Dimplex SAHARA FIREPLACE 6903950000 Bedienungsanleitung

7208570100R04

PRACTICAL USER’S GUIDE

FOR THE SAHARA FIREPLACE

Model 6903950000 series

CAT NUMBER:

EWF-SS

Quality checked by:

Valued Customer,

We are pleased that you have chosen to purchase an electric

fireplace manufactured by Dimplex North America Limited.

CONTENTS

PAGE 1 Important Instructions

PAGE 4 Fireplace Installation

PAGE 8 Operation

PAGE 10 Remote Operation

PAGE 11 Maintenance

PAGE 13 Warranty

QUICK REFERENCE GUIDE FOR THE SAHARA

FIREPLACE

1. Before using the Sahara fireplace verify:

·Are the circuit breakers for the unit

on?

·Are the light bulbs loose? (to

check, follow the instructions for

replacing the light bulbs under the

maintenance section of this

manual)

2. The heater may emit a slight, harmless

odor when first used. This odor is a

normal condition caused by the initial

heating of internal heater parts.

3. The information regarding the model of

your unit can be found on the carton

label or the rating plate. The rating plate

is located on the side of the unit

underneath the outer frame. The carton

label is attached to the front surface of

the carton.

4. If you have any questions or concerns

regarding the operation of your fireplace,

contact Dimplex customer service at 1-

888-DIMPLEX (1-888-346-7539).

Rating Label Serial Number Label Serial NumberLabel

Rating

Label

IMPORTANT INSTRUCTIONS

RETAIN THIS USER’S GUIDE FOR FUTURE

REFERENCE

Whenusingelectricalappliances,basicprecautions

shouldalwaysbefollowedtoreducetheriskoffire,

electricshock,andinjurytopersons.

1. ReadallinstructionsbeforeusingtheSahara

fireplace.

2. Theheaterishotwheninuse. Toavoid

burns,donotletbareskintouch hot

surfaces. Thetrim around theheater outlet

becomeshotduringheateroperation. Keep

combustiblematerials, suchasfurniture,

pillows,bedding, papers, clothes, and

curtainsat least 3 feet (0.9m)fromthefront of

theunit.

3. Extremecaution isnecessarywhen any

heateris used by or near children or invalids

andwhenever the unitisleft operating and

unattended.

4. Alwaysunplug theSaharafireplace whennot

inuse.

5. Do not operate with a damaged cord or plug,

orif the heater has malfunctioned,orif the

Sahara fireplace has been dropped or

damagedin any manner. Returnheater to

authorizedservice facility forexamination,

electricalor mechanical adjustment, orrepair.

6. Donot use outdoors.

7. TheSahara fireplace is not intended for use

inbathrooms, laundry areas andsimilar

indoorlocations. Never locate heater where

itmay fall into a bathtuborother water

container.

8. Donot run the cord under carpeting. Do not

covercord withthrowrugs, runners,orthe

like. Arrangecordawayfromtraffic area and

whereit will not be tripped over.

9. Todisconnect theunit,turn thecontrolsoff,

thenremove theplug fromtheoutlet.

10.Donot insert or allow foreign objects to enter

anyventilation orexhaustopening as this

may cause an electric shock or fire, or damage

to the heater.

11. To prevent a possible fire, do not block air intake

or exhaust in any manner. Do not use on soft

surfaces, like a bed, where openings may

become blocked.

12. All electrical heaters have hot and arching or

sparking parts inside. Do not use in areas

where gasoline, paint, or flammable liquids are

used or stored or where the unit will be exposed

to flammable vapors.

13. Do not modify the Sahara fireplace. Use it only

as described in this manual. Any other use not

recommended by the manufacturer may cause

fire, electric shock or injury to persons.

14. To reduce the risk of electric shock, this

appliance must be grounded.

Avoid the use of an extension cord. Extension

cords may overheat and cause a risk of fire. If

you must use an extension cord, the cord must

be No. 16 AWG minimum size and rated no

less than 1875 watts.

15. Do not burn wood or other materials in the

Sahara fireplace.

16. Do not strike the glass front.

17. Always use a certified electrician should new

circuits or outlets be required.

18. Always use properly grounded, fused and

polarized outlets.

19. Disconnect all power supply before performing

any cleaning, maintenance or relocation of the

unit.

20. When transporting or storing the unit and cord,

keep in a dry place, free from excessive

vibration and store so as to avoid damage

21 If the power supply cord is damaged, it must be

replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a

hazard

22 The heater must not be located immediately

below a socket-outlet

NOTE: Proceduresand techniques that are considered

importantenough to emphasize.

CAUTION: Proceduresand techniques which, if not carefully

followed, will result in damage to the equipment.

WARNING: Procedures and techniques which, if not

carefully followed, will expose the user to the risk of fire,

serious injury, illness or death.

SAVE THESE INSTRUCTIONS

NOTE

A15amp, 120 volt circuit is required. Adedicated circuit is

preferred but not essential in all cases. Adedicated circuit

will be required if, after installation, the circuit breaker trips or

the fuse blows on a regular basis when the heater is

operating. Additional appliances on the same circuit may

exceed the current rating of the circuit breaker.

WARNING

Ensurethepowercordisnotinstalledsothatitis

pinchedor against a sharp edge and ensure that the

power cord is stored or secured to avoid tripping or

snaggingto reduce the risk of fire, electric shock or

injurytopersons.

Constructionand electrical outletwiringmust comply

withlocalbuilding codes and other applicable

regulationsto reduce the risk of fire, electric shock

andinjury topersons.

Donot attempt to wireyourown new outlets or

circuits. To reduce the riskof fire, electric shock or

injuryto persons, always usealicensed electrician.

WARNING

The supplied mounting bracket is designed for

use with Dimplex wall mounted fireplaces only.

Improper use, or use for purposes other than

intended, may cause damage or injury.

SAHARAFIREPLACE

INSTALLATION

WARNING

Failure to install the Sahara fireplace as instructed below may

result in damage to the equipment and or may expose the

user to the risk of fire, serious injury, illness or death.

WARNING

TheSahara fireplace requires thewall mounting bracket

screws to be installed into a minimum of two wall studs.

(FIGURE1)

1. Selectan appropriate location to mount the

uniton a wall,abovean electrical outlet.

Thebottom of the unitmustbe a minimum

of12" above the floor (mounting bracket

34"above the floor). Access to the

electricaloutlet must bemaintained.Ensure

theinstallation meets thenationaland state/

provincialelectrical codes.

NOTE:It is recommended thatthebottom of the

unitnot be mountedhigherthan 40" fromthe

ground(mounting bracket nohigher than 62").

WARNING

Ensure the front of the installed unit will be at least 3

feet (0.9m) from combustible materials, such as

furniture, pillows, bedding, papers, clothes, and

curtains.

2. Thewall-mounting bracketmust bemounted

toat least two wall studs. Studsshould be

accessedthrough two wall-bracketholesin

oneof the following combinations: A&F,

B&D, or C&E (FIGURE 2).

NOTE: Wallanchors mustbeinstalledin the

appropriatewall locations to fasten the wall bracket

throughthe remaining holes (Figure 4). For

example,if you plan to secure thebracketto studs

throughholesA&F,install anchors centeredon

holes B, C, D, and E.

3. Holdthe wall-mountingbracketon the walland

markthe location of ONEofthe mounting holes.

4. Placethe bubble level ontothetop of the wall-

mountingbracket.

Figure1

Figure2

5. Adjustthe wall-mounting bracketso the bubble

onthe level is centered betweenthetwo black

lines.

6. Mark5 other mounting screwlocations,on the

wall,ensuring thatthe wall bracketstays level.

7. Installthe suppliedwallanchors on themarked

locationsbyplacing a #2 phillips screwdriver

intothe recess of the anchor. Pressthe anchor

intothewallinthedesiredmarkedposition

whileturning theanchorclockwise until itis flush

withthewall

9. Insertthewallanchorscrewsthrough thewall

bracketand thread into thewallanchors.

Tightenthe screw.(FIGURE 4)

10.Installthe remainingscrewsthrough thebracket

andinto the wall studs as required.

Note: At least two of the mounting screws

must be installed into a wall stud.

11. Remove glass assembly (Figure 5).

Figure4

Wall Anchor

Screw

Wall Bracket

Figure5

12. Mount the unit on the wall as shown (Figure 6).

Figure6

Wall Bracket Supports

Wall Bracket

15.

13. Fix the unit in place by inserting 2 screws through 2 of

the 4 available back panel holes, and into the wall studs. If

studs are unattainable please use wall anchors. (Figure 7).

Figure7

17.Replace glass assembly.Panel Mounting Holes

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dimplex Kamin im Innenbereich Handbücher

Dimplex

Dimplex 34" Prism Bedienungsanleitung

Dimplex

Dimplex BF36 Series Bedienungsanleitung

Dimplex

Dimplex BFSL33 Bedienungsanleitung

Dimplex

Dimplex DF2550-EU Bedienungsanleitung

Dimplex

Dimplex 3 Step E Bedienungsanleitung

Dimplex

Dimplex EWMC-CC-SS Bedienungsanleitung

Dimplex

Dimplex DWF1203B Bedienungsanleitung

Dimplex

Dimplex BEETHOVEN Bedienungsanleitung

Dimplex

Dimplex BURLINGTON BLN12 Bedienungsanleitung

Dimplex

Dimplex BFL50-EU Bedienungsanleitung

Dimplex

Dimplex DWF1203 Bedienungsanleitung

Dimplex

Dimplex RLG20BR Bedienungsanleitung

Dimplex

Dimplex DF2608-EU Bedienungsanleitung

Dimplex

Dimplex SPF1808L-IR Bedienungsanleitung

Dimplex

Dimplex OPTIMYST RTOPCS20 Bedienungsanleitung

Dimplex

Dimplex DS5629 Bedienungsanleitung

Dimplex

Dimplex MULTIFIRE DF3215 Bedienungsanleitung

Dimplex

Dimplex OptiFlame Cheriton Deluxe Bedienungsanleitung

Dimplex

Dimplex DF3003 Bedienungsanleitung

Dimplex

Dimplex 3-STEP Optimyst Bedienungsanleitung

Dimplex

Dimplex DF1136L Bedienungsanleitung

Dimplex

Dimplex DWOP20R Bedienungsanleitung

Dimplex

Dimplex BRENTA BNT20 Bedienungsanleitung

Dimplex

Dimplex FABER ALBANY ECO ABN15 ECO Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch