DentalEZ Forest Bedienungsanleitung

INSTALLATION

INSTRUCTIONS

2.17.21 0097-305 Rev. T 4 of 4

6200 NE Cherry Drive, Hillsboro, OR 97124 USA (TF) 800 . 423 . 3555 (T) 503 . 640 . 3012 (F) 503 . 693 . 9715

DTE OREGON, INC. DENTALEZ.COM

REAR PIVOT MOUNT

1 of 4

ALERT SYMBOL KEY

The safety notices associated with the following should be

given special attention when they appear in maintenance,

operating and emergency procedures in the guide.

WARNING indicates that the personal safety of the

patient, end user or technician could be compromised

by disregarding the WARNING. Not following instruc-

tions may result in an injury.

CAUTION indicates that a particular procedure

or precaution must be followed to avoid system

irregularity or possible damage to the product.

NOTE indicates special information to improve the

ease of maintaining the product, or to clarify important

information.

CAUTION: To avoid electrostatic discharge (ESD)

damage to electronics, always wear grounded wrist

strap attached to a ground adapter (eg: Banana or

Grounding plug) when handling circuit boards, chair

controls, and cables or working in the area of electrical

circuits.

CAUTION: Field modiﬁcations that alter the electrical

and/or mechanical safety of Forest products conﬂict

with agency construction ﬁle requirements and are not

sanctioned by Forest.

NOTE: Installation Veriﬁcation: Refer to Operator’s

Guide or Service Manual on our website at Forest-

dental.com; perform all operations. If operations

performing as intended installation complete. If

operations not performing as intended, review steps in

installation instructions to conﬁrm correct installation or

call Forest Technical Support at 800-423-3555.

FIG.1: POSITION CHAIR

Tools Required: 1/8”, 5/32”, 3/16”, 3/32” & 5/16”, 3mm, 8mm, and

10mm, Allen Hex Wrenches, 1/8”, 5/16” Allen Sockets with

Torque Wrench, 3/4”, 9/16” & 15/16” Wrench, Flathead Screw-

driver, and Nitrile Gloves.

NOTE: Chairs purchased before July of 2014 contain

metric screws, all chairs purchased after this date

contain standard screws. This kit contains a metric and

standard nut and bolt set to accommodate either chair.

Please check to make sure that you are using the

correct tools and hardware for your chair before

proceeding.

NOTE: If rear pivot is already installed, proceed to page 3.

REAR PIVOT ASSISTANT’S OR CUSPIDOR

MOUNT 3900 CHAIR

STEP 1: Position the chair’s back in the fully up position and

the base in the fully down position. (FIG. 1)

STEP 2: Remove the 6 screws holding the upholstery in place

(Phillips screwdriver). Sit upholstery and hardware aside.

(FIG. 2)

FIG. 2: REMOVE SEAT UPHOLSTERY

ROUTING DRAIN/SUCTION LINE

STEP 1: Remove covers. (FIG. 1)

STEP 2: Route and secure tubings together with zip tie. (FIG. 2)

CAUTION: Do not kink tubings with zip tie.

STEP 3: Make appropriate connection at utility center.

STEP 4: Reinstall covers.

STEP 5: Reinstall upholstery if originally removed.

FIG. 1: REMOVE COVERS.

COVERS

DRAIN LINE FROM

REAR PIVOT UNIT

ZIP TIE

TUBINGS

TOGETHER

FIG. 2: REAR UNIT DRAIN/SUCTION LINE.

2 of 4 3 of 4

REAR PIVOT ASSISTANT’S OR CUSPIDOR

MOUNT 3900 CHAIR (CONTINUED)

LIFT COVER PLATE INSTALLATION (FIG. 3)

STEP 1: Remove existing lift cover plate from chair (1/8” or

3mm hex).

STEP 2: Use pre-existing screws to install the new cover plate

that contains the umbilical routing hole.

REAR PIVOT MOUNT SETUP (FIG. 4)

STEP 1: Install rear pivot bumpers on the mounting plate using

the screws provided (5/32” hex). Choose hole location based

on the desired limits of the link arm that will be attached.

REAR PIVOT MOUNT INSTALLATION (FIG. 5)

STEP 1: Remove 3 shoulder bolts as shown (3/8” or 10mm hex)

If a chair mounted touchpad is installed, remove it during this

step.

STEP 2: Install mounting plate and spacers with nuts and

bolts provided. (5/16” hex & 3/4” socket or 8mm hex & 19mm

socket). If re/installing a chair mounted touchpad, insert the

touchpad mount assembly in place of the provided spacer.

STEP 3: Remove remaining shoulder bolt. Insert spacer and

secure with nut and bolt (5/16” hex & 3/4” socket or 8mm hex

& 19mm socket).

FIG. 3:

STEP 1: REMOVE

BOLTS (3)

STEP 2: INSTALL SPACERS/BOLTS

(3)

REAR PIVOT BEARING ASSEMBLY - ASSISTANT’S

1090/1091/1095/1096/1290

REAR PIVOT BEARING ASSEMBLY - CUSPIDOR OR DUO CONTROL

1490/1495PI/1500PI/1580/1590/1591

CAUTION: Protect work area. Threads to be

sealed must be clean and dry. Shake the product

applicator before use.

FIG. 4:

FIG. 5:

CAUTION: Protect work area. Threads to be sealed

must be clean and dry. Shake the product applicator

before use.

(REAR ADAPTER)

MAIN BEARINGS

1115-314

GREASE

BEARINGS

(LINK 1110-625)

LOCTITE®

(243/242) P/N:

0030-010

(ARM SIDE )

INTERMEDIATE BEARINGS

0010-679

MODEL 3900

CHAIR

ASSISTANT’S UNIT

(LINK = 1110-911)

(REAR ADAPTER)

MAIN BEARINGS

1115-314

MODEL 3900

CHAIR

GREASE

BEARINGS

LOCTITE®

(243/242) P/N:

0030-010

(ARM SIDE )

INTERMEDIATE BEARINGS

0010-728

CAUTION: 2 or 3 screw threads from bolt (1) should

protrude below the nut (13) for proper installation.

CAUTION: 2 or 3 screw threads from bolt (1) should

protrude below the nut (13) for proper installation.

STEP 3: REMOVE BOLT; INSTALL

SPACER/BOLT (1) CUSPIDOR OR

DUO CONTROL

LOCTITE®

(243/242) P/N:

0030-010

Andere DentalEZ Dentalgeräte Handbücher

DentalEZ

DentalEZ Forest Bedienungsanleitung

DentalEZ

DentalEZ Simplicity LED Light Head Handbuch

DentalEZ

DentalEZ StarDental Star Simplicity FX Bedienungsanleitung

DentalEZ

DentalEZ J-Chair J-3 Bedienungsanleitung

DentalEZ

DentalEZ aXcs Series Bedienungsanleitung

DentalEZ

DentalEZ StarDental 430 SWL Flex Bedienungsanleitung

DentalEZ

DentalEZ Star Bedienungsanleitung

DentalEZ

DentalEZ aXcs Operatory Light Bedienungsanleitung

DentalEZ

DentalEZ StarDental Concentrix FX Bedienungsanleitung

DentalEZ

DentalEZ Star Titan Low-Speed Bedienungsanleitung

DentalEZ

DentalEZ Star Bedienungsanleitung

DentalEZ

DentalEZ TruSim Bedienungsanleitung

DentalEZ

DentalEZ Star LUBRICATED PROPHY ANGLE Bedienungsanleitung

DentalEZ

DentalEZ aXcs Basic-Duo Bedienungsanleitung

DentalEZ

DentalEZ StarDental Titan 3 Five Star Bedienungsanleitung

DentalEZ

DentalEZ Star TITAN 3 Bedienungsanleitung

DentalEZ

DentalEZ Heritage CORE Delivery Unit Bedienungsanleitung

DentalEZ

DentalEZ StarDental Blis-sonic K Bedienungsanleitung

DentalEZ

DentalEZ StarDental Titan LubeFree Five Star Bedienungsanleitung

DentalEZ

DentalEZ Heritage CORE Chair Bedienungsanleitung

DentalEZ

DentalEZ Star Aeras 500 Elite Bedienungsanleitung

DentalEZ

DentalEZ StarDental 430 SWL RA Bedienungsanleitung

DentalEZ

DentalEZ StarDental PROPHY STAR 3 Bedienungsanleitung

DentalEZ

DentalEZ StarDental Titan 3 257506 Bedienungsanleitung

Beliebte Dentalgeräte Handbücher anderer Marken

Vatech

Vatech EzRay Air VEX-P300 Bedienungsanleitung

KaVo

KaVo GENTLEpower LUX Contra-angle 25 LP Bedienungsanleitung

DENTSPLY

DENTSPLY SmartLite Focus Bedienungsanleitung

LM ProPower CombiLED Bedienungsanleitung

Owandy Radiology

Owandy Radiology RX-AC Bedienungsanleitung

mectron

mectron Piezosurgery Bedienungsanleitung

Belmont

Belmont CREDIA G1 Bedienungsanleitung

Planmeca

Planmeca Sovereign Classic Bedienungsanleitung

Bego

Bego Fornax T Bedienungsanleitung

Renfert

Renfert SYMPRO Kurzanleitung

Ateco

Ateco AT-301 Bedienungsanleitung

Nevadent

Nevadent NZPS 3 A1 Bedienungsanleitung

Muss Dental

Muss Dental MA 50 Technisches Handbuch

Diplomat

Diplomat Comfort Series Bedienungsanleitung

Dentatus

Dentatus Nyström Bedienungsanleitung

OMS

OMS DUKE EASY Handbuch

OMS

OMS LINEA PATAVIUM Handbuch

BRYANT DENTAL

BRYANT DENTAL Ignis Gesture A-494322 Bedienungsanleitung