D-Link Securicam Network DCS-2000 Bedienungsanleitung

D-Link

DCS-2000

Internet Camera

Manual

(12/13/2002)

Building Networks for People

Contents

Contents of Package..........................................................................3

Introduction ........................................................................................5

Features and Benefits ........................................................................5

Connections .......................................................................................7

Hardware Installation .........................................................................9

Software Installation ........................................................................10

Installing the Surveillance Software ...............................................15

Using the DCS-2000 .........................................................................19

Firmware Upgrades ..........................................................................40

Using the Surveillance Software .....................................................42

Monitor Program ..............................................................................42

Playback Program ............................................................................72

Appendix ...........................................................................................87

Frequently Asked Questions ................................................87

Troubleshooting ....................................................................88

How to PING Your IP Address ...............................................90

Reset and Restore .................................................................91

I/O Connector .........................................................................92

Adjusting the Cameras Focus ..............................................95

Replacing the Lens................................................................97

Technical Specifications .......................................................98

Contacting Technical Support ......................................................100

Warranty and Registration .............................................................101

Package Contents

Contents of Package





D-Link DCS-2000 Internet Camera





Power Adapter





Installation software and manual on CD





Quick Installation Guide





Camera Stand





Category 5 Ethernet Cable

If any of the above items are missing, please contact your

reseller.

Using a power supply with a different voltage than the one included with the

DCS-2000 will cause damage and void the warranty for this product.

System Requirements





Internet Explorer 5.x or higher t Web Browser

 CPU: Pentium III, 500 MHz or above

 Memory Size: 32 MB (64 MB recommended)

 VGA card resolution: 800 x 600 or above

These are minimum requirements. Please see Appendix xxx for require-

ments for various modes of the enclosed Surveillance Software.

Cautions and Warnings

Warning!

Keep the unit away from direct

sunlight, strong magnetic fields,

excessive dust, humidity and

electronic/electrical equipment

(home computers, facsimiles, etc.)

which generate electrical noise.

Caution!

Use of controls or

adjustments or

performance of

procedures other than

herein may result in

hazardous radiation

exposure.

For your safety, please do

not detach the cover!

To avoid accident of electric shock,

please do not attempt to detach the

cover of the unit or the DC power

supply connector.Customer should

contact a qualified technician

regarding any repair job.

Voltage Alert!

The voltage used must be

the same as that specified on

this unit. Using this product

with a higher voltage than is

specified is dangerous and

may result in a fire or other

type of accident causing

damage.

Introduction

The D-Link DCS-2000 Internet Camera is a full featured survellance system that

connects to an Ethernet, Fast Ethernet or broadband Internet connection to provide

remote high-quality video and audio. The DCS-2000 Internet Camera differs from a

conventional PC Camera because the Internet Camera is a stand-alone system with

a built-in CPU and Web server providing a low-cost solution capable of solving

demanding security and home/office monitoring needs. The Internet Camera can be

accessed remotely, and controlled, from any PC or notebook computer over the

Internet from anywhere in the world. Simple installation procedures, along with the

built-in Web-based interface offers easy integration to your network environments.

Features and Benefits

The DCS-2000 Internet Camera is a stand-alone system requiring no special hardware

or software such as PC frame grabber cards. All that is required is a computer with

the Internet Explorer Web browser (version 5.x or above). Just plug-in the camera and

view the picture from your Internet Camera with a valid IP Address.

Supports a Variety of Platforms

Supporting TCP/IP networking, SMTP e-mail, HTTP and other Internet related

protocols, the Internet Camera can be integrated easily into other Internet/Intranet

applications because of its standards-based features.

Broad Range of Applications

With today’s high-speed Internet services, the Internet Camera can provide the ideal

solution for live video images over the Intranet and Internet for remote monitoring. The

Internet Camera allows remote access from your Internet Explorer Web browser for

live image viewing and allows the administrator to manage and control the Internet

Camera anywhere and any time in the world. Apply the Internet Camera to monitor

various objects and places such as homes, offices, banks, hospitals, child-care

centers, amusement parks and other varieties of industrial and public monitoring.

The Internet Camera can also be used for intruder detection with its motion-detection

mode, capture still images and video images for archiving and many more applications.

Web Configuration

Using the Internet Explorer Web browser, administrators can configure and manage

the Internet Camera directly from its own web page via the Intranet or Internet. Up to

20 user names and passwords are permitted, with privilege settings controlled by the

administrator.

Features & Benefits (continued)

Remote Monitoring Utility

The powerful Surveillance Software application assigns an administrator with a pre-

defined user ID and password who can modify the Internet Camera settings from the

remote site via an Intranet or the Internet. Users are allowed to monitor the image,

record the image to a hard drive, and take snapshots.

Connection to External Devices

Supporting auxiliary Input/Output connectors, you can connect the Internet Camera to

a variety of external devices such as IR-sensors, switches and alarm relays. Combined

with programmable alarming facilities, you can develop a variety of security applications

that are triggered on alarm-based events. The Internet Camera provides an industry

standard in/out external connector for connectivity.

Connections

Ethernet Cable Connector

The Internet Camera’s rear panel features an RJ-45 connector for connections to 10Base-

T Ethernet cabling or 100Base-TX Fast Ethernet cabling. This network port supports the

NWay protocol, allowing the Internet Camera to automatically detect or negotiate the

transmission speed of the network.

DC Power Connector

The DC power input connector is located on the Internet Camera’s rear panel and is

labeled DC 12V with a single socket to supply power to the Internet Camera.

Reset Button

Reset will be initiated when the reset button is pressed once and Power LED begins to

flash.

The Ethernet cable included with the DCS-2000 Internet

Camera is a Category 5 cable. This is the

recommended cable type when the camera is installed

into a 100 Mbps Fast Ethernet network.

Ethernet Cable

DC Power Connector I/O Connector

Reset Button

Factory reset will be initiated when the reset button is pressed continuously

for 5 seconds or when the Power LED begins to light up. Release the reset

button and the Power LED will begin to flash indicating that the Internet

Camera’s settings are reverting back to the factory settings.

I/O Connector

There are two I/O connectors,one for input and one for output situated on the

rear panel. The I/O connectors provide the physical interface to send and receive

digital signals to a variety of external alarm devices. Please refer to the

appendix in this manual for detailed information.

Connections (continued)

Connecting to the Camera Stand

Located on the bottom panel of the Internet Camera, the socket is used to

connect the camera stand onto the Internet Camera by attaching the screw

head on the camera stand into the Internet Camera.

Bottom Panel

Socket for stand

Power LED

LED stands for Light-Emitting Diode.

The Power LED is positioned on the right side of the Internet Camera lens. As

soon as the power adapter is connected to the Internet camera the power

LED will flash red and green several times. The Internet camera is conducting

a quick self-test while the LED flashes. Upon passing the self-test the LED

will turn green to indicate a good connection to an Ethernet port or red to

indicate no connection has been made.

Hardware Installation

Connect an Ethernet cable

Connect an Ethernet cable to the network

cable connector located on the Internet

Camera’s rear panel and attach it to the

network.

Attach the external power supply

Attach the external power supply to the DC

power input connector located on the

Internet Camera’s rear panel and labeled

DC 12V and connect it to your local power

supply.

The Internet Camera comes with a camera

stand with a swivel ball screw head that

can be attached to the Internet Camera

bottom bracket cavity. Attach the camera

stand to the Internet Camera and station it

for your application. There is a hole located

in the base of the camera stand allowing

the Internet Camera to be mounted on the

ceiling or any wall securely.

Connecting the Internet Camera to the Camera Stand

When you have a proper connection the LED will turn from red to green. The

light may cycle on and off and your computer may show an intermittant loss

of connectivity, this is normal until you have configured your Internet Camera.

Software Installation

After you have successfully completed the hardware installation of the DCS-

2000 Internet Camera, it is necessary to install software to configure and operate

the camera. The first step is to run a program on the CD called IP Installer.

The program will allow you to use the Internet Camera with you Internet browser.

The IP Installer program allows you to enter settings that permit the camera to

access the Internet directly or your Ethernet network.

After the IP Installer software program is completed, you will have an operating

and controllable Internet Camera. From your Internet Explorer Web browser

you will be able to access the video and sound from the Internet camera. The

camera has a software program built in (called firmware) built-in Web server.

This Web server is the program that allows the camera to access the Internet

without an attached computer and permits users to view the video and audio

remotely.

After running the IP Installer software program this built-in Web server program,

along with your Internet browser, is the only software needed to actually operate

the DCS-2000 and view the camera remotely.

However it is necessary to install the Surveillance Software from the enclosed

CD to create a truly powerful monitoring and surveillance system. The following

section will detail installing the IP Installer and the Surveillance software.

Installing the IP Installer program

Insert the CD that is included with the DCS-2000 Internet Camera. The IP Installer

program will start up automatically from the CD. If it does not (the Windows

operating system can turn this autorun function off , for example) simply access

the CD from Windows and click on the software program IP Installer.

Click on the Installer button.

Click Installer

Andere Handbücher für Securicam Network DCS-2000

Inhaltsverzeichnis

Andere D-Link IP-Kamera Handbücher

D-Link

D-Link DCS-932L Bedienungsanleitung

D-Link

D-Link DCS-2330L Bedienungsanleitung

D-Link

D-Link DCS-933L Cloud Camera 1150 Bedienungsanleitung

D-Link

D-Link SECURICAM Network DCS-5300W Bedienungsanleitung

D-Link

D-Link DCS-1130 - mydlink-enabled Wireless N Network... Bedienungsanleitung

D-Link

D-Link DCS-6620G - Network Camera Bedienungsanleitung

D-Link

D-Link WIRELESS G DCS-950G Bedienungsanleitung

D-Link

D-Link SECURICAM Network DCS-900 Bedienungsanleitung

D-Link

D-Link DCS-6620G - Network Camera Bedienungsanleitung

D-Link

D-Link SECURICAM Network DCS-5300W Bedienungsanleitung

D-Link

D-Link DCS-5000L Bedienungsanleitung

D-Link

D-Link DCS-2132L Bedienungsanleitung

D-Link

D-Link DCS-5220 Bedienungsanleitung

D-Link

D-Link Securicam Network DCS-2000 Bedienungsanleitung

D-Link

D-Link SECURICAM Network DCS-2120 Bedienungsanleitung

D-Link

D-Link SECURICAM Network DCS-2100+ Bedienungsanleitung

D-Link

D-Link DCS-942L Handbuch

D-Link

D-Link SECURICAM Network DCS-3220G Bedienungsanleitung

D-Link

D-Link DCS-6620G - Network Camera Bedienungsanleitung

D-Link

D-Link DCS-5211L Bedienungsanleitung

D-Link

D-Link DCS-2800LH-EU Bedienungsanleitung

D-Link

D-Link SECURICAM Network DCS-2100 Bedienungsanleitung

D-Link

D-Link DCS-5030L Bedienungsanleitung

D-Link

D-Link DCS-1110 - Network Camera Bedienungsanleitung

Beliebte IP-Kamera Handbücher anderer Marken

FLIR

FLIR Exx series Bedienungsanleitung

Avigilon

Avigilon H4A-BO1-IR Bedienungsanleitung

Digital Watchdog

Digital Watchdog DWCA-C128-64 Bedienungsanleitung

ShareTech

ShareTech AV1 Bedienungsanleitung

Ezviz

Ezviz C6C Bedienungsanleitung

Melchioni

Melchioni UCAM 2015 Bedienungsanleitung

Geutebruck

Geutebruck G-Cam/ESD-4630 Bedienungsanleitung

Arecont Vision

Arecont Vision MegaBall AV3146DN-3310-D-LG Bedienungsanleitung

Mitel

Mitel 6800i Series Service-Handbuch

Vitek

Vitek VTC-IR403-212NP Bedienungsanleitung

THOMSON

THOMSON DSC - 323W Bedienungsanleitung

AVer

AVer FB2027 Bedienungsanleitung

ENFORCER

ENFORCER EV-T5105-N2SQ Bedienungsanleitung

Wansview

Wansview NC543 Bedienungsanleitung

Eneo

Eneo MCB-64A0003M0A Bedienungsanleitung

deView electronics

deView electronics CBDNI36F Bedienungsanleitung

Swann

Swann SwannEye Bedienungsanleitung

LevelOne

LevelOne IP CamSecure Bedienungsanleitung