Wilbur Curtis Co., Inc.
Mail: 6913 Acco Street, Montebello, CA 90640-5403 U.S.A.
Phone:
800-421-6150
│ Fax:
323-837-2410
│ T
echnical
Support
Phone:
800-995-0417
(M-F
5:30
a.m.- 4:00 p.m. PST) │ Email: [email protected] │ www.wilburcurtis.com05/2020 F-3639 revM
NOTICE - Do not use cleaning liquids, compounds or powders containing chlorine (bleach) or corrosives.
These products promote corrosion and will damage the nishes. USE OF THESE PRODUCTS WILL VOID THE
WARRANTY.
DAILY CLEANING INSTRUCTIONS
The following cleaning process requires a mild solution
of dish-washing detergent and warm water, and One-Pro
Beverage Equipment Cleaner (Curtis PN WC-79001). Mix
the One-Pro cleaner at a ratio of 1 oz. (28 g.) per 5 gal.
(19 L) of hot water (122°F/50°C min.).
Container
1 Prepare a mild solution of detergent and warm water.
Remove the container from the brewer and remove
the lid. Rinse.
2 Wash - Wipe the exterior surfaces with a sponge
and the detergent solution to remove spills and
debris. Use the detergent solution and a soft bristled
brush to wash the inside of the container.
3 Rinse - Rinse with clean, warm water.
4 Sanitize - Fill the container to the top with One-Pro
cleaning solution, mixed as specied above. Allow
the mixture to soak for 15 minutes, then drain. Fill
the container to the top with warm clean water, then
drain. Fill with water and drain a second time.
5 Disassemble the faucet - Unscrew the faucet
assembly from the container. Then, unscrew the
handle/bonnet assembly from the top of the faucet
and remove. Inspect the seat cup for wear. Replace
the seat cup if it is damaged.
6 Air Dry - Turn the container upside down and allow
to air dry.
Faucet Parts and Lid
7 Wash - Wash the lid and faucet parts with the
detergent solution.
8 Rinse - Thoroughly rinse all parts with clean, warm
water.
9 Sanitize - After rinsing, place the faucet parts in
One-Pro solution, mixed as specied above, and
allow them to soak for 15 minutes.
10 Air Dry - Remove the parts from the sanitizer, rinse
them off thoroughly, and allow them to air dry.
11 Reassemble - When dry, reassemble the handle/
bonnet. Hand tighten the handle/bonnet onto the
top of the faucet assembly. Hand-tighten the faucet
assembly onto the container outlet.
Seat cup
Faucet
Handle
Bonnet
WASH
RINSE
SANITIZE
To dis-assemble the top of
the faucet, grasp the bonnet
and push up on the seat cup,
while unhooking the handle.
