Dimplex ELECTRALOG CFP3913 Bedienungsanleitung

Owner’s Manual

Model

CFP3913

7209260100R04

IMPORTANT SAFETY INFORMATION: Always read this manual rst

before attempting to install or use this replace. For your safety, always

comply with all warnings and safety instructions contained in this manual

to prevent personal injury or property damage.

2 www.dimplex.com

Table of Contents

Always use a qualied technician

or service agency to repair

this replace.

!NOTE: Procedures and

techniques that are

considered important

enough to emphasize.

CAUTION: Procedures and

techniques which, if not

carefully followed, will result

in damage to the equipment.

WARNING: Procedures

and techniques which, if not

carefully followed, will expose

the user to the risk of re,

serious injury, or death.

Welcome & Congratulations . . . . . . . . . . . . . . . . .3

IMPORTANT INSTRUCTIONS ...............4

Fireplace Installation .......................7

Operation ................................8

Maintenance .............................9

Warranty ...............................11

Replacement Parts ........................14

Welcome & Congratulations

Thank you and congratulations for choosing to purchase an electric

replace from Dimplex, the world leader in electric replaces.

Please carefully read and save these instructions.

CAUTION: Read all instructions and warnings carefully before

starting installation. Failure to follow these instructions may result

in a possible electric shock, re hazard and will void the warranty.

Please record your model and serial numbers below for future

reference: model and serial numbers can be found on the Model and

Serial Number Label of your replace.

NO NEED TO RETURN TO THE STORE

Questions with operation or assembly? Require Parts Information?

Product Under Manufacturer’s Warranty?

For Troubleshooting and Technical Support

OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)

Monday to Friday 8:00 a.m. to 4:30 p.m. EST

Please have your model number and product serial

number ready. (See above)

Model Number

Serial Number

4 www.dimplex.com

① Read all instructions before

using this appliance.

② The heater is hot when in use.

To avoid burns, do not let bare skin

touch hot surfaces. The trim around

the heater outlet becomes hot during

heater operation. Keep combustible

materials, such as furniture, pillows,

bedding, papers, clothes, and

curtains at least 3 feet (0.9 m) from

the front of the unit.

CAUTION: High temperature,

keep electrical cords, drapery, and

other furnishings at least three (3)

feet (0.9 m) from the front of the

heater and away from the side and

rear.

③ Extreme caution is necessary

when any heater is used by or near

children or invalids and whenever the

unit is left operating and unattended.

④ Always unplug the replace when

not in use.

⑤ Do not operate any unit with a

damaged cord or plug, or if the heater

has malfunctioned, or if the replace

has been dropped or damaged

in any manner. Return heater to

IMPORTANT INSTRUCTIONS

an authorized service facility for

examination, electrical or mechanical

adjustment, or repair.

⑥ Do not use outdoors.

⑦ The replace is not intended for

use in bathrooms, laundry areas and

similar indoor locations. Never locate

heater where it may fall into a bathtub

or other water container.

⑧Do not run the cord under

carpeting. Do not cover cord with

throw rugs, runners, or the like.

Arrange cord away from trafc area

and where it will not be tripped over.

⑨To disconnect the unit, turn the

controls off, then remove the plug

from the outlet.

⑩Do not insert or allow foreign

objects to enter any ventilation or

exhaust opening as this may cause

an electric shock or re, or damage to

the heater.

⑪ To prevent a possible re, do not

block air in take or exhaust in any

manner. Do not use on soft surfaces,

like a bed, where openings may

become blocked.

SAVE THESE INSTRUCTIONS

⑫ All electrical heaters have hot

and arching or sparking parts inside.

Do not use in areas where gasoline,

paint, or ammable liquids are used

or stored or where the unit will be

exposed to ammable vapors.

⑬Do not modify the replace. Use

it only as described in this manual.

Any other use not recommended by

the manufacturer may cause re,

electric shock or injury to persons.

⑭To reduce the risk of electric

shock, this appliance has a polarized

plug (one blade is wider than the

other). This plug will t in a polarized

outlet only one way. If the plug does

not t fully in the outlet, reverse the

plug. If it still does not t, contact

a qualied electrician to install the

proper outlet. Do not change the plug

in any way.

⑮ Avoid the use of an extension

cord. Extension cords may overheat

and cause a risk of re. If you must

use an extension cord, the cord must

be No. 14 AWG minimum size and

rated no less than 1875 Watts.

⑯ Do not burn wood or other

materials in the replace.

⑰Do not strike the clear door panel.

⑱ Always use a certied electrician

should new circuits or outlets be

required.

⑲ Always use properly grounded,

fused and polarized outlets.

⑳ Disconnect all power supply

before performing any cleaning,

maintenance or relocation of the unit.

㉑When transporting or storing the

unit and cord, keep in a dry place,

free from excessive vibration and

store so as to avoid damage.

IMPORTANT INSTRUCTIONS

6 www.dimplex.com

IMPORTANT INSTRUCTIONS

!NOTE: This equipment has

been tested and found to comply

with the limits for Class B digital

device, pursuant to part 15 of

the FCC Rules. These limits are

designed to provide reasonable

protection against harmful

interference in a residential

installation. This equipment

generates, uses and can radiate

radio frequency energy and, if not

installed and used in accordance

with the instructions, may cause

harmful interference to radio or

television reception, which can

be determined by turning the

equipment off and on, the user is

encouraged to try to correct the

interference by one or more of the

following measures:

Reorient or relocate the •

receiving antenna.

Increase the separation •

between the equipment and

the receiver.

Connect the equipment into •

an outlet on a circuit different

from that to which the

receiver is connected.

Consult the dealer or an•

experienced radio/TV

technician for help.

Operation is subject to the

following two conditions: (1)

this device may not cause

interference and (2) this device

must accept any interference,

including interference that may

cause undesired operation of the

device.

Fireplace Installation

!NOTE: A 15 Amp, 120 Volt

alternating current (VAC) circuit

is required. A dedicated circuit

is preferred but not essential in

all cases. A dedicated circuit will

be required if, after installation,

the circuit breaker trips or fuse

blows on a regular basis when the

heater is operating. Additional

appliances on the same circuit

may exceed the current rating of

the circuit breaker.

WARNING: Ensure the power

cord is not installed so that

it is pinched or against a

sharp edge and ensure that

the power cord is stored or

secured to avoid tripping or

snagging to reduce the risk of

re, electric shock or injury to

persons.

WARNING:Construction and

electrical outlet wiring must

comply with local building

codes and other applicable

regulations to reduce the risk

of re, electric shock and injury

to persons.

WARNING:Do not attempt

to wire your own new outlets

or circuits. To reduce

the risk of re, electric shock

or injury to persons, always

use a licensed electrician.

Make sure the unit’s Main 1.

ON/OFF Switch is switched

OFF (refer to operating

instruction section).

Plug the unit into a 152.

Amp/120 VAC outlet. If the

cord does not reach, you may

use an extension cord rated

for a minimum of 1875 Watts.

8 www.dimplex.com

Operation

Three switches provide a choice

of heat settings. A switch is in the

ON position when the side with

the markings on (i.e. I, II, or II) is

pushed in. (Figure 1)

Switch 1

(I) Manual mode: Controls the

electricity supply to the heater

and ame manually.

(II)Remote mode: Allows the

control of electricity supply to

the heater and ame through

the use of the supplied remote

control.

!NOTE: This switch must

be in either (I) or (II) to operate

with or without heat.

Switch 2 (I) Provides 715 Watt

heat output.

Switch 3 (II)Provides 1430 Watt

heat output with Switch 2.

Remote Operation

The replace is supplied with an

integral ON/OFF remote control.

!NOTE: Ensure that the

replace ON/OFF Switch is set to

the remote control setting (I.E.. II).

To operate: push ON button

to turn replace on; push OFF

button to turn replace off.

