Dell PowerEdge C6145 Bedienungsanleitung

Dell PowerEdge

C6145

Getting Started

With Your System

Guide de mise en route du système

Primeiros passos com o sistema

Procedimientos iniciales con el sistema

Dell PowerEdge

C6145

Getting Started

With Your System

Notes, Cautions, and Warnings

NOTE:

A NOTE indicates important information that helps you make better use of

your computer

CAUTION: A CAUTION indicates potential damage to hardware or loss of

data if instructions are not followed.

WARNING: A WARNING indicates a potential for property damage,

personal injury, or death.

______________

Information in this publication is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission

of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell™, the DELL logo, and PowerEdge™ are trademarks of

Dell Inc. AMD®is a registered trademark and AMD Opteron™ is a trademark of

Advanced Micro Devices, Inc. Red Hat Enterprise Linux®and Enterprise Linux®are

registered trademarks of Red Hat, Inc. in the United States and/or other countries.

Novell®is a registered trademark and SUSE™ is a trademark of Novell Inc. in the United

States and other countries. Citrix®and XenServer®are either registered trademarks or

trademarks of Citrix Systems, Inc. in the United States and/or other countries. VMware®

is a registered trademarks or trademarks of VMWare, Inc. in the United States or other

countries.

Other trademarks and trade names may be used in this publication to refer to either the

entities claiming the marks and names or their products. Dell Inc. disclaims any

proprietary interest in trademarks and trade names other than its own.

Regulatory Model B05S

January 2011 P/N 6HNH8 Rev. A00

Getting Started With Your System | 5

CAUTION: Restricted Access Location

This server is intended for installation only in restricted access locations as

defined in Cl. 1.2.7.3 of IEC 60950-1: 2001 where both these conditions apply:



Access can only be gained by service persons or by users

who have been

instructed about the reasons for the restrictions applied to the location and

about any precautions that shall be taken.



Access is through the use of a tool or lock and key, or other means of

security, and is controlled by the authority responsible for the location.

Installation and Configuration

WARNING: Before performing the following procedure, review and follow the

safety instructions that came with the system.

Unpacking the System

Unpack your system and identify each item.

Installing the Tool-Less Rail Solution

WARNING: Whenever you need to lift the system, get others to assist you.

To avoid injury, do not attempt to lift the system by yourself.

WARNING: The system is not fixed to the rack or mounted on the rails. To

avoid personal injury or damage to the system, you must adequately

support the system during installation and removal.

WARNING: To avoid a potential electrical shock hazard, a third wire safety

grounding conductor is necessary for the rack installation. The rack

equipment must provide sufficient airflow to the system to maintain proper

cooling.

CAUTION: When installing rails in a square-hole rack it is important to

ensure that the square peg slides through the square holes.

Getting Started With Your System | 6

Pull on the latch release buttons on the end piece midpoints to open

the rail latches.

Align the end pieces of the rails on the vertical rack flanges to seat

the pegs in the bottom hole of the first U and the top hole of the

second U. Engage the back end of the rails until the latches lock in

place.

NOTE:

The rails can be used in both square-hole (item 1 in the following figure)

and round-hole racks (item 2 in the following figure).

Repeat Step 1 and Step 2 to position and seat the front end pieces on

the vertical flanges.

NOTE:

To remove the rails, pull on the latch release button on the end piece

midpoint and unseat each rail.

On each vertical rack flange on the rear, put two screw bases into the

two square holes right above the rail.

Install the chassis stabilizer shipping brackets (optional) on the rear

rack flanges and simultaneously fasten the screws.

NOTE:

To transport systems already installed in the rack, ensure that the two

chassis stabilizer shipping brackets (optional) are in place.

Getting Started With Your System | 7

Slide the system into the rack.

Tighten the thumbscrews to secure the ears of the system to the front

of the rack flanges.

Getting Started With Your System | 8

Optional-Connecting the Keyboard, Mouse, and Monitor

Connect the keyboard, mouse, and monitor (optional).

The connectors on the back of your system have icons indicating which cable to

plug into each connector. Be sure to tighten the screws (if any) on the monitor’s

cable connector.

Getting Started With Your System | 9

Connecting the Power Cable(s)

Connect the system’s power cable(s) to the system and, if a monitor is used,

connect the monitor’s power cable to the monitor. Plug the other end of the

power cables into a grounded electrical outlet or a separate power source such as

an uninterrupted power supply or a power distribution unit.

Getting Started With Your System | 10

Turning on the System

Press the power button(s) either on the front or back of the system and on the

monitor. The power indicators should light.

Andere Handbücher für PowerEdge C6145

Inhaltsverzeichnis

Sprachen:

Andere Dell Server Handbücher

Dell

Dell KY0730481 Installationshandbuch

Dell

Dell PowerEdge R200 Technisches Handbuch

Dell

Dell PowerEdge R830 Bedienungsanleitung

Dell

Dell PowerEdge R300 Bedienungsanleitung

Dell

Dell IP4700 Montage- und Wartungsanleitung

Dell

Dell Wyse 5020 Bedienungsanleitung

Dell

Dell VMware ESX Server 3i Bedienungsanleitung

Dell

Dell EMC PowerEdge XE8545 Bedienungsanleitung

Dell

Dell PowerEdge R200 Bedienungsanleitung

Dell

Dell PowerEdge M820 Systems Kurzanleitung

Dell

Dell PowerEdge C410X Bedienungsanleitung

Dell

Dell 6100 Betriebsanleitung

Dell

Dell Force10 S25-01-GE-24P Bedienungsanleitung

Dell

Dell PowerEdge R210 II Kurzanleitung

Dell

Dell PowerEdge 1600SC Bedienungsanleitung

Dell

Dell PowerEdge C5220 Bedienungsanleitung

Dell

Dell PowerEdge C8000 Bedienungsanleitung

Dell

Dell P570 Bedienungsanleitung

Dell

Dell Dimension 4100 Leitfaden

Dell

Dell PowerEdge Bedienungsanleitung

Dell

Dell PowerEdge 8450 Installations- und Betriebshandbuch

Dell

Dell PowerEdge FN410S Bedienungsanleitung

Dell

Dell PowerEdge 2450 Bedienungsanleitung

Dell

Dell PowerEdge systems 6300 Service-Handbuch

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

MSI

MSI P1-109N-L70 Bedienungsanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

NEC

NEC Express5800/T110j Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung

Planet

Planet NAS-7410 Bedienungsanleitung

Lenovo

Lenovo ThinkSystem SR635 V3 Bedienungsanleitung

Fujitsu

Fujitsu PRIMERGY BX900 Bedienungsanleitung

Asus

Asus RS700DA-E6 PS4 Bedienungsanleitung