3
NOTE: Additional hard wire installation
may be required by a licensed
electrician. User may choose to utilize
an outdoor rated power strip.
1. Remove one of the bottom covers to pass
cables for TV and fan through. Insert rubber
gasket into hole.
NOTE: Wires for fan come attached to fan.
2. Remove bracket from the TV enclosure by
unscrewing pre-attached bolts.
ATTACH BRACKET TO TV
3. Mount the the bracket arms to the
back of the TV, using the M4/M6
screws.
4. Mount bracket to the arms by
tightening all screws to attach.
5. To hold unit door up, insert
metal rod into hole. This is located
along the hydraulic rods.
MOUNT ENCLOSURE TO WALL
6. Drill four 8mm holes into desired
wall, being careful to measure for
appropriate dimensions and level
installation.
7. Put expansion screw caps into
the holes.
8. Two people should hold the unit against
the wall, while a third inserts and tightens
expansion screws.
NOTE: Enclosure door may need to be held
open while installing.
