Lock Setup Menu
Denler
Touch the keypad to wake up lock and touch *# to enter system
menu. If the lock is in factory reset mode, no admin password
will be asked. If you have already added admin enter your
admin password to enter system menu
Now select opon “1.New User” by touching number 1 on
keypad. Where you can add Face, Fingerprint & RFID Card & PIN
1.New User
2.Delete User
3.System Set
4.Install Set
To add Fingerprint & RFID Card & PIN, select opon 1.Register
Key and if you want to add face ID then select opon 2.Enrol on
face by selecng the respecve opon through keypad number
1 or 2
1.Register Key
2.Enrol on Face
If you select “1.Register Key”, this screen will appear. On this
screen, User Num 00 is the ID assigned by system to specific
entry. Here you can either enter numeric password or touch
RFID card near number 5 or place your finger on fingerprint
sensor to add any of the 3 above biometric details.
User Num 00
Enter Secret Key
_
If you select “2.Enrol on Face”, this screen will appear. On this
screen, User Num 00 is the ID assigned by system to specific
entry. Adjust you face posion in front of camera as guided by
system voice prompt.
User Num 00
Register Face
User Num 00
Enter Secret Key
_
1 2 3 4 5 6 You can set 6 to 9 Digit numeric password. Aer entering
numeric password system will voice prompt “Please Enter
Again” enter the same password again to verify. Then, you will
see “Succeed” message on screen with voice prompt
“Operaon Succeed”
Succeed
Adding new user
Adding PIN, RFID or Fingerprint
Adding Face ID
