Dimplex Auvergne Log 2920 Bedienungsanleitung

Installation and

Operating Instructions

Focal Point Fire with Optiflame® Elite

incorporating 2kW Fan Heater

AUS/NZ Model: Auvergne Log Model 2920.

Issue 2. 5/01/04 08/18720/0

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Introduction This fire incorporates a flame effect which can be used without

heating, so that the comforting effect may be enjoyed at any

time of the year. The flame effect is provided by low wattage

motor and two 40 watt lamps. Using the flame effect on its

own, therefore, requires little electricity.

The controls are concealed behind the ash pan flap beneath

the firebox. A choice of 1 kW or 2kW thermostatically

controlled heat output is provided by the fan heater, which is

concealed beneath the unit.

This model is designed to be free standing and is normally

positioned against a wall.

Installation Instructions Ensure that all packing items are removed (read any warning

labels carefully).

Retain all packing until installation is complete.

Firebox

Door

Glass

viewing

screen

Controls

behind

here

Heat

outlet

Fig.2

Fig.1

Preparation for use WARNING: THIS APPLIANCE MUST BE EARTHED

This heater must be used on an AC ~ supply only and the

voltage marked on the heater must correspond to the supply

voltage.

Important Safety Advice:

When using electrical appliances, Basic precautions should

always be followed to reduce the risk of fire, electrical shock,

and injury to persons, including the following:

•If the appliance is damaged, check with the supplier before

installation and operation.

•Do not use outdoors.

•Do not use in the immediate surroundings of a bath, shower or

swimming pool.

•Do not locate the heater immediately below a fixed socket

outlet or connection box.

•Do not cover the heater. Do not place material or garments on

the heater, or obstruct the air circulation around the heater, for

instance by curtains of furniture, as this could cause

overheating and a fire risk.

•The appliance is not intended for use by young children or

infirm persons without supervision.

•Young children or infirm persons should be supervised to

ensure that they do not play with the appliance.

•Do not use this heater in series with a thermal control, a

program controller, a timer or any other device that switches

on the heat automatically, since a fire risk exists when the

heater is accidentally covered or displaced.

•Ensure that furniture, curtains or other combustible material

are positioned no closer than 1 metre from the heater.

•In the event of a fault unplug the heater.

•Unplug the heater when not required for long periods.

•Although this heater complies with safety standards, we do not

recommend its use on deep pile carpets or on long hair type of

rugs.

•The appliance must be positioned so that the plug is

accessible.

•If the supply cord is damaged it must be replaced by the

manufacturer or service agent or a similarly qualified person in

order to avoid a hazard.

Operation The controls are located behind the hinged ash pan flap (see

Fig.3).

A switch is in the ‘ON' position when the red indicator mark of

the switch is visible.

Connect the fire to your electricity supply.

Flame Effect

Press switch to the 'ON' position. The flame effect will now

operate.

Heating unit

You have a choice of low heat (1kW) or high heat (2kW) out

put.

Both settings have thermostat temperature control.

Open flap

for access to In order to operate the heating, switch must be in the 'ON'

controls Fig.3 Position (see Fig.4).

Low heat setting

With switch in the 'ON' position, press switch '’ to 'ON'.

The 1 kW heat output is controlled by the thermostat, which

should be set to maximum (see ‘Thermostat operation’ ).

High heat setting

With switches and '' in the 'ON' position, press switch ‘’

to 'ON'.

The 2kW heat output is controlled by the thermostat, which

should be set to maximum (see ‘Thermostat operation' ).

Thermostat operation

The thermostat controls the heat output according to the room

temperature. This ensures that the heater will not produce

heat unnecessarily when the room is warm.

Thermostat Fig.4

To set the temperature you require, turn the thermostat knob

fully clockwise 



to 'max' position. When the room is warm

enough, turn the knob back slowly until the thermostat just

clicks off. The heater will now maintain your selected

temperature.

Thermal safety cut-out

A thermal safety cut-out is incorporated in the heater to

prevent damage due to overheating.

This can happen if the heat outlet were restricted in any way.

The heater will switch on once the obstruction has been

removed and the heater has cooled. If the cut-out continues to

operate intermittently, the heater should be switched off and a

service agent contacted.

Maintenance WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

Lamp replacement

To gain access to the lamps, open the firebox door, remove

the two screws securing the fuel effect assembly (see Fig.5).

Slide out the fuel effect assembly. (See Fig. 5).

Carefully rotate the lamp anti-clockwise 



until it comes out

of its holder (see Fig. 6).

Replace the defective lamp with a 24OV, 40 watt E14 SES

clear candle lamp, rotating the lamp clockwise 



in the

holder until it is fully home. Do not over tighten.

Refit the fuel effect complete with fixing screws, ensuring that

the rear edge locates under the glass viewing screen, (see

page 1).

Cleaning

For general cleaning use a soft clean duster or, if necessary, a

damp cloth never use abrasive cleaners.

The fuel effect can be cleaned with a soft brush or vacuum

cleaner.

The glass viewing screen should be cleaned carefully with a

chamois leather. DO NOT use proprietary glass cleaners.

After sales service Your product is guaranteed for one year from the date of

purchase.

We undertake to exchange or repair free of charge within this

period, any part, with the exception of a lamp bulb, found to be

defective due to a manufacturing fault.

All enquiries for service should be directed in the first instance

to the retailer from whom your product was purchased.

Please do not initially return a faulty appliance or part of an

appliance to us as this may result in transit damage and/or

delay in providing service. Let us know your difficulty quoting

the model number and series letter of the appliance. We will

then take the appropriate action.

The product complies with the Australian/New Zealand Safety Standards AS/NZ S 335.2.30:2002 and also the European Standard

Electromagnetic Compatibility (EMC) EN 55 014-1:1993, EN 61000-3-2:1995, EN 61000-3-3:1995, EN 55 014-2:1997 which

cover the essential requirements of EEC Directive 89/336/EEC.

Fig.5

Fig.6

Inhaltsverzeichnis

Andere Dimplex Kamin im Innenbereich Handbücher

Dimplex

Dimplex DF2608 Bedienungsanleitung

Dimplex

Dimplex DFP6975O Bedienungsanleitung

Dimplex

Dimplex PRISM 34 Bedienungsanleitung

Dimplex

Dimplex ADG20BN Benutzerhandbuch

Dimplex

Dimplex BLF7451 Bedienungsanleitung

Dimplex

Dimplex CDS6599 - Celeste Bedienungsanleitung

Dimplex

Dimplex THWG XLF50 Bedienungsanleitung

Dimplex

Dimplex SF55992-AU Kurzanleitung

Dimplex

Dimplex CAS500 Bedienungsanleitung

Dimplex

Dimplex DCF7850 Bedienungsanleitung

Dimplex

Dimplex EWM-COPPER Bedienungsanleitung

Dimplex

Dimplex DNV20AB Bedienungsanleitung

Dimplex

Dimplex BF8000ST Bedienungsanleitung

Dimplex

Dimplex DF3033ST Bedienungsanleitung

Dimplex

Dimplex MULTIFIRE DF3015 Kurzanleitung

Dimplex

Dimplex ELECTRALOG DF203A Bedienungsanleitung

Dimplex

Dimplex EMP-075-W Bedienungsanleitung

Dimplex

Dimplex DF2426GB Bedienungsanleitung

Dimplex

Dimplex Pro Engine series Bedienungsanleitung

Dimplex

Dimplex VCX1525 Bedienungsanleitung

Dimplex

Dimplex Prism Series Bedienungsanleitung

Dimplex

Dimplex RBF30-AU Bedienungsanleitung

Dimplex

Dimplex DF2608-AU Bedienungsanleitung

Dimplex

Dimplex ALBANY ABN 15 Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch