Align holes on upper brace (short) with the holes on the upper leg piece. Insert two carriage bolts and
hand tighten using hex nuts.
Repeat the above step on the opposite side.
From the inside of the leg stand, place a lower brace (short) on both the upper and the lower leg
pieces. Insert two carriage bolts and hand tighten using hex nuts.
Repeat the four steps above on the opposite side.
Wear rubber feet on the bottoms of each lower leg piece.
Tighten all hex nuts with a wrench. This completes the leg stand.
MOUNTING A PLANER OR A JOINTER ON THE STAND
WARNING! TO AVOID serious injury, death, or damage to the machine,
DO NOT mount any machine on the stand until the stand is completely assembled.
DO NOT run the machine until it is mounted on the stand securely.
Mount your machine on the stand. Line up with the corresponding pre-bored holes (as shown below)
at the four corners of the stand. Fasten the machine onto the stand with nuts, bolts and washers.
For technical support, email support@cutechtools.us or call 858-886-7333
