Dimplex EOS-2006 Kurzanleitung

PARTS AND SERVICE MANUAL

FOR THE

ELECTRIC PATIO STOVE

Model EOS2006

TABLE OF CONTENTS

OPERATION PAGE 2

PARTS DRAWING PAGE 4

PARTS LIST PAGE 5

WIRING DIAGRAM PAGE 6

LIGHT BULB REPLACEMENT PAGE 7

FLAME ROD AND MOTOR REPLACEMENT PAGE 8

CIRCUIT BOARD REPLACEMENT PAGE 9

SWITCH REPLACEMENT PAGE 10

POWER CORD REPLACEMENT PAGE 11

EOS2006

OPERATION

To access the controls go to the back of the Stove.

A. MAIN ON/OFF SWITCH

The on/off switch supplies power to all unit functions (flame/towel warmer)

B. TOWEL WARMER ON/OFF SWITCH

The towel warmer on/off switch supplies power to the towel warmer. The main on/off

switch must be on to activate towel warmer switch.

NOTE: When the Towel Warmer is switched ON, the warmer will operate. The warmer will

not operate if the cooler insert is still in place within the unit.

BEVERAGE COOLER

This stove has a convenient hidden beverage cooler located under the flip top lid. To use the

cooler ensure that cooler is inserted. Ice may be used. Place beverages in cooler insert and

surround with ice.

TOWEL WARMER

This unit has a convenient towel warmer built in. To operate the towel warmer remove cooler

insert, activate towel warmer switch (fig.2), and place dry towels in towel warmer

compartment. THIS IS NOT A TOWEL DRYER, DO NOT PLACE DAMP OR WET

TOWELS IN COMPARTMENT

EOS2006

REPLACEMENT PARTS

OUTDOOR ELECTRIC STOVE

CATALOGUE NO. EOS2006

PART NO. 6903510159

REPLACEMENT PART

1. MOTOR, ASSEMBLY 2000220100RP

2. CIRCUIT BOARD 3000570100RP

3. MIRROR 5900820100RP

4. FLAME ROD 5900340100RP

5. BUSHING 8500000400RP

6. LOGSET 0438270100RP

7. POWER CORD 4100170200RP

8. SWITCH, SPLASHPROOF 2800130200RP

9. TERMINAL BLOCK 4000070100RP

10. CAPACITOR 3200030100RP

11. COOLER ASSEMBLY 0478060100RP

WIRING DIAGRAM

EOS2006

LIGHT BULB REPLACEMENT

Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental

burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the

clarity and detail of the log exterior disappears. There are three bulbs under the log set

which generate the flames and embers.

HELPFUL HINTS

It is a good idea to replace all light bulbs at one time if they are close to the end of their rated

life. Group replacement will reduce the number of times you need to open the unit to replace

light bulbs.

LIGHT BULB REPLACEMENT

1. Open door by pulling the handles.

2. Remove the screw from the logset located in the center of the emberbed and remove

the logset from the unit.

3. Locate and examine the bulbs to determine which bulb(s) required replacement.

4. Locate and remove the light bulb(s).

5. Insert new bulb(s).

6. Install the logset into the unit, pushing firmly against the glass. Replace the logset

retaining screw into the ember bed.

7. Close the doors.

LIGHT BULB REQUIREMENTS

Quantity of 3 clear chandelier or candelabra bulbs with an E-12 (small) socket base,

60 watt rating.

EOS2006

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating

element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

FLAME ROD AND MOTOR REPLACEMENT

1. Open door by pulling the handles.

2. Remove the screw from the logset located in the center of the emberbed and remove the

logset from the unit.

1. While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket

screws. Carefully remove the mirror and store in a safe place to prevent damage.

2. Remove the 3 screws securing rear reflector to the unit.

3. Remove the reflector rod from the flame motor by pulling the end of the rod to the left and

carefully remove flame rod from rubber sleeve.

