Directions for use (V06-07)
Electronic vacuum switch PSA 100 B
Sté COVAL SAS
ZA des Petits Champs
26120 MONTELIER
Tel +33 (0) 4 75 59 91 91
Fax +33 (0) 4 75 59 91 05
http://www.coval.com
e-mail: coval@coval.com
Page 1 / 3
COVAL S.A.S.
ZA des Petits-Champs
26120 Montélier.
France
Tel : 04.75.59.91.91
Fax : 04.75.59.91.05
Email : coval@coval.com
1. Display:
Mode key Selection of the different modes
Keys +/- Changement of the differnet adjustments
LED output 1 & 2 Indicates the state of the contact output
2. Contact output 1 adjustment
Display
The display is alternating between “h1” and the adjusted value.
To adjust the threshold of output 1, push the “mode” key 1
time.
The display is alternating between “H1” and the adjusted value.
To change this adjustment, push “+/-” keys until the requested
value is displayed.
After 5 seconds, thechosen value registers automatically and
the screen returns to the vacuum display.
or
To adjust the hysteresis h1, push the mode key.
To change this adjustment, push “+/-” keys to display the
requested value.
After 5 seconds, the chosen value registers automatically and
the screen returns to the vacuum display.
or
To adjust output 1configuration, push the “mode” key.
To change this adjustment, push “+/-” keys. NO or NC are
displayed. (NO on standard basis).
After 5 seconds, the chosen value registers automatically and
the screen returns to the vacuum display.
