D-Link 10/100BASE-TX to 100BASE-FX Media Converter Bedienungsanleitung

10/100BASE-TX to

100BASE-FX

Media Converter

User’s Guide

Rev. 01 (JUN. 2002)

1907M110MM16003

RECYCLABLE

TABLE OF CONTENTS

TABLE OF CONTENTS ....2

INTRODUCTION..............3

ABOUT MEDIA CONVERTER .....................................3

PRODUCT FEATURES ...............................................3

INSTALLATION ...............4

SELECTING A SITE FOR THE EQUIPMENT ...................4

CONNECTING TO POWER .........................................5

SLIDING SWITCH .......................................................5

CONNECTING TO POWER .........................................6

INSTALLING IN A CHASSIS .......................................6

LED INDICATOR .......................................................7

SPECIFICATIONS ...........8

RECYCLABLE

Rev. 01 (Jan. 2002)

6012-9600128

1907M110MM16001

Printed In Taiwan

INTRODUCTION

Thank you for choosing the 10/100BASE Fast Ethernet

Media Converter, The Converter introduced here

provides one channel media conversion between

10/100BASE-TX and 100BASE-FX.

About Media Converter

The Media Converter is a network technology specified

by IEEE 802.3 10BASE-T, IEEE802.3u 100BASE-TX,

100BASE-FX standards.

Product Features

9One-channel media conversion between

10/100BASE-TX and 100BASE-FX

9Fiber media allows: multi-mode fiber using SC,

LC or MT-RJ connector; single-mode fiber using

SC connector

9Auto negotiation of speed and duplex mode on TX

port

9Auto MDI-X on TX port

9One slide switch for configuring fixed half/full

duplex modes

9Store-and-forward mechanism

9Back-pressure & IEEE802.3x compliant flow

control

9Full wire-speed forwarding rate

9Front panel status LEDs

9Used as a stand-alone device or with a chassis

9Hot-swappable when used with a chassis

INSTALLATION

This chapter gives step-by-step installation instructions

for the Converter.

Selecting a Site for the Equipment

As with any electric device, you should place the

equipment where it will not be subjected to extreme

temperatures, humidity, or electromagnetic interference.

Specifically, the site you select should meet the

following requirements:

1. The ambient temperature should be between 32

and 104 degrees Fahrenheit (0 to 40 degrees

Celsius).

2. The relative humidity should be less than 90

percent, non-condensing.

3. Surrounding electrical devices should not exceed

the electromagnetic field (RFC) standards for

IEC 801-3, Level 2 (3V/M) field strength.

4. Make sure that the equipment receives adequate

ventilation. Do not block the ventilation holes on

each side of the switch or the fan exhaust port on

the side or rear of the equipment.

5. The power outlet should be within 1.8 meters of

the switch.

Connecting to Power

1. This Converter is a plug-and-play device.

2. Connect the supplied AC to DC power adaptor

with a power voltage of 7.5Vdc/1.5Amp to the

receptacle on the rear panel of the converter, and

then attach the plug into a standard AC outlet

with a voltage range from 100 to 260 Vac.

Sliding Switch

There is a sliding switch for duplex mode setting for

fiber port. Refer to the table below for more details.

Half

Duplex

Full Duplex

(default)

Connecting to Power

3. This Converter is a plug-and-play device.

4. Connect the supplied AC to DC power adaptor

with a power voltage of 7.5Vdc/1.5Amp to the

DC-Jack on the converter, and then attach the

plug into a standard AC outlet.

Installing in a Chassis

The Converter can be fit into any of the expansion slots

on a special designed chassis.

yFirst, install the converter onto a carrier supplied with

the chassis:

Step 1- Unscrew and pull out the media converter

board.

Step 2- Plug in the media board to any of the vacant

slot.

Step 3- Fit the converter onto the carrier and use the

screw to secure it.

LED Indicator

The LED indicators give you instant feedback on status

of the converter:

LEDs State Indication

Steady Power onPower

(PWR) Off Power off

Steady Runs at 100Mbps on TX port100 Mbps

(100) Off Runs at 10Mbps on TX port

Steady

(FDX)

Connection in full duplex

mode

FDX stands for

FULL-DUPLEX

Lights off Connection in half duplex

mode

TX Port (TX)

FX Port (FX)

FDX/COL

Blinking

(COL)

Data collision

Steady

(LINK)

A valid network connection

established

Lights off Not Linking

TX Port (TX)

FX Port (FX)

LINK/ACT Blinking

(ACT)

Transmitting or receiving

data

ACT stands for Activity

SPECIFICATIONS

Applicable

Standards

IEEE 802.3 10BASE-T

IEEE802.3u 100BASE-TX & 100BASE-FX

Fixed Ports 1 TX port, 1 FX port

Speed 10/20Mbps for half/full-duplex

100/200Mbps for half/full-duplex

Forwarding

rate

148,800pps

Per Unit- (2 LEDs): Power; Speed( 100 )LED Indicators

Per Port- (2 LEDs): FDX/COL, LINK/ACT

Cable 10BASE-T –

2-pair UTP Cat. 3,4,5, up to 100 m (328 ft)

100BASE-TX --

2-pair UTP Cat. 5, up to 100 m (328 ft)

100BASE-FX --

62.5/125um multi-mode fiber optic cable,

up to 2 km

10/125um single-mode fiber optic cable, up

to 75 km

Dimensions L120 × W88 × H25 mm

Weight 305 g

Power External power adaptor 7.5V 1.5A

Power

Consumption

7.2W Max.

Temperature Operating:0°C ~ 40°C (32°F ~ 104°F)

Storage: -25°C ~ 70°C (-13°F ~ 158°F)

Humidity 10 ~ 90%, non-condensing

Emissions FCC part 15 Class B, CISPR ClassB, VCCI

Class B, CE Mark

Inhaltsverzeichnis

Andere D-Link Medienkonverter Handbücher

D-Link

D-Link DMC-1910R Bedienungsanleitung

D-Link

D-Link DSB-V100 Bedienungsanleitung

D-Link

D-Link DUB-AV300 Bedienungsanleitung

D-Link

D-Link DMC-G01LC Bedienungsanleitung

D-Link

D-Link DE-856SC Bedienungsanleitung

D-Link

D-Link 100BASE-FX Bedienungsanleitung

D-Link

D-Link 1000BASE-TX Bedienungsanleitung

D-Link

D-Link DMC-810SC Bedienungsanleitung

D-Link

D-Link DMC-1910 Bedienungsanleitung

D-Link

D-Link 100Base-FX Bedienungsanleitung

D-Link

D-Link 10BASE-TX Bedienungsanleitung

D-Link

D-Link DMC-G01LC Bedienungsanleitung

D-Link

D-Link DMC-G01LC Bedienungsanleitung

D-Link

D-Link 1000Base-T to mini-GBIC Media Converter... Bedienungsanleitung

D-Link

D-Link DIS-M100G-SW Bedienungsanleitung

D-Link

D-Link DMC-920R Bedienungsanleitung

D-Link

D-Link DMC-530SC Bedienungsanleitung

D-Link

D-Link DUB-AV200 Bedienungsanleitung

D-Link

D-Link DCF-650WK Bedienungsanleitung

D-Link

D-Link 1000BASE-SX Bedienungsanleitung

D-Link

D-Link DVS-210-1 Bedienungsanleitung

D-Link

D-Link DMC-300SC - Media Converter - External Bedienungsanleitung

D-Link

D-Link DMC-805X Bedienungsanleitung

D-Link

D-Link DMC-805X Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung