Craftsman 65018 Bedienungsanleitung

Model No.

65018

Assembly Instructions

STORAGE SHED

Español pg. 24

0361315B

Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A.

CAUTIONBEFORE YOU BEGIN...

• Consult your local authorities for any permits

required to construct shed. Prior to the

construction of your shed, check with the local

building code ofﬁcial to review any required permits

or building limitations.

• A level and sturdy foundation is recommended

before shed construction can begin. Site

preparation information is available on pages 9-10.

• Read instructions thoroughly prior to assembly.

This kit contains parts that can be damaged if

assembled incorrectly or in the wrong sequence.

• Please follow instructions.

• Check for all parts before you begin assembly.

Using the provided parts check list on pages 4-8,

verify that you have all the parts required to

construct your shed model. COMPLETE SITE

PREPARATION AND FOUNDATION

CONSTRUCTION BEFORE UNPACKING ALL

PARTS.

• Assistance is required during entire

assembly.

• Proper site preparation required.

• Shed not intended for use in extreme weather

conditions.

• Shed not intended for storage of ﬂammable or

caustic chemicals.

• Store heavy items near the bottom of shed.

• Shed not intended for use by children.

• DO NOT stand, sit, or store items on storage shed

roof.

• Treat carefully in extreme temperatures.

• Repair or replace broken parts immediately.

• Manufacturer is not responsible for damage caused

by weather or misuse.

• At regular intervals inspect your shed to make sure

that assembly integrity has been maintained.

• Periodically check that the location you have

chosen to set your shed is still level.

• This kit contains parts with metal edges. Please be

careful when handling.

• The warranty does not cover damage caused by

Acts of Nature including but not limited to: wind in

excess of 65 mph; tornado; hurricane; microburst;

hail; ﬂood; blizzard; extreme heat; pollution or ﬁre

events.

• Assembly on a foundation other than as described

in the assembly instructions, or assembly on no

foundation, will void the warranty.

•The owner is responsible for securing all permits

and meeting other requirements needed for place-

ment, construction and use.

ASSEMBLY DAY TIPS

SHED CARE AND SAFETY

• Hot items, such as recently used grills, blowtorches,

etc., must not be stored in the shed.

• Heavy articles should not be leaned against the

walls, as this may cause panel distortion and

permanent damage.

• Keep roof clean of snow and leaves.

• Your product is made of materials that will withstand

outdoor use. Exposure to the elements (such as

dust, plant and animal life, moisture and sunlight)

encourages moss, algae, and mold to grow on

outdoor items. To maintain the look of your product,

we recommend cleaning it each year with mild

soap and water. DO NOT use bleach, ammonia, or

other caustic cleaners, and DO NOT use stiff bristle

brushes. Failure to perform annual cleaning could

result in permanent staining of the plastic. This is

not a manufacturing defect and is not covered under

warranty.

• Complete site preparation and foundation

construction before unpacking parts and

beginning assembly.

• DO NOT attempt to assemble on a day with strong

winds.

• DO NOT attempt to assemble on days when

temperature is below 32 degrees.

• Set aside appropriate amount of time to completely

assemble shed.

• Make sure you have assistance nearby to lift and

secure parts in place.

• Wear light duty work gloves while assembling shed.

• Once roof is assembled, a ﬂashlight may be of use

when assembling smaller components inside shed.

• DO NOT use a torque wrench or hand drill to

tighten provided Easy bolts. Use 010210410 Easy

Bolt Easy Driver tool (provided) ONLY.

• Extra hardware is provided for small fasteners for

customer convenience. In some cases, there will be

extra small fasteners once the assembly is complete.

Note: This product contains parts that are used in

different orientations to construct the shed. Please take

note of the orientation of the parts shown throughout

this instruction manual. Failure to follow instructions

could result in damage to parts. Manufacturer is not

responsible for replacing parts lost or damaged due

to incorrect assembly.

PRODUCTS AND REPLACEMENT PARTS

1-855-239-0261

To purchase replacement parts call.

TOOLS NEEDED FOR INSTALLATION

0B00344 –Back panel

0B00334 – Left back corner

0B00335 – Right back corner

0B00343 – Right front corner

0B00357 – Floor

0B00342 – Left front corner

TOOLS NEEDED FOR INSTALLATION

PARTS – WALLS AND FLOOR

IMPORTANT

OPEN ALL BOXES FIRST AND NEATLY LAYOUT PARTS. SMALL PARTS MAY BE CONTAINED IN

EACH BOX. PLEASE REFERENCE THE PARTS LIST WITHIN THIS MANUAL TO VERIFY

ALL PARTS ARE PRESENT.

COMPLETE SITE PREPARATION AND FOUNDATION CONSTRUCTION BEFORE

UNPACKING ALL PARTS.

Easy Bolt Easy Driver

Included in kit

010210410

PARTS / ROOF AND DOORS

0440546A – Window gasket

x1 set

0B00336 – Left door

0B00337 – Right door

0440690 – Window

x1 set

0440631 – D-ring

slide bolt

x1 set

DDD

0463370 – Door Handles

x1 set

PARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS / ROOF AND DOORSPARTS – DOORS

IMPORTANT

OPEN ALL BOXES FIRST AND NEATLY LAYOUT PARTS. SMALL PARTS MAY BE CONTAINED IN

EACH BOX. PLEASE REFERENCE THE PARTS LIST WITHIN THIS MANUAL TO VERIFY

ALL PARTS ARE PRESENT.

COMPLETE SITE PREPARATION AND FOUNDATION CONSTRUCTION BEFORE

UNPACKING ALL PARTS.

