D-Link DXN-221 - HD MediaBridge Coax Network... Bedienungsanleitung

2D-Link DXN-220 User Manual

Table of Contents

Product Overview ........................................................3

Package Contents....................................................3

System Requirements ............................................. 3

Introduction..............................................................4

Features...................................................................4

Beneﬁts.................................................................... 5

Hardware Overview .................................................6

LEDs ..................................................................6

Connection......................................................... 7

Installation Planning Overview ..................................8

Hardware Installation ................................................11

Software Installation ................................................. 13

Conﬁguration............................................................. 16

Setup .....................................................................18

Status.....................................................................19

Password ...............................................................20

Help .......................................................................21

Firmware Upgrade ...........................................21

Troubleshooting.........................................................23

Technical Speciﬁcations...........................................25

Contacting Technical Support..................................26

Warranty .....................................................................27

Registration................................................................32

Table of Contents

3D-Link DXN-220 User Manual

Section 1 - Product Overview

• D-Link DXN-220 Ethernet Coaxial Bridge

• CAT5 Ethernet Cable

• CD-ROM with Manual and Installation Wizard

• Quick Installation Guide

System Requirements

• Windows Vista®or XP (with Service Pack 2)

• PC with 233MHz Processor, 64MB Memory

• Ethernet Adapter (100MBit/s)

Product Overview

Package Contents

4D-Link DXN-220 User Manual

Section 1 - Product Overview

Introduction

D-Link announces a fast, 270Mbps Ethernet Coaxial Bridge which allows you to network your home computers,

networking devices and gaming devices through the existing coaxial wiring network in your house and share Internet

connections, printers, transfer ﬁles, play games, and more.This kit can be used to network two computers with a 10/100

Base-T adapter through coaxial wiring.

Features

• MoCA 1.1 compliance

• Hardware DES Encryption for network security with password protection

• 270 Mbps Coaxial interface (F-type)

• PC Application based conﬁguration

• User selectable RF channel

• Field upgradable software utilizing a conﬁguration switch

• Easily installed into existing home coax network

• Status LEDs (Power, Ethernet, Coax)

5D-Link DXN-220 User Manual

Section 1 - Product Overview

Beneﬁts

• Seamlessly links consumer entertainment devices from room to room using existing coax wiring.

• Reliably accesses and distributes digital video content, including multiple streams of HDTV, SDTV and

audio – without compromise.

• Enables Ethernet to coax bridge solution with no professional installation required.

6D-Link DXN-220 User Manual

Section 1 - Product Overview

Hardware Overview

LEDs

Power LED

A solid light indicates that the

device is receiving power.

COAX LED

A solid light indicate that the

device has formed a network

over the coaxial cable with at

least one other DXN-220.

LAN LED

A solid light indicates a connection on

the Ethernet port. The LED blinks during

data transmission

100Mbps LED

A solid light indicates that the device has

detected a 100 Mbps connection.

7D-Link DXN-220 User Manual

Section 1 - Product Overview

Hardware Overview

Connection

COAX IN/OUT

Connect one end of a coaxial cable to

the DXN-220 Coax Input/Output port and

the other end to your cable outlet.

Conﬁguration Switch

Conﬁguration Switch put DXN-220 in

either MoCA mode or Conﬁg mode.

Default mode is MoCA mode.

Power

Connect the power adapter included in

the product package of the DXN-220.

Reset

Press and hold at least 10 seconds

to restore device back to the factory

default settings. Press 1 second for

system reboot.

TV OUT

Connect one end of a coaxial cable

to the DXN-220 TV out port and the

other end to your television.

LAN

Connect one end of the CAT5

Ethernet cable to DXN-220 LAN

port and the other end to your

Ethernet device.

8D-Link DXN-220 User Manual

Section 2 - Installation

Installation Planning Overview

The proper cable installation, placement of ﬁlter/ampliﬁer, frequency planning and home preparation for signal

coexistence should be planned out thoroughly before deploying the DXN-220. Inadequate planning will not only affect the

DXN-220 network but also cause unwanted interference with other existing services. The following section discusses

these installation considerations in more detail.

Proper Cable Installation

The rooms qualiﬁed to be part of the DXN-220 network should have an existing coaxial connection and the following

characteristics:

• The room is capable of receiving good quality analog television service (no set-top box required) over the

coaxial cable.

• The room is capable of receiving digital television services using a set-top box.

If the room cannot receive digital or good quality analog television services, the Ethernet-Coaxial network capabilities

may be compromised to this location.

Ampliﬁer Bypassing

An electronic ampliﬁer is a device that boosts a weak signal. The typical ampliﬁer cannot pass DXN-220 network

signal because they are designed to be unidirectional devices. Hence, the ampliﬁer should be uninstalled or bypassed

if possible. To bypass an ampliﬁer, user will need to install Diplexers to separate the DXN-220 signal and other signal

ﬁrst and only install the ampliﬁer between the paths of none DXN-220 network signal.

9D-Link DXN-220 User Manual

Section 2 - Installation

Frequency Planning

The DXN-220 is capable of operating between frequency bands of 800MHz and 1500MHz. In order to avoid interference

between the DXN-220 device and other devices on the same cable network, DXN-220 device must operate at a

frequency spectrum that is different from other devices.

• 5-42MHz (High-speed Internet Access Upstream)

• 42-850MHz (High-speed Internet Access downstream)

• 50-806MHz (Off-Air TV)

• 50-860MHz (Cable TV)

• 950-2150MHz (Satellite L-Band)

One common scenario is where DXN-220, cable television and high-speed Internet service need to coexist.

The cable television in United States operates between 50-860MHz while high-speed Internet service upstream

and downstream operate between 5-42MHz and 42-850 MHz respectively. Hence, the logical choice for

DXN-220 frequency would be between 940-1500MHz. Similar frequency planning approach should be taken into

consideration when dealing with Satellite and off-air antenna.

Terrestrial Television (Off-Air)

If you are receiving terrestrial television service using a broadband antenna, then additional components may have

to be installed in order to be compliant with governmental regulations. DXN-220 network signals operating in the 800

to 1500 MHz range should be prevented from radiating out of the antenna by using a small, in-line Low Pass Filter

(LPF-860Mhz). This ﬁlter will prevent DXN-220 network signals from reaching the antenna.

10D-Link DXN-220 User Manual

Section 2 - Installation

Cable Television (CATV)

For a cable television subscriber, there are no additional components required to work with the DXN-220 on the same

cable network. The user may choose to install the DXN-220 on the network and use it as-is if data rate is acceptable.

Else, user may improve DXN-220 network performance by inserting a Low Pass Filter (LPF-860Mhz) at Point of Entry

(POE) where the drop cable enters the house.

DBS Satellite Television with Terrestrial Television (Off-Air)

The Direct Broadcast Satellite (DBS) uses proprietary satellite channel-stacking switch or Low-Noise Block (LNB) to

distribute the resulting signal (usually 950 to 2150 MHz) in the same cable network that carries the lower-frequency

terrestrial television from an outdoor antenna. Another Diplexer then separates the signals to the receiver of the TV set

and the DBS set-top box (STB).

Most of the satellite switches are not designed to pass DXN-220 network signal and prevents it from forming a network.

It is recommended that satellite signal and DXN-220 network signal should remain on separate cable networks. If

separate wiring cannot be done, then additional components have to be installed:

1. Install Triplexer to separate UHF/VHF, DXN-220, and DBS signals.

2. Install MoCA Coupler switch before the satellite switch.

Existing OSP installed MoCA network

The DXN-220 will automatically scan for an available channel and form Ethernet-Coaxial network. This may cause

issue with the existing OSP MoCA network. It will not be permitted to join the OSP MoCA network unless utilizing the

same frequency and password.

The remedy in this situation is to use the DXN-220 software utility to conﬁgure the DXN-220 to be on the same frequency

with the same privacy network as the existing OSP MoCA network.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere D-Link Netzwerk-Router Handbücher

D-Link

D-Link DSL-500T Bedienungsanleitung

D-Link

D-Link DIR-855L Bedienungsanleitung

D-Link

D-Link DFL-1500 Bedienungsanleitung

D-Link

D-Link DSL-2750E Bedienungsanleitung

D-Link

D-Link DIR-514 Bedienungsanleitung

D-Link

D-Link DSL-2750E Handbuch

D-Link

D-Link DIR-882 Bedienungsanleitung

D-Link

D-Link DIR-890L Bedienungsanleitung

D-Link

D-Link DES-810 Bedienungsanleitung

D-Link

D-Link DSL-200 Bedienungsanleitung

D-Link

D-Link DES-1016D - Switch Bedienungsanleitung

D-Link

D-Link xStack DES-3200 Series Bedienungsanleitung

D-Link

D-Link 2Voice + 4SW VoIP Router DVG-1402S Bedienungsanleitung

D-Link

D-Link DIR-685 - Xtreme N Storage Router Wireless Bedienungsanleitung

D-Link

D-Link DIR-809/B Bedienungsanleitung

D-Link

D-Link DIR-827 Bedienungsanleitung

D-Link

D-Link DSL-500 Bedienungsanleitung

D-Link

D-Link DIR-652 Bedienungsanleitung

D-Link

D-Link DAP-1155 Bedienungsanleitung

D-Link

D-Link Xtreme N DIR-614 Bedienungsanleitung

D-Link

D-Link DSL-604+ Bedienungsanleitung

D-Link

D-Link DIR-865L Bedienungsanleitung

D-Link

D-Link Amplifi DIR-645 Bedienungsanleitung

D-Link

D-Link DIR-1260 Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Korenix

Korenix JetNet 5710G Series Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise