DETRUM GAVIN-6C Bedienungsanleitung
TABLE OF CONTENTS
Introduction..........................................................................................................1
Disclaimer ........................................................................................................1
Indications and Symbols for Safe Use.............................................................1
Installation Precautions....................................................................................1
Flying Precautions ...........................................................................................2
Product Description............................................................................................5
Box Contents ...................................................................................................5
Transmitter.......................................................................................................5
Specifications .............................................................................................5
Features......................................................................................................5
Names of Each Transmitter Control...........................................................7
Main Screen .............................................................................................10
Receiver.........................................................................................................11
Specifications ...........................................................................................11
Features....................................................................................................11
Receiver Connections ..............................................................................11
Basic Operation.................................................................................................13
Adjust the Stick Lever Tension.......................................................................13
Change the Location of Throttle Stick ...........................................................14
Turn on/off the Transmitter.............................................................................15
Binding...........................................................................................................16
Range Test.....................................................................................................17
Flight Mode ....................................................................................................17
Dual Rate (D/R) setting..................................................................................18
Model Parameter ...............................................................................................19
Servo Reverse [Rev Set] ...............................................................................19
End Point [End Point].....................................................................................20
Sub Trim [Sub Trim].......................................................................................21
Stick Curve [Stick Curve]...............................................................................21
Throttle Curve [THR Curve]...........................................................................23
Pitch Curve [PIT Curve] (Heli only)................................................................25
Throttle Hold [THR Hold] ...............................................................................26
Mix Set [Mix Set] (Airplane only) ...................................................................27
Delta Mixing [Delta Mix]............................................................................27
V-tail Mixing [V-tail Mix] ............................................................................29
Flaperon Mixing [Flaperon Mix]................................................................31
Throttle to Balance Mixing [THR▶BAL Mix]..............................................33
Veer to Elevator Mixing [Veer▶ELE].........................................................34
Swash Mixing [Swash Mix] (Heli only)...........................................................35
Servo Delay [Servo Delay] (Airplane/Heli only).............................................37
Channel Monitor................................................................................................38
Model Set............................................................................................................39
Select Model [Model] .....................................................................................39
Edit Model Name [Name]...............................................................................39
Select Model Type [Type] ..............................................................................40
Function Set [Func Set].................................................................................40
Trainer Set [Trainer Set] ................................................................................41
Fail Safe [Fail Safe] .......................................................................................43
Timer Set [Timer 1/2/3 Set]............................................................................45
Reset Model [Reset] ......................................................................................46
System Set.........................................................................................................48
Language [Language]....................................................................................48
Calibration [Calibration] .................................................................................48
Stick Mode [Stick Mode]................................................................................49
Key Volume [Key Volume] .............................................................................50
Key Tone [Key Tone]......................................................................................51
Back-light Brightness [Brightness].................................................................51
Contrast [Contrast].........................................................................................51
Back-light Time [Bright Off]............................................................................51
About Information [About]..............................................................................52
- 1 -
Introduction
Disclaimer
Thank you for purchasing this DETRUM product. This is a 2.4GHz digital
proportional R/C system with high performance. In order to make full use of the
features of this product and to safely enjoy your R/C activities, please read this
manual carefully before using. Please install and use this product in strict
accordance with the manual. The company assumes no liability or loss incurred
directly or indirectly from improper use, installation, or any modification of this
product.
Products shall be subject to any changes without additional notices.
This product is suitable for users experienced in operating model aircraft and
aged 14 years or older.
Please fly at a locally recognized model aircraft flying field.
Indications and Symbols for Safe Use
The following symbols used in this manual indicate the precautions regarding
possible danger which may occur following improper operation.
DANGER: Procedures, which if not properly followed, may lead to a
dangerous condition of death or serious injury.
WARNING: Procedures, which if not properly followed, may lead to a
possibility of death or serious injury.
CAUTION: Procedures, which if not properly followed, may lead to a
possibility of property damage, or a danger of injury.
Prohibited Mandatory
Installation Precautions
It is very important to properly install the R/C system on the model aircraft.
GAVIN-6C Instruction Manual
- 2 -
Please refer to the following instructions:
In order to protect the receiver, wrap the receiver with 10mm foam rubber,
and then fasten it with a rubber band or a Velcro strap.
The servos should be installed with rubber gaskets and brass eyelets to
isolate the vibration from the fuselage. When locking the screws, follow the
principle that the rubber gasket does not distort. If the locking is too tight, it
will reduce the vibration-proof performance.
When mounting a servo, make sure that the servo can rotate over its full
travel and check that the push-rods and servo arms do not bind or contact
each other.
When mounting a power switch, keep away from the engine's exhaust pipe
and any places with high vibration. And ensure that you can turn the switch
on/off without binding.
The two antennas of the receiver should be placed at 90 degrees to each
other. Do not place the two antennas twisted together or in parallel.
Flying Precautions
WARNING: Personal injury and property loss may be caused by improper
aircraft handling. Please operate strictly according to the following safety
instructions.
Flying Field and Conditions:
In order to protect the personal safety and their property, please do not fly at
the following places:
Near another radio control flying field
Near or above people
Near residential areas, schools, hospitals or other places where people
congregate
Near high-voltage lines, tall buildings, or communication facilities
Never fly on rainy day, thunder storm, when the wind is strong, and at night.
Always keep away from wet conditions.
GAVIN-6C Instruction Manual
- 3 -
This product is made of precision electronic components and mechanical
parts, please keep away from wet conditions, to prevent the components
damage from water and cause a failure which would lead to a crash.
Always keep away from hot conditions.
This product is made of precision electronic components and mechanical
parts, please keep away from hot conditions, to avoid distortion or damage.
Precautions before Flight:
Always make sure that all servos in the model work properly following the
transmitter stick movements prior to flight. And make sure that all switches
work properly as well.
Always check the remaining capacity of both the transmitter and receiver
batteries before each flying session prior to flight. Low battery capacity will
cause loss of control and a crash.
Always perform a range test before each flying session.
Always check the operation of each control surface before each flying session.
When using the trainer function, please check both the instructor and student
transmitters.
For safety reasons, always set fail safe functions before each flying session.
Especially set the throttle channel fail safe function.
Precautions during Flight:
Never grasp the transmitter antenna during flight. Otherwise, the transmitter
output power will reduce drastically.
Do not point the antenna directly toward the aircraft during flight. When
pointing the antenna directly, the transmitter output is the weakest. The
strong radio wave radiate from the side of the transmitter antenna.
Never turn on and off the power switch of transmitter during flight or while the
engine or motor is running.
Do not touch the engine, motor or other heating device or component during
and immediately after use. These devices or components may become hot
during use.
GAVIN-6C Instruction Manual
- 4 -
For safety, always fly the aircraft in visible range. Flying behind tall buildings
will not only lose sight of the aircraft, but also degrade the RF signal
performance.
Always return the transmitter setting screen to the initial main screen during
flight. Erroneous input during flight is very dangerous.
Precautions in Other Conditions
Never fly in the range check mode (test mode). In the range check mode, the
transmitter output power is greatly reduced, it may cause a crash.
When setting the transmitter during flight preparations, do not set it upright on
the ground. The transmitter may fall to the ground, the sticks may move and
the servos may rotate unexpectedly and cause injury.
Do not touch the receiver antenna directly by hands. Otherwise, the
components may be damaged by static, and this may cause a reduction in
transmission distance of the receiver.
Before turning on the transmitter, always make sure the transmitter throttle
stick and throttle trim are in the lowest position.
Always turn on the R/C system in proper sequence: turn on the transmitter
first, then turn on the receiver, and then turn on the engine or motor. Incorrect
sequence may cause loss of control and personal injury.
Always turn off the R/C system in proper sequence: turn off the engine or
motor first, then turn off the receiver, and then turn off the transmitter.
Incorrect sequence may cause loss of control and personal injury.
- 5 -
Product Description
Box Contents
GAVIN-6C Transmitter
DETRUM RXC7 Receiver
Bind Plug
Instruction Manual
USB Cable (optional)
Simulator Convertor (optional)
9g Servo *4pcs (optional)
NOTE: The set contents depend on the type of set.
Transmitter
Specifications
Parameters
GAVIN-6C Specifications
Coder
6-channel
Transmitting frequency
2.4GHz
Power supply
1.5V AA batteries *4pcs
Consuming current
Test mode: less than or equal to 120mA.
Operating mode: less than or equal to 230mA.
Output power
Test mode: 10mW. Operating mode: 100mW.
Output pulse
1050~1850ms (neutral 1500ms)
Features
It is suitable for airplane, helicopter, and multicopter (multirotor).
You can store a maximum of 30 aircraft models in the transmitter.
Adopting 2.4GHz direct sequence spread spectrum (DSSS) and multiple
frequency-hopping technology, the transmitter has strong anti-interference
GAVIN-6C Instruction Manual
- 6 -
performance.
The ergonomic design enables users to hold the transmitter easily.
The LCD display is designed with straightforward menu and intuitive graphical
interface. It is easy to understand and convenient to use.
This allows adjustment of the sticks lever tension, and there are four
selectable stick modes to meet different operating habits.
With a USB interface, it is easy to upgrade the transmitter firmware to the
latest program.
With fail safe function, it allows to set the positions that the servos move to in
the case of fail.
With trainer function, make it possible that a skilled instructor can teach a
student with flying skills.
With test mode function, it allows to check the environment interference and
the R/C system before each flying session.
GAVIN-6C Instruction Manual
- 7 -
Names of Each Transmitter Control
NOTE: When the Stick Mode is set to MODE 1, the positions of sticks and
digital trims are shown in the figure. The positions are different depending on
the stick mode. For details, please refer to Stick Mode [Stick Mode] (Page
49).
Antenna
Digital Trim (elevator)
Switch (GEAR)
Switch (HOLD)
Digital Trim (rudder)
Elevator Stick
Rudder Stick
Trainer Connector
Exit Key (EXT)
Menu Selection Key
(UP, DOWN)
Neck Strap Attachment
Power Switch LCD Display
Changing Value Key
(R/+, L/-)
Enter Key (ENT)
Digital Trim (aileron)
Digital Trim (throttle)
Aileron Stick
Throttle Stick
Switch (FMOD)
Switch (FLAP)
Switch (TRAINER)
Status display LED
(under the Indicated position
GAVIN-6C Instruction Manual
- 8 -
Antenna
The strong radio wave radiate from the side of the transmitter antenna. Do not
point the antenna directly toward the aircraft during flight.
Carrying Handle
The carrying handle is designed for easily carrying and placing the
transmitter.
Inhaltsverzeichnis
Andere DETRUM Sender Handbücher
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