0MP000001 –Header Bracket

x1 set

0MR001006 – Ridge beam

0B00331 – Left roof

0B00333–Rear header

0B00332 – Front header

0B00330 - Right roof

0440630 – Vent screen

x1 set

0MR009004–

Roof Support

0102231 – Skylight

0510700– Gasket

0MR002002 – Header Beam

x1 set

IMPORTANT

OPEN ALL BOXES FIRST AND NEATLY LAYOUT PARTS. SMALL PARTS MAY BE CONTAINED IN EACH

BOX. PLEASE REFERENCE THE PARTS LIST WITHIN THIS MANUAL TO VERIFY ALL PARTS ARE

PRESENT.

COMPLETE SITE PREPARATION AND FOUNDATION CONSTRUCTION BEFORE

UNPACKING ALL PARTS.

HARDWARE

Metal hinge plate

0480337 –

Hardware bag

0MP000002 – Hardware bag

Easy bolt 7/8"

x18

*Easy bolt easy driver

.625" Truss head screw

x92

.625" Pan head screw

x12

0480327 – Hardware bag 0480216A – Hardware bag 0480351 – Hardware bag

.25 x .75"

Machine screw

.25 Locking nut

.75" Sealing screw

Rubber washer

Hardware shown at actual size (*Unless otherwise noted.) Extra hardware provided. Not all are used.

0480341 –

Hardware bag

.25 x 2" Hex bolt

0480374 – Hardware

bag

.25 Locking nut

0480370 – Hardware bag

Hardware

Hardware shown at actual size (*Unless otherwise noted.) Extra hardware provided. Not all are used.

0463370 – Door Handle Kit

DDD

.25" Washer

CCC

.25" x 1" Pan head screw

Door Handle Kit - CBMS6301

SITE PREPARATION AND PLATFORM CONSTRUCTION

Materials NOT supplied with 6301 Shed Kit

72"

32 1/2"

Anchoring ﬂoor panel to concrete slab

• Secure shed to concrete slab using masonry

fasteners.

• Dimensions allow for shed to ﬁt within the nearest

1" on each side.

Anchoring ﬂoor panel to wood platform

• Secure shed to wood platform using 1/4" x 3" lag

screws.

Note: Site preparation is recommended for this shed.

Placing the shed on a constructed foundation is required.

Without a constructed foundation, settling could

occur, causing distortion and damage to the shed.

Manufacturer is not responsible for replacing parts

damaged or property lost due to incorrect assembly.

Note: Complete the site preparation and foundation

construction before unpacking parts and beginning

assembly.

To prepare your shed site, follow the below steps:

1) Consult your local authorities for building codes and

covenants before beginning foundation or erecting

shed.

2) Before any digging, check with local utilities to

determine location of buried cables, pipes, etc.

3) Decide which type of foundation you want:

- Concrete slab, 4" thick

- Wood platform

Use exterior grade wood. The wood platform should

be set on pier blocks or footing. Consult your local

retailer for help to determine the best anchoring

method for your particular installation. The provided

plans are sized for the minimum number of cuts to

lumber and plywood.

4) Prepare the building site:

- The ground should slope away from the foundation

area to provide drainage.

- The foundation surface must be ﬂat and level.

- A vapor barrier should be provided to prevent

excessive condensation in the shed.

- Follow local building codes for a proper vapor

barrier.

5) Anchoring the shed to the foundation:

- Consult your local retailer for help to determine

the best anchoring method for your particular

installation.

- To secure the shed to a concrete slab, use masonry

fasteners available at your local hardware retailer.

- To secure the shed to a wood platform, use 1/4" x

3" long lag screws with washers.

32 1/2"

72"

Front

SITE PREPARATION AND PLATFORM CONSTRUCTION/Continued

Materials NOT supplied with 65002 Shed Kit

Wood platform critical spacing

Wood platform materials list

• Check all critical spacing measurements.

Item Qty Size

A 1 32 ½" x 72" x ¾"

B 4 2" x 6" x 69"

C 4 2" x 6" x 9"

D 2 2" x 6" x 32 ½"

32 1

4 1

12"

72"

(APPROXIMATE)

FRONT

Inhaltsverzeichnis

Sprachen:

Andere Craftsman Außenlagerung Handbücher

Craftsman

Craftsman 65088 Gebrauchsanweisung

Beliebte Außenlagerung Handbücher anderer Marken

USP

USP DURAMAX 10 Ft x 8 Ft StoreMax Plus Bedienungsanleitung

TYGO

TYGO Nyland Bedienungsanleitung

Duratuf

Duratuf GL105 Bedienungsanleitung

Viking

Viking SD5300SS Technisches Handbuch

USP

USP DURAMAX Apex Pro 10.5 Ft x 8 Ft 40116 Bedienungsanleitung

ModuLaro

ModuLaro Lojo WC202200 Bedienungsanleitung

Lifetime

Lifetime 6418 Bedienungsanleitung

rollaway container

rollaway container ARPCA24 Bedienungsanleitung

Duratuf

Duratuf Havelock Bedienungsanleitung

X-METAL

X-METAL 4065 Bedienungsanleitung

Outdoor Life Products

Outdoor Life Products FP2030 F Bedienungsanleitung

Royalcraft

Royalcraft Faro 295L Storage Box Bedienungsanleitung

Riverlea

Riverlea Duratuf KIWI KS3 Bedienungsanleitung

Rubbermaid

Rubbermaid 5L45 Bedienungsanleitung

garofalo

garofalo TUSCANY EVO Bedienungsanleitung

OLT

OLT GS84D-FJ-Plywood Bedienungsanleitung

Duratuf

Duratuf Kiwi MK1 Bedienungsanleitung

Eden

Eden CA2988 Bedienungsanleitung