© DICTATOR Technik GmbH • Gutenbergstr. 9 • 86356 Neusäß • Germany
Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail info@dictator.de • 20200703
Page 05.023.10
Technical Manual E8
III. Adjustment / Programming - cont.
„P-0“ Position of the door
The parameter P-0 shows the present position of the door when a drive
unit with integrated position control system is connected.
If separate limit switches are used, the values shown in the display have
the following signification:
000 Door is CLOSED (limit switch Door CLOSED has been actuated)
003 Door is OPEN (limit switch Door OPEN has been actuated)
The signification of the values 001/002 depends on the direction in
which the door is moving.
In OPENING direction:
001 Door moves at „normal“ speed (between the positions of the
limit switches creep speed CLOSE and OPEN)
002 Door moves at creep speed
In CLOSING direction:
001 Door moves at creep speed
002 Door moves at „normal“ speed (between the positions of the
limit switches creep speed CLOSE and OPEN)
„P-1“ Crawling speed
This parameter permits to adjust the crawling speed before the position
OPEN. The control system automatically switches to this speed as soon
as the position „Crawling Speed OPEN“ is reached (adjusted with the
parameter „P-8“ or indicated by a separate limit switch).
This parameter, just as all following parameters, is adjusted with the
arrow membrane keys and on the lid of the casing. The adjusted
value is memorized as soon as you change to another parameter or the
display changes back to „P-0“
The value for the crawling speed is adjusted ex works to 40 digits. It
can be increased to a maximum of 100 digits.
The crawling speed before the position Door CLOSED is set in the con-
trol system and cannot be adjusted. However it is possible to adjust the
distance before the position Door CLOSED where the motor changes to
the crawling speed (see parameter „P-9“).
„P-2“ Normal opening speed
With this parameter you can adjust the normal travel speed of the door
for opening. The control system switches automatically to this speed after
an initial acceleration.
The value for this speed is adjusted ex works at 150 digits. This value
can be reduced to min. 100 digits and increased to max. 200 digits
III/2 Parameter
.
