensee. You
MUST have an ISED LICENCE or the express consent of an ISED licensee to operate this device.
