Dimplex EF2570G Bedienungsanleitung
Owner’s Manual
Model
EF2570G
6909450159
7213510100R05
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install or use this replace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
2 www.dimplex.com
Table of Contents
Always use a qualied technician
or service agency to repair
this replace.
!NOTE: Procedures and
techniques that are considered
important enough to emphasize.
CAUTION: Procedures and
techniques which, if not carefully
followed, will result in damage to
the equipment.
WARNING: Procedures
and techniques which, if not
carefully followed, will expose
the user to the risk of re,
serious injury, or death.
Welcome & Congratulations ................3
IMPORTANT INSTRUCTIONS ...............4
Fireplace Installation ......................7
Operation ...............................9
Maintenance ...........................12
Warranty ...............................13
Replacement Parts .......................15
3
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an electric
replace from Dimplex, the world leader in electric replaces.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result in a
possible electric shock, re hazard and will void the warranty.
Please record your model and serial numbers below for future
reference: model and serial numbers can be found on the Model and
Serial Number Label of your replace.
Model Number
Serial Number
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product Under Manufacturer’s Warranty?
Contact us at: www.dimplex.com/customer_support
For Troubleshooting and Technical Support
OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EST
Please have your model number and product serial
number ready. (See above)
4 www.dimplex.com
When using electrical appliances,
basic precautions should always
be followed to reduce the risk of
fire, electric shock, and injury to
persons, including the following:
① Read all instructions before
using this appliance.
② The heater is hot when in use.
To avoid burns, do not let bare
skin touch hot surfaces. The trim
around the heater outlet becomes
hot during heater operation.
Keep combustible materials, such
as furniture, pillows, bedding,
papers, clothes, and curtains at
least 3 feet (0.9m) from the front
of the heater and away from the
side and rear.
③ Extreme caution is neces-
sary when any heater is used by
or near children or invalids and
whenever the unit is left operating
and unattended.
④ Always unplug the fireplace
when not in use.
⑤ Do not operate any heater with
a damaged cord or plug, or if the
heater has malfunctioned, or if it
has been dropped or damaged
in any manner. Contact technical
service at 1-888-346-7539.
⑥ Do not use outdoors.
⑦ The fireplace is not intended
IMPORTANT INSTRUCTIONS
for use in bathrooms, laundry ar-
eas and similar indoor locations.
Never locate heater where it may
fall into a bathtub or other water
container.
⑧ Do not run the cord under
carpeting. Do not cover cord with
throw rugs, runners or the like.
Arrange cord away from traf-
c area and where it will not be
tripped over.
⑨ To disconnect the unit, turn
the controls off, then remove the
plug from the outlet.
⑩Do not insert or allow foreign
objects to enter any ventilation
or exhaust opening as this may
cause an electric shock or re, or
damage to the heater.
⑪ To prevent a possible re, do
not block air intake or exhaust in
any manner.
⑫ All electrical heaters have
hot and arcing or sparking parts
inside. Do not use in areas where
gasoline, paint, or ammable
liquids are used or stored.
⑬ Do not modify the replace.
Use it only as described in this
manual. Any other use not rec-
ommended by the manufacturer
may cause re, electric shock or
injury to persons.
5
SAVE THESE INSTRUCTIONS
⑭ Always plug heaters directly
into a way outlet/receptacle.
Never use with an extension cord
or reloadable power tap (outlet/
power strip).
⑮ Do not burn wood or other
materials in the replace.
⑯ Always use a certied electri-
cian should new circuits or outlets
be required.
⑰ Always use properly grounded,
fused and polarized outlets.
⑱ Disconnect all power supply
before performing any cleaning,
maintenance or relocation of the
unit.
⑲ When transporting or stor-
ing the unit and cord, keep in a
dry place, free from excessive
vibration and store so as to avoid
damage.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of re, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: Remote control
contain a small batterys. Keep
away from children. If swallowed,
seek medical attention immedi-
ately.
WARNING: Do not install
remote control battery backwards,
charge, put in re or mix with
used or other battery types - may
explode or leak causing injury.
!NOTE: Changes or modica-
tions not expressly approved by
the party responsible for compli-
ance could void user's authority to
operate the equipment.
IMPORTANT INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
6 www.dimplex.com
IMPORTANT INSTRUCTIONS
!NOTE: This equipment has been
tested and found to comply with
the limits for Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installa-
tion. This equipment generates, uses
and can radiate radio frequency en-
ergy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and the receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is con-
nected.
• Consult the dealer or an expe-
rienced radio/TV technician for
help.
Operation is subject to the following
two conditions: (1) this device may
not cause interference and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
7
Fireplace Installation
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of re, electric shock or injury to
persons.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of re, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING:To reduce the risk
of re, do not store or use gaso-
line or other ammable vapors or
liquids in the vicinity of the heater.
Grounding Instructions
This product must be grounded.
If it should malfunction or break-
down, grounding provides a path
of least resistance for electric
current to reduce the risk of
electric shock. This product is
equipped with a cord having an
equipment-grounding conductor
and a grounding plug. The plug
must be plugged into an appropri-
ate outlet that is properly installed
and grounded in accordance with
all local codes and ordinances.
DANGER: Improper connec-
tion of the equipment-grounding
conductor can result in a risk
of electric shock. Check with a
qualied electrician or serviceman
if you are in doubt as to whether
the product is properly grounded.
Do not modify the plug provided
with the product – if it will not t
the outlet, have a proper outlet
installed by a qualied electrician.
This product is for use on a
nominal 120-volt circuit and has
a grounding plug that looks like
the plug in Figure 1. Make sure
that the product is connected to
an outlet having the same con-
guration as the plug. No adapter
should be used with this product.
!NOTE: A 15 Amp, 120 Volt cir-
cuit is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
Figure 1
8 www.dimplex.com
Fireplace Installation
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
cassette is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
Figure 2
THERMISTOR
SWITCHBOARD
FLAMES
M
M
$&1
17&703
'LVSOD\ 5HPRWH
)ODPH
$&102725)$1
.H\%RDUG
7IXVH
$&1
37()+
3
5/
&1
&1
5/
5/
&1&1
&1
&1
3 3
6PDOO)ODPH
&1
DISPLAY
REMOTE
MOTOR
HEATING ELEMENTS
Wiring
Media Installation
1. Remove the two knobs in the
top corners (Figure 2).
2. Remove the front glass as-
sembly from the unit.
!NOTE: There are two clips on
the bottom that hold the assembly
on the unit.
3. Carefully pour the media into
the media tray.
4. Reinstall the front glass as-
sembly, ensuring that the
clips are inserted into the
frame.
5. Install the replace into the
mantel (refer to mantel as-
sembly instructions).
9
Operation
WARNING: This electric rebox
must be properly installed before it
is used.
The manual controls for the unit are
located in the top right hand corner.
(Figure 3)
!NOTE: Press any button to
activate the On-Screen display
before making any changes.
A - Standby
Turns the unit On and Off. When
the unit is turned back On, the
system will recall its last heat set-
ting used.
!NOTE: When the unit is turned
OFF the media lighting will not
immediately go out. This is a
designed feature to represent the
embers of the re slowly fading
out.
Figure 3
A
!NOTE: Although the heater has
been turned off the fan may still
run to prevent over heating.
B - Light Control
Adjusts the lighting of the media.
Repeatedly pressing the light con-
trol button will cycle through the
ve different colors of ame.
When adjusting the colour of the
media lighting this icon will light
up with a blue light. The setting
will be displayed on the main
display with the ames in the cor-
responding colour: L1 - Blue,
L2 - Pink, L3 - White, L4 - Auto-
cycle, and L5 - Orange.
C - Thermostat
By pressing the , on the rebox,
or the and , on the remote,
the 7 different temperature set-
BCD
10 www.dimplex.com
ranging from 10 (minutes) to
6 (hours).
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by unplugging the
unit and waiting 5 minutes before
plugging the unit back in.
CAUTION: If you need to con-
tinuously reset the heater, unplug
the unit and call technical support
at 1-888-346-7539.
Operation
Figure 3
tings that the rebox can be oper-
ated at will be cycled through.
60°C (99°F) → 30°C (86°F) →
28°C (82°F) → 26°C (78°F) →
24°C (75°F) → 22°C (71°F) →
"OF" (for use without the heater)
Press and hold the down arrow
for 5 seconds to switch tempera-
ture readout from °C and °F.
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
To disable:
Press and holding the button
on the unit for 5 seconds will
disable the heater, indicated by
the temperature display ash-
ing.
To enable:
With the temperature displayed
(it will be ashing), press and
hold the button on the unit
for 5 seconds to reactivate the
heating controls.
D - Sleep Timer
This icon will light up with a
blue light when using the Timed
Shut-OFF function. A time will be
displayed on the main display
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Dimplex Kamin im Innenbereich Handbücher
Dimplex
Dimplex X1B Black Bedienungsanleitung
Dimplex
Dimplex EWMC-CC-SS Bedienungsanleitung
Dimplex
Dimplex Burgate BRG20 Bedienungsanleitung
Dimplex
Dimplex SCANDIC Bedienungsanleitung
Dimplex
Dimplex MULTIFIRE DF3015 Kurzanleitung
Dimplex
Dimplex Charlotte CRT20AB Bedienungsanleitung
Dimplex
Dimplex BLF50 Bedienungsanleitung
Dimplex
Dimplex Revillusion 20" Bedienungsanleitung
Dimplex
Dimplex DF2550-EU Bedienungsanleitung
Dimplex
Dimplex milano-ef Bedienungsanleitung
Dimplex
Dimplex DF2608-AU Bedienungsanleitung
Dimplex
Dimplex X-XLF5017-XD Bedienungsanleitung
Dimplex
Dimplex PF2325 Bedienungsanleitung
Dimplex
Dimplex GDS28L8-1924SK Bedienungsanleitung
Dimplex
Dimplex DFOP25 Bedienungsanleitung
Dimplex
Dimplex ELECTRALOG DF203A Bedienungsanleitung
Dimplex
Dimplex BF33STP Kurzanleitung
Dimplex
Dimplex EF3003 Bedienungsanleitung
Dimplex
Dimplex Vivente Bedienungsanleitung
Dimplex
Dimplex BAR20-AU Bedienungsanleitung