4. Remove the 2 screws securing the flame motor to the flame motor bracket

5. Disconnect motor wiring connections from circuit board.

6. Discard the old motor.

7. Reassemble in the reverse order as above.

EOS2006

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating

element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

CIRCUIT BOARD REPLACEMENT

1. Open door by pulling the handles.

2. Remove the screw from the logset located in the center of the emberbed and remove the

logset from the unit

3. While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket

screws. Carefully remove the mirror and store in a safe place to prevent damage.

4. Remove the 3 screws securing rear reflector to the unit.

5. Locate the circuit board on the underside of the rear reflector bracket.

6. Remove wiring connections from circuit board noting their original locations.

7. From the underside of the circuit board, break off the 4 mounting studs by grasping with

pliers and twisting on the protruding part of the stud, push the remainder of the studs out

through the top panel.

8. NOTE: New mounting studs are supplied with the replacement circuit board

9. Reassemble in the reverse order as above.

Andere Handbücher für EOS-2006

Inhaltsverzeichnis

Andere Dimplex Herd Handbücher

Dimplex

Dimplex Bellingham 5kW BLM5SE Bedienungsanleitung

Dimplex

Dimplex Club Courchevel CLB20E Bedienungsanleitung

Dimplex

Dimplex 143041WT Bedienungsanleitung

Dimplex

Dimplex ELECTRALOG CS1205 Bedienungsanleitung

Dimplex

Dimplex EOS-2006 Bedienungsanleitung

Dimplex

Dimplex ELECTRIC PATIO STOVE Bedienungsanleitung

Dimplex

Dimplex DS3311 Bedienungsanleitung

Dimplex

Dimplex STOCKBRIDGE SKG20BL Bedienungsanleitung

Dimplex

Dimplex Opti-myst Evandale Slate EVN20SL Bedienungsanleitung

Dimplex

Dimplex CDS8515 Bedienungsanleitung

Dimplex

Dimplex Tango Bedienungsanleitung

Dimplex

Dimplex Purifire Electric Stove Bedienungsanleitung

Dimplex

Dimplex Ritz Bedienungsanleitung

Dimplex

Dimplex DS2205 Bedienungsanleitung

Dimplex

Dimplex CELESTE Bedienungsanleitung

Dimplex

Dimplex DCS19W Bedienungsanleitung

Dimplex

Dimplex ELECTRALOG CS1205 Bedienungsanleitung

Dimplex

Dimplex ELECTRIC STOVE Bedienungsanleitung

Dimplex

Dimplex Brayford BFD20 Bedienungsanleitung

Dimplex

Dimplex LEE Bedienungsanleitung

Dimplex

Dimplex Langbrook LBK5SE Bedienungsanleitung

Dimplex

Dimplex DCS19W Bedienungsanleitung

Dimplex

Dimplex DS7420 Bedienungsanleitung

Dimplex

Dimplex BAR20-AU Bedienungsanleitung

Beliebte Herd Handbücher anderer Marken

Arada

Arada Cassette Stove Bedienungsanleitung

Parmco

Parmco FS 600 Bedienungsanleitung

MCZ

MCZ SUITE AIR 10 M2 Bedienungsanleitung

HearthStone

HearthStone Stowe DV 8321 Fehlerbehebungshandbuch

Cattara

Cattara FAMILY Bedienungsanleitung

Stanley

Stanley Argon F500 OVAL Bedienungsanleitung

Avalon

Avalon B-VENT Bedienungsanleitung

Nordpeis

Nordpeis Vega Bedienungsanleitung

Exquisit

Exquisit EKC601-5 Bedienungsanleitung

Stanley

Stanley Oisin Oil MK II Betriebsanleitung

Thermocet

Thermocet Brookfield S/CC Bedienungsanleitung

HASE

HASE delhi Bedienungsanleitung

Vermont Castings

Vermont Castings Intrepid 2 Bedienungsanleitung

Italiana Camini

Italiana Camini CLASSICA Kurzanleitung

Avalon

Avalon Vashon Avanti DVS FS Bedienungsanleitung

Spartherm

Spartherm ambiente a1 Bedienungsanleitung

Warmlite

Warmlite WL46040 Bedienungsanleitung

Regency

Regency Ultimate U39E Series Kurzanleitung