Dixon BLOUNT 3O4 Gebrauchsanweisung

TECHNICAL DATA BROCHURE

Mode1 3O4

IMPORTANT -READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS

SEAT ADJUSTMENT

1. Pull or lift body retention latch (P/N 3934)

from transaxle backing plate, raise and push

body and seat assembly forward.

2. Loosen four seat bolts (P/N 3006) and slide

seat forward or backward to desired position.

3. Re-tighten bolts. DO NOT operate mower

without seat retention bolts properly

tightened.

4. Close upper body and push retention

latch (P/N 3934) over transaxle backing plate.

BODY REMOVAL

'-•'i " £

1. The 304 has a (2) piece polyethelene body. The upper body can be folded

forward to expose the transaxle. In some cases, it may be necessary to

remove the upper body to service the transaxle.

2. To remove upper body, remove two bolts (P/N 3080) from the front

of upper body hinge located on the brake shaft (P/N 9283). Disconnect seat

switch (P/N 4761) at plug-in.

3. Reverse above procedure to reinstall.

ADJUSTMENT OF MOWER DECK DRIVE BELT

1. The mower deck drive belt is tensioned by a spring loaded engagement idler

quadrant.

2. This system is designed to maintain the proper belt tension at all times.

3. Belt tension can be adjusted by moving the engaging rod (P/N 7013) into the

outside hole of engagement handle (P/N 7020).

4. After, belt tension is adjusted, check to assure that the mower blade will not

turn freely when the engaging rod is in the "OFF" position.

5. If the mower blade turns freely, adjust the blade by loosening nut (P/N 3205)

at end of the brake rod (P/N 2988).

6. After adjustment is achieved, perform the safety checks listed below.

Page 1 of 7

IXON INDUSTRIES, INC

A BLOUNT COMPANY

AIRPORT INDUSTRIAL PARK

PO BOX 1569

COFFEYVILLE KS 67337 O945

316 251 2OOO

FAX 316 251 4117

REMOVING THE MOWER BLADE

Secure blade (P/N 2483) from turning. Remove blade bolt from center

(P/N 3268) and blade washer (P/N 6260), then blade (P/N 2483). To reinstall,

reverse above procedure.

WARNING: Sharp edges on blade can cause injury!

Caution should be exercised when service is required on blade.

REMOVING MOWER DECK

1. Loosen the belt keeper (P/N 7026 & 7027), located under the engine, by

loosing two rear engine mounting bolt's, allowing the deck drive belt to cone

free of the rear pulley.

2. Disconnect the wiring loom at the deck safety switch (P/N 4242).

3. Remove the two clevis pins (P/N 3072) from the two rear L-rods (P/N 1355) and

slide from slots.

4. Remove clevis pins (P/N 3072) L-rod attached to lift handle and slide from slot.

5. Remove clevis pin (P/N 3072) from front deck hanger shaft (P/N 1332), located at

from of mower deck on slide plates welded at battery box and remove.

6. Lift front of mower chassis and roll free of the deck.

7. To install, reverse the above procedure.

MOWER BLADE OPERATION

To engage the mower blades, turn lever on floor slowly to the "ON" position. To

disengage mower blades, turn lever slowly to the "OFF" position.

"IMPORTANT" -PERFORM SAFETY CHECKS AFTER MAKING ANY REPAIRS OR ADJUSTMENTS

1. After reassembly, while seated on mower, attempt to start engine with sower

deck engaged. Engine should not start. If engine does start, return the mower to

an Authorized Dixon Dealer for adjustment or repair.

2. Disengage mower deck and start engine. With the operator in the normal

seated position, engage mower deck and remove weight from seat. The engine should

stop. If the engine does not stop when operator rises from seat, return the mower

to an Authorized Dixon Dealer for adjustment or repair.

3. Engage, then disengage, mower blade in each cutting height. Insure that blade

disengages and comes to a stop within (5) seconds in each height position.

If blade does not disengage properly, contact your Authorized Dixon Dealer.

PARKING BRAKE ADJUSTMENT

1. Raise upper body to the open position.

2. Tighten nut on brake rod (P/N 2533) located in front of the transaxle on

each side, just enough to prevent brake from slipping when engaged. :

CAUTION: Over tightening may cause premature wear on the brake band (P/N

5085).

Page 2 of 7

Revised 1/92

(P/N 8112)

1304 Transaxle Assembly__________I

304 Body Assembly

____

Inhaltsverzeichnis

Andere Dixon Rasenmäher Handbücher

Dixon

Dixon ZTR 501 Bedienungsanleitung

Dixon

Dixon ZTR SPEEDZTR Bedienungsanleitung

Dixon

Dixon Mower Bedienungsanleitung

Dixon

Dixon SpeedZTR 30 ZTR Bedienungs- und Wartungshandbuch

Dixon

Dixon 12881-106 Bedienungs- und Wartungshandbuch

Dixon

Dixon D25KH48 Bedienungsanleitung

Dixon

Dixon ZTR 5000 Series Bedienungsanleitung

Dixon

Dixon RAM Series Bedienungsanleitung

Dixon

Dixon D26KH54 Betriebsanleitung

Dixon

Dixon SPEEDZTR 44/965981001 Bedienungsanleitung

Dixon

Dixon D2548YT Bedienungsanleitung

Dixon

Dixon KODIAK Bedienungs- und Wartungshandbuch

Dixon

Dixon ZTR421, ZTR422, ZTR423 Bedienungsanleitung

Dixon

Dixon SpeedZTR 46 CE Bedienungsanleitung

Dixon

Dixon ZTR 700 Series Bedienungsanleitung

Dixon

Dixon ZEETER 422 & 424 Bedienungsanleitung

Dixon

Dixon ZTR 3000 Series Bedienungsanleitung

Dixon

Dixon 2700 Bedienungsanleitung

Dixon

Dixon ZTR 3000 Series Bedienungsanleitung

Dixon

Dixon Zeeter Zero-Turn Riding Mower Leitfaden

Dixon

Dixon ZTR 301 Bedienungsanleitung

Dixon

Dixon ZTR Ram Ultra 61 Bedienungsanleitung

Dixon

Dixon SPDZTR 42 Bedienungsanleitung

Dixon

Dixon Ram Ultra 50 Bedienungsanleitung

Beliebte Rasenmäher Handbücher anderer Marken

RHINO

RHINO 1958 Bedienungsanleitung

Wolf Garten

Wolf Garten Compact plus 40 B Bedienungsanleitung

Cub Cadet

Cub