Crestron DM-NAX-8ZSA Bedienungsanleitung
DM-NAX-8ZSA
DM NAX™ 8-Zone Streaming Amplifier
Product Manual
Crestron Electronics, Inc.
Original Instructions
The U.S. English version of this document is the original instructions.
All other languages are a translation of the original instructions.
Regulatory Model: M1845004
Crestron product development software is licensed to Crestron dealers and Crestron Service Providers (CSPs) under a
limited nonexclusive, nontransferable Software Development Tools License Agreement. Crestron product operating
system software is licensed to Crestron dealers, CSPs, and end-users under a separate End-User License Agreement.
Both of these Agreements can be found on the Crestron website at www.crestron.com/legal/software_license_
agreement.
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, visit www.crestron.com/opensource.
Crestron, the Crestron logo, Crestron Toolbox, DM NAX and DM NVX are either trademarks or registered trademarks of
Crestron Electronics, Inc. in the United States and/or other countries. Dante is either a trademark or a registered
trademark of Audinate Pty Ltd. in the United States and/or other countries. Active Directory is either a trademark or a
registered trademark of Microsoft Corporation in the United States and/or other countries. Pandora is either a
trademark or a registered trademark of Pandora Media, Inc. in the United States and/or other countries. SiriusXM is
either a trademark or a registered trademark of Sirius XM Radio Inc. in the United States and/or other countries.
TOSLINK is either a trademark or a registered trademark of Toshiba Electronics Devices & Storage Corporation in the
United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this
document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any
proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or
photography.
©2021 Crestron Electronics, Inc.
Contents
Introduction 1
Physical Description 2
Front Panel 2
Rear Panel 3
Application 5
Web Interface Configuration 11
Access the Web Interface 11
Action 14
Rebooting the DM-NAX-8ZSA 15
Restoring to Factory Default Settings 15
Updating Firmware 16
Download Logs 16
Managing Certificates 17
To Add Certificates 18
To Delete Certificates 18
Save Changes 18
Revert 18
Status 19
Device 19
Network 20
Control System 21
Settings 22
System Setup 22
Date/Time 23
Time Synchronization 23
Time Configuration 23
Auto Update 24
Network 25
Configure DHCP 25
Control System 26
Chimes 27
Zones 28
Zone Settings 29
Bussing 41
Configure Bussing 41
Inputs 42
Configure Inputs 42
DM NAX Streams 43
Product Manual — Doc. 9045A Contents • i
Configure Transmitters 44
Configure Receivers 45
Routing 46
Streaming Services 48
Port Selection 49
Security 51
Current User 52
Users 53
Create a New Local User 54
Add an Active Directory User 55
Delete User 55
View User Details 56
Update User Details 56
Groups 57
Create Local Group 58
Add Active Directory Group 58
Delete a Group 59
View Group Details 59
802.1x Configuration 60
To Configure DM-NAX-8ZSA for 802.1X Authentication 61
Access the Web Interface With the Crestron Toolbox™ Application 62
ii • Contents Product Manual — Doc. 9045A
Product Manual — Doc. 9045A DM-NAX-8ZSA • 1
Introduction
The Crestron DM-NAX-8ZSA is a next generation DM NAX™ Audio-over-IP (AoIP) amplifier that
puts Crestron multiroom audio distribution on the network. It provides eight amplified stereo
zone (16-channel) outputs. Four stereo line-level outputs mirror speaker zone outputs 1-4. A
dedicated streaming service player for each of the eight zones enables complete freedom to
stream different content in every zone. Full DSP capabilities are available on the line and speaker
outputs.
DM NAX is built on AES67 standards with the additional ease of configuration via a web
interface, SIMPL Windows, C#, and/or a RESTful API. It is compatible with DM NVX® endpoints
through an AES67 secondary audio stream and also with third-party AES67 solutions and
Dante® audio networking via the compatibility mode enabled in Dante Controller.
Voltage triggers corresponding to the 4 stereo line-level analog outputs can be used to power
connected external amplifiers on and off. The DM-NAX-8ZSA supports Synchronized Control to
manage a large network of DM NAX devices from a single interface.
For installation information, refer to the Quick Start Guide.
2 • DM-NAX-8ZSA Product Manual — Doc. 9045A
Physical Description
The following sections provide information about the connectors, controls, and indicators that
are available on the DM-NAX-8ZSA device.
Front Panel
The following illustration shows the front panel of the DM-NAX-8ZSA.
PWR: (1) LED, indicates operating power is supplied; illuminates amber
while booting, white when powered on, red when in standby (no audio or
LAN connection), and off when no power is supplied.
LAN: (1) LED, illuminates white when the amplifier is connected to a
network with a valid IP address, and off when the device is not
connected to a network or the IP address is invalid.
NAX: (1) LED, Illuminates white when the AoIP is ready to pass and the
unit's PTP clock is synced, and off when there is no AoIP is passing to or
from an amplifier and/or PTP is not synced.
SOURCE: (8) LEDs, illuminate white when a signal is detected on the
specified input/source, red when there is clipping on an analog input or
bitstream audio detected on a digital input, and off when there is no
signal detected on the specified input/source.
ZONE:(8) LEDs, illuminate white when there is audio output on the
indicated zone, red when clipping or a fault is detected on the zone
output due to overcurrent, over temperature, or low voltage.
Product Manual — Doc. 9045A DM-NAX-8ZSA • 3
Rear Panel
The following illustration shows the rear panel of the DM-NAX-8ZSA.
DM-NAX-8ZSA Rear Panel
DIGITAL INPUTS: (2) JIS F05 female (TOSLINK®) optical fiber connectors,
S/PDIF optical digital audio inputs;
(2) RCA female; S/PDIF coaxial digital audio inputs; Input Impedance: 75
Ohms
ANALOG INPUTS: (8) RCA female comprising (4) unbalanced stereo line-
level audio inputs; Input Impedance: 10000 Ohms;
Maximum Input Level: 2 Vrms
SPEAKER OUTPUTS: (16) 2-pin 7.62 mm detachable terminal block;
Balanced/unbalanced stereo line-level audio outputs,
Output Impedance: 4 Ohms/8 Ohms;
Maximum Output Level: 150 Watts single-ended at 8 Ohms, 300 Watts
single-ended at 4 Ohms, with zones bridgeable up to 500 Watts at 8 Ohms.
LINE OUTPUTS: (8) RCA connectors, female; Comprise (4) unbalanced line-
level stereo audio outputs (mirror corresponding speaker outputs pair 1 – 4);
Output Impedance: 100 Ohms; Maximum Output Level: 2 Vrms;
(2) 5-pin 3.5mm detachable terminal blocks; Balanced stereo line-level audio
outputs (mirror corresponding unbalanced RCA output pairs 1 – 2);
Output Impedance: 150 Ohms; Maximum Output Level: 4 Vrms
I/O Port: (1) single 5-pin Phoenix block that comprises four I/O ports, and a
shared ground
TRIGGER: (2) 4-pin Phoenix connectors for all outputs;
The triggers correspond to the respective LINE OUTPUTS 1-4 and will drive
the individual eight zone amplifiers whenever a signal is routed to the
respective line output.
4 • DM-NAX-8ZSA Product Manual — Doc. 9045A
Ethernet 1: (1) 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port;
Green LED indicates Ethernet link status;
Flashing amber LED indicates Ethernet activity
Ethernet 2: (1) 8-pin RJ-45 connector, female;
100BASE-TX/1000BASE-T Ethernet port;
Green LED indicates Ethernet link status;
Flashing amber LED indicates Ethernet activity
SETUP: (1) Push button: Pressing and holding the SETUP button for 15
seconds with power supplied clears Network Settings and restores the
default DHCP Mode;
Press and hold the SETUP button with power disconnected then connect
the power supply and continue to hold SETUP button for 15 seconds will
perform a factory restore;
(1) LED, illuminates red when the button is pressed, flashes red when reset
has been initiated
CONSOLE: (1) Standard USB 2.0 Type B connector, female
GROUND: 6-32 screw, chassis ground lug 11
10A Fuse: 10 Ampere Fuse
POWER OUTLET: (1) 100-240V~50/60Hz Universal AC; IEC 60320 C14 Main
power inlet, mates with removable power cord (included)
Product Manual — Doc. 9045A DM-NAX-8ZSA • 5
Application
This section shows DM-NAX-8ZSA device in multizone applications.
This application diagram shows the following setup:
lUp to 8 zones of amplification and audio distribution
lLocal line level input
lLocal line level output to an Audio Video Receiver (AVR) mirroring a zone of amplification
lAvailable NVX audio streams to route audio from video sources to non-video zones
lAvailable music streaming services on up to 8 NAX zones
6 • DM-NAX-8ZSA Product Manual — Doc. 9045A
This application diagram shows the following setup:
lUp to 8 zones of amplification and audio distribution
lLocal line level input
lLocal line level output to an AVR mirroring a zone of amplification
lAvailable music streaming services on up to 8 NAX zones
lThe DM-NAX-16AIN is used to carry audio from the DM chassis’ video sources to the NAX
network for routing to non-video zones
Andere Handbücher für DM-NAX-8ZSA
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Crestron Verstärker Handbücher
Crestron
Crestron AMP-2210S Anleitung zur Verwendung
Crestron
Crestron 4K DigitalMedia 3-Series Betriebsanleitung
Crestron
Crestron DM-NAX-8ZSA Bedienungsanleitung
Crestron
Crestron MP-AMP40-70/100V Anleitung zur Verwendung
Crestron
Crestron HD-DA-4KZ-E Series Maßzeichnung
Crestron
Crestron X Series Bedienungsanleitung
Crestron
Crestron PROAMP(I)-7X250 Bedienungsanleitung
Crestron
Crestron PROCISE PROAMPI-7X400 Bedienungsanleitung
Crestron
Crestron on wall speaker Bedienungsanleitung
Crestron
Crestron AMP-1200-100 Maßzeichnung
Crestron
Crestron HD-DA-2 Maßzeichnung
Crestron
Crestron DigitalMedia DM-MD6X4 Bedienungs- und Wartungsanleitung
Crestron
Crestron QuickMedia QM-MD8X8 Bedienungsanleitung
Crestron
Crestron X Series Bedienungsanleitung
Crestron
Crestron HD-DA-2 Maßzeichnung
Crestron
Crestron AMP-225 Maßzeichnung
Crestron
Crestron Adagio AMS-AIP Bedienungsanleitung
Crestron
Crestron CNAMPX-16X60 Bedienungsanleitung
Crestron
Crestron High-Gain Line Amplifier SRD-AMP-1 Bedienungsanleitung
Crestron
Crestron CNAMPX-7X200 Bedienungsanleitung
