Dacor IF36BNDF Bedienungsanleitung
Introduction Custom decorator panels cover the door trim of Dacor IF36 series refrigerators for an attractive
seamless look that flows into the overall design of the room. Fabricate the panels first, then slide
them into the door trim frames. The panels are custom designed and installed by your cabinet
maker. Installation may be accomplished using various methods. Below are three examples.
For additional installation ideas, see the 3-Door Custom Overlay Installation Guide (PN 102426).
Three Panel Method
The backing panel (1/4” [6 mm] thick) slides behind the trim frames that surround the edges of
each door. The spacer (1/8” [3 mm] thick) compensates for the thickness of the trim frame. The
decorative front panels (3/4” [19 mm] thick maximum) are designed to match the surrounding
cabinets and cover the trim frame around the edges of the door. Countersink the screws used to
assemble the panels.
WARNING: Individual door panels must not exceed the maximum weight specications.
CUSTOM OVERLAY PANEL INSTALLATION
INSTRUCTIONS
REFRIGERATOR MODELS: IF36BNDF, IF36BNNF and IF36INDF
Part No. 100504 Rev. G
Routed Raised Panel Method
Create a routed raised panel and screw or glue the front panel directly to the 1/4” thick backing
panel. Instead of using a spacer panel, route the edges of the front panel to compensate for the
trim frame thickness. For the top two doors on three door models, do not route the inner edges
because there are no trim frames in the center where the doors come together. Countersink the
screws used to assemble the panels.
Spacer panel (1/8”)
Refrigerator door
Front panel (3/4” max.)
Backing panel (1/4”)
Trim frame
surrounding door
Backing panel (1/4”)
Refrigerator door
Front panel (7/8” Max.)
Routed area
(1/4” W X 1/8” D)
Trim frame
surrounding door
Single Panel Method
A single 1/4” panel design can be created using the trim
frames to frame the panel (the trim frames will be exposed).
Single 1/4” panel
Trim frame surrounding door
Refrigerator door
IF36 Panel Overlay Installation
Page 2
B
A
C
DD
D
Three Door Models Two Door Model
Panel Specifications
Front Panels
NOTE: Modification to the dimensions above may be required to allow for
door swing and other considerations depending on the location and type
of cabinet installation.
Backing Panel
(Thickness = 1/4”)
A* 17 7/8” (45.4 cm)
B 42” (106.7 cm)
C 23 13/16” (60.5 cm)
D 36 3/16” (91.9 cm)
Spacer Panel - Routed Area
(Thickness = 1/8”)
A* 17 5/8” (44.8 cm)
B 41 1/2” (105.4 cm)
C 23 5/16” (59.2 cm)
D 35 11/16” (90.6 cm)
Front Panel
(Thickness = 3/4”)
A* 18 1/8” (46.0 cm)
B 42 3/16” (107.2 cm)
C 24” (61.0 cm)
D 36 1/2” (92.7 cm)
* On three door models there are no
trim frames on the inner edges of
each door. The inner door surfaces
must be completely finished for a
refined look (see page 3). Stated
dimensions are to the finished edge.
Door Panel Weight Specifications
Models: IF36BNDF, IF36BNNF
Three Doors
Model: IF36INDF
Two Doors
Panel Maximum
Weight Specifications
1 15 lb. (7 kg)
2 30 lb. (14kg)
2
11
11
No trim
frame*
No trim
frame*
WARNING:
To prevent the unit from tipping
forward and to provide a stable
installation, the refrigerator must
be secured in place with an anti-tip
device.
IF36 Panel Overlay Installation
Page 3
Finishing the Inner Refrigerator Doors Edges on Three Door Models
French Style Refrigerator
Door Detail
Trim frame
screw
Top trim frame
Back of door
Detail “C”
Single Panel Method
Decorative 1/4” thick panel,
finish exposed edge
Front of door
See Detail “C”
and “D”
Detail “D”
Three Panel and Routed
Raised Panel Methods
Trim frame screw
Top trim frame
Refrigerator
door surface
Back of door
Front of door
1/4” backing panel
1/8” Spacer or
front panel inset
Decorative front panel,
3/4” maximum thickness
Fill all joints and finish
exposed edge
Refrigerator door surface
IF36 Panel Overlay Installation
Page 4
Handle Dimensions and Installation
Before installing a custom panel assembly, you must install the•
custom handle hardware.
Dacor recommends handles with larger D-style pulls. If using•
screws with thick heads, they must be countersunk into the
panel before installing the handles.
Any handle designed for use with an appliance should produce•
satisfactory results.
Mounting screw length varies with the total thickness of the•
panels.
On two door model: The top handle is mounted on the left or•
right side of the door depending on door swing.
IMPORTANT: Dacor does not advise the use of single pull knobs.
20" (508mm)
20” Typical
(50.8 cm)
36” Max.
(91.4 cm)
Example of
Door Handle
Detail “C”
Side view - Handle installation on
top doors of three door models
Detail “D”
Side view - Handle installation on
all other doors
Double sided
tape between
doors and
panels
Apply two strips of double sided thin
tape between door front and panel
back on each side of door handle
Counter sink
screw
Handle
Door panel
assembly
Door Door
Trim frame
surrounding door
Door panel
assembly
Handle
Counter sink
screw
Three Door Models Two Door Model
Detail “C”
Detail “D”
Detail “D”
Detail “D”
IF36 Panel Overlay Installation
Page 5
Panel Installation
NOTE: Remove the top door(s) to make panel installation
easier. On three door models secure the inner edges of the
overlays to the door where there are no trim frames using
double sided tape.
With a Phillips screwdriver, remove the trim screws from the•
top trim frame on the freezer and refrigerator door(s).
Remove the trim.•
Lower the overlay panel into the trim frames on the door.•
With the panel in position, replace the top trim. Be sure that•
the panel is inserted completely into the channel for proper
fit and alignment.
Two door model
Refrigerator Doors (Top)
Three door models
Left door
Freezer Door
(Bottom - All Models)
Right door
IF36 Panel Overlay Installation
Page 6
Notes
IF36 Panel Overlay Installation
Page 7
Notes
DacorCorporation●1440BridgeGateDrive,DiamondBar,CA91765●Tel:(800)793-0093●FAX:(626)403-3130●www.Dacor.com
Specications subject to change without notice.
Dacor assumes no liability for changes to specications.
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Dacor Kühlschrank Handbücher
Dacor
Dacor EF48 Series Bedienungsanleitung
Dacor
Dacor EF36IWF Bedienungsanleitung
Dacor
Dacor DRF365 Series Bedienungsanleitung
Dacor
Dacor OF24LS Bedienungsanleitung
Dacor
Dacor EF36LNFSSPA Bedienungsanleitung
Dacor
Dacor EF36BNNFSS Bedienungsanleitung
Dacor
Dacor IF42 Series Technisches Handbuch
Dacor
Dacor IF36LNBOL Benutzerhandbuch
Dacor
Dacor IF36BNDFSF Bedienungsanleitung
Dacor
Dacor DRF36C Bedienungsanleitung
Dacor
Dacor OF24LS Technisches Handbuch
Dacor
Dacor OF24LS Bedienungsanleitung
Dacor
Dacor RF36NDFSS Bedienungsanleitung
Dacor
Dacor DYF42BIWS Bedienungsanleitung
Dacor
Dacor DISCOVERY DYF48BNDI Bedienungsanleitung
Dacor
Dacor PF36BNDF Bedienungsanleitung
Dacor
Dacor EF36BNNFSS Technisches Handbuch
Dacor
Dacor DISCOVERY DYF42BNDI Bedienungsanleitung
Dacor
Dacor EF36BNDFSS Bedienungsanleitung
Dacor
Dacor EF36LNBSS Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
