B –Minus Button: reduces the cycle of the motor.
C –Digital Display: shows in which cycle the motor is.
D –Plus Button: used to increase the cycle of the motor with one level.
E –Timer Button: when this button is pushed, the cycle of the motor flashes on digital display and the
motor stops within 15 minutes. It is necessary to keep pushed this button for 3 seconds to activate it. Push
only one time to cancel it.
F –Bulb Button: used to turn on and off the bulb.
INFORMATION ABOUT MAINTENANCE
Section 7-1
Plug out the product, or turn off the power switch, or turn off the safety fuse supplying the chimney hood,
before starting maintenance operation.
Aluminum Filter
This filter is used to catch the oil particles in the air and, thus, it will be blocked after a period of time which will
change depending on the frequency of use of the device. We recommend that this filter is cleaned almost once
a month to make sure that the device does not pose a danger. For this operation, firstly, remove the aluminum
filter. Wash the filters with liquid washing agent and flush with water, and mount it on its place after drying. The
change in color may be observed as the aluminum filters are washed. This is normal and there is no need to
replace the filters. It is also possible to wash the aluminum filter in the dishwashing machine.
Removing Aluminum Filter
1.
Push the lock of the aluminum filter forward.
2.
Then, slightly lower it downwards and push forward. Otherwise, the filter can be defected. Wash the
aluminum filter and mount it again into its place by applying the steps mentioned above inreverse.
Carbon filter (it is for flueless use)
This filter removes the cooking smell. Itcleansthecirculatingairwithinthekitchenin case there is no possibility to
use chimney. Physical life of the carbon filter of the device will expire depending on the frequency of use and
mode of cooking, and that of aluminum filter will expire depending on the cleaning regularly.
In usual use, it should be replaced once in every 4 months at most.
Removing Carbon Filter:
1.
Remove the aluminum filter.
2.
To remove the carbon filter, turn it to the left and pull it towardsyourself.
3.
Mount a new carbon filter.
4.
Mount the aluminum filters.
Section 7-2
Use soft cloth wetted with water to clean the exterior surface of the chimney hood. Never use
abrasive and scratching products for cleaning. The cloth must be applied in the same direction with
the brush in order to avoid scratching of the steel drum. The bulb glasses must not be removed
during cleaning.