!NOTE: Remote control

operates main power supply.

Heat must still be controlled by

switches on replace.

Resetting The Tempera-

ture Cutoff Switch

Should the heater overheat, an

automatic cut out will turn the

heater off and it will not come

back on without being reset. It

can be reset by switching the

Main ON/OFF Switch to OFF and

waiting ve (5) minutes before

switching the unit back on.

CAUTION: If you need to

continuously reset the heater,

unplug the unit and call customer

service at 1-888-346-7539.

Figure 1

3 2 1

Maintenance

WARNING: Always

disconnect from the power

supply before attempting any

maintenance.

Bulb Replacement

The bulbs are located behind the

back panel.

To gain access to the bulbs:

Remove the silver screw that 1.

secures the access panel to

the rebox as indicated in

Figure 2.

Remove and slide out panel.2.

Remove the defective lamp 3.

by unscrewing it as shown in

Figure 3.

Replace with a 60 Watt 4.

E12 clear chandelier or

candelabra. Take care not to

over-tighten the bulb.

Ret the access panel 5.

and secure with the screw

removed in step 1.

!NOTE: To remove the rebox

insert prior to repair, remove the

ve (5) black screws at the back

of the rebox as shown in Figure

2 and slide it out to the front.

Helpful Hints

It is a good idea to replace all

light bulbs at one time if they are

close to the end of their rated life.

Group replacement will reduce

the number of times you need

to open the unit to replace light

bulbs.

Cleaning

WARNING: Always

disconnect from the power

supply before cleaning the

replace.

For general cleaning use a

soft clean duster – never use

abrasive cleaners. The glass

viewing screen should be cleaned

carefully with a soft cloth. DO

NOT use glass cleaners.

To remove any accumulation

of dust or uff the soft brush

attachment of a vacuum cleaner

should occasionally be used to

clean the outlet grill of the fan

heater.

10 www.dimplex.com

Maintenance

Figure 2

Access

Panel

Screw

Firebox

Mounting

Screws (2)

Firebox

Mounting

Screws (3)

Figure 3

Bulbs

Andere Handbücher für ELECTRALOG CFP3913

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dimplex Kamin im Innenbereich Handbücher

Dimplex

Dimplex DCF7850 Bedienungsanleitung

Dimplex

Dimplex MULTIFIRE DF3215 Bedienungsanleitung

Dimplex

Dimplex Optimyst Cassette 500 Project Bedienungsanleitung

Dimplex

Dimplex BF8000ST Bedienungsanleitung

Dimplex

Dimplex ELECTRALOG DF203A Bedienungsanleitung

Dimplex

Dimplex CDFI1000P Bedienungsanleitung

Dimplex

Dimplex Charlotte CRT20BR Bedienungsanleitung

Dimplex

Dimplex Dimplex VALENCIA Bedienungsanleitung

Dimplex

Dimplex XHD23L-INT Bedienungsanleitung

Dimplex

Dimplex MULTIFIRE DF3015 Bedienungsanleitung

Dimplex

Dimplex SNG20 Bedienungsanleitung

Dimplex

Dimplex Cavendish CSH20 Bedienungsanleitung

Dimplex

Dimplex CFP49449BW Bedienungsanleitung

Dimplex

Dimplex Pro Engine series Bedienungsanleitung

Dimplex

Dimplex CDN20-AU Bedienungsanleitung

Dimplex

Dimplex DFI2309 Bedienungsanleitung

Dimplex

Dimplex DF2000 Bedienungsanleitung

Dimplex

Dimplex RLG20 Bedienungsanleitung

Dimplex

Dimplex DF2010-EU-E Bedienungsanleitung

Dimplex

Dimplex DF2608 Bedienungsanleitung

Dimplex

Dimplex DF2690 Bedienungsanleitung

Dimplex

Dimplex X-XLF5017-XD Bedienungsanleitung

Dimplex

Dimplex WINSLOW SWM3520 Bedienungsanleitung

Dimplex

Dimplex BF392SD Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung