CRISTEC
CPS-UNIT-DAA Page 5
1.4 Brief presentation
Designed in partnership with the main French boat builders, the CRISTEC power
units allow to get in a single cabinet the on-board 230VAC protection and a battery
charger.
The power housings meet the European on-going rules. Compact and lightweight,
they provide practical entry for the cabling that reduces mounting time.
The 230VAC user protection is insured by a 16A/30mA differential circuit breaker.
The 230VAC on-board utilisation outputs are protected by 2 off 10 DPN thermo-
magnetic circuit breakers.
The charger function is made by a switch mode charger PCB from our classic CPS
charger range : Selective Programmable Charge.
General characteristics :
- Input voltage : 115 or 230VAC +/-15%
- Input frequency : from 47 to 63 Hz
- Display : green LED for mains present
- Input and output cabling on gland
- Functioning temperature : 0°C/+40°C
- Matt black RAL 9011 and grey RAL 7035, salt atmosphere resistant
- CE standards: EN50081-1, EN50082-1, EN 55011, EN55022, EN60950 & ISO 13297
Charger characteristics :
- Input voltage : 115 or 230VAC +/-15% by internal switch
- Output voltage : 12VDC +/-1%
- Three automatic charge cycles : boost, absorption, floating
- Six hours programmable timed boost by internal switch
¾Position "BOOST ON" for authorize boost
¾Position "BOOST OFF" for inhibit boost
- Charge distributor incorporated into each battery output
- Specific output matched to the engine battery charging on 16A and 25A models
- Selection of the level of charge according to the type of battery by internal switch
¾Plomb/Antimoine (ANT)
¾Plomb/Calcium (CAL)
- Internal potentiometer allows output voltage to be adjusted
- Protection against shorts-circuits and polarity reversal. Fuses on input and output.
- Low noise, thermostatically controlled electric fan on 25A model
