Digicom Michelangelo Gateway Bedienungsanleitung

Michelangelo LAN, ADSL Router

1Router Commander Rel 2.0 02/2002

Michelangelo LAN

Router Commander

Product warranty does not apply to damage caused by lightning, power surges or

wrong voltage usage.

Contents

Documentation ................................................................................................. 4

Introducing DSL Router Commander ..........................................5

1.1 Logging In ............................................................................................. 5

1.2 Getting Ready Information Required ...................................................... 6

Network Setup Overview ..............................................................8

2.1 Configuring the PCs .............................................................................. 9

Configuring your Router with DSL Router Commander ..............10

3.1 Line Configuration ................................................................................. 1 3

3.1.1 Configuring for RFC 2684 (RFC 1483) Bridged .................. 14

3.1.2 Configuring for RFC 2684 (RFC 1483) Routed ................... 20

3.1.3 Configuring for RFC 2225 (RFC 1577) ............................... 22

3.1.4 Configuring for RFC 2516 ................................................... 23

3.1.5 Configuring for RFC 2364 ................................................... 24

3.1.6 Configuring for Transparent Bridge ...................................... 2 7

3.2 RouteTable .......................................................................................... 28

3 . 3 DHCP ................................................................................................... 3 0

3.3.1 Configuring Your Ethernet card for DHCP ............................ 32

3.4 SNMP ................................................................................................... 33

3.5 DSL Monitoring Application .................................................................. 35

Glossary ........................................................................................ 37

Index .............................................................................................43

Software Manual

Documentation

Quick Installation Guide

Please refer to this manual for setting up and connecting your modem/router.

DSL Router Commander Software Manual 1(THIS MANUAL)

This software manual is a softcopy guide that contains information on DSL Router Commander,

a user-friendly user interface that provides a simple way of configuring your router. A

Glossary section is also included to describe the terms used in the manual.

ADSL Ethernet Router Technical Manual 1

The technical manual is a softcopy guide that contains console commands and advanced

router configurationsthat are mostly intended for experienced users.

ATMOS Console Commands Reference Manual 1

The reference manual is a softcopy guide that contains the detailed description of the console

commands. For any advance configurations, you may refer to it for their descriptions.

ISP will be used throughout the manual to denote Internet Service Provider.

1These manuals can be found on the CD-ROM that comes with your package.

Chapter…1

Introducing DSL

Router Commander

DSL Router Commander is a user-friendly interface that allows you to initialize, view and

modify your router configurations to match the characteristics of your network environment.

1.1 Logging In

1. Place the ADSL CD-ROM into your CD-ROM Drive. You will be prompted with aMain

Menu, followed by a prompt asking you to install Acrobat Reader for viewing the

manuals. Click OK.

On the Main Menu, select RUN DSL ROUTER COMMANDER.

(If you do not see the Main Menu displayed, you may run the menu.exe file from the ADSL CD-

ROM. You may also run DSL Router Commander by running DslCom.exe file from \Tools\DSL

Router Commander folder on the CD-ROM.)

2. You will be prompted for your log in password. Enter the password as stm (factory's

default) and click OK.

(The factory default for Router IP Address and

Password is 192.168.1.1 andpassword respectively*.

Replace them with your new Router IP Address

and Password if your System Administrator has

changed them. (* "stm" for old models))

Software Manual

1.2 Getting Ready Information Required

To configure your router, you need to have the following information ready from your

Internet Service Provider (ISP) and SystemAdministrator.

The following table shows the information required.

a) Check with your ISP:

i) The line protocol to use

ii) For RFC 2684 (RFC 1483) / RFC 2225 (RFC 1577):

The addresses for

WAN IP

WAN Subnet Mask

VPI and VCI values

Default WAN Gateway

DNS Relay

DNS Server (Primary)

DNS Server (Secondary)

For RFC 2516 / RFC 2364:

The PPP Authorization's

User Name

Password

Channel

Authentication

DNS Relay

DNS Server (Primary)

DNS Server (Secondary)

iii) The Framing Mode [not applicable for RFC 2225 (RFC 1577)]

You may also change your login password by selecting the SNMP tab from

the DSL Router Commander.

Software Manual

b) Check with your System Administrator:

i) The addresses for

LAN IP address

LAN Subnet Mask

Remote Gateway

ii) To enable or disable NAT

Network

Setup Overview

This section gives an overview of a typical network. The addresses indicated are used as

examples throughout the whole manual. You are to replace them with values given by your

System Administrator / ISP.

Chapter…2

PVC=0/35

WAN LAN PC X

PCA

PC B

ADSL Your Router

PCs with

Ethernet cards

WAN IP

202.166.29.154

LAN IP

192.168.1.1 (with NAT)

202.166.30.1 (without NAT)

WAN Gateway = 202.166.29.2

Hub/Switch

Software Manual

1. For configuration without NAT:

The range of the IP address used in this example is from 202.166.30.1 to

202.166.30.6 as restricted by subnet mask defined.

Network ID : 202.166.30.0 Broadcast ID : 202.166.30.7

The ISP will have to create a static route:

Network ID : 202.166.30.0 Subnet Mask :ff:ff:ff:f8

Next Hop Gateway : 202.166.29.154

2. For PPPoA and PPPoE:

The WAN IP and WAN Gateway will be dynamically assigned by the PPP

server. There is no need to specify the WAN IP nor to configure a default

route to the WAN Gateway.

2.1 Configuring the PCs

For PCA:

(with NAT) (without NAT)

IP = 192.168.1.11 = 202.166.30.2

Subnet mask = 255.255.255.0 = 255.255.255.248

Gateway = 192. 168.1.1 = 202.166.30.1

For PC B:

(with NAT) (without NAT)

IP = 192.168.1.12 = 202.166.30.3

Subnet mask = 255.255.255.0 = 255.255.255.248

Gateway = 192. 168.1.1 = 202.166.30.1

For PC X:

(with NAT) (without NAT)

IP = 192.168.1.23 = 202.166.30.6

Subnet mask = 255.255.255.0 = 255.255.255.248

Gateway = 192. 168.1.1 = 202.166.30.1

Chapter…3

Configuring your Router with

DSL Router Commander

1. For any settings that you are unsure, please check with your ISP or

System Administrator.

2. Based on your selected line configuration, fields that are not applicable

will be grayed out.

3. The values in the screen shots are based on the examples in Chapter 2

- Network Setup Overview. You are required to replace these values

with those given by your ISP or System Administrator !

Andere Handbücher für Michelangelo Gateway

Inhaltsverzeichnis

Andere Digicom Netzwerk-Router Handbücher

Digicom

Digicom VOICEGATE H.323 Bedienungsanleitung

Digicom

Digicom ADSL2+ Router Bedienungsanleitung

Digicom

Digicom Michelangelo SHDSL 8E4338 Bedienungsanleitung

Digicom

Digicom Michaelangelo Office Pro ADSL Router Bedienungsanleitung

Digicom

Digicom 3G SOHO HSDPA Betriebsanleitung

Digicom

Digicom Michaelangelo LANPro 8D5517 Bedienungsanleitung

Digicom

Digicom 3G Industrial Router VPN Pro Bedienungsanleitung

Digicom

Digicom Modem GSM Dual Band Modem Bedienungsanleitung

Digicom

Digicom 3G Router AM11 Bedienungsanleitung

Digicom

Digicom 8E4389 Bedienungsanleitung

Digicom

Digicom 3G Corporate DG 11 Bedienungsanleitung

Digicom

Digicom External GSM Modem Bedienungsanleitung

Digicom

Digicom 8E4589 Bedienungsanleitung

Digicom

Digicom ADSL Bedienungsanleitung

Digicom

Digicom 8E4087 Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Korenix

Korenix JetNet 5710G Series Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise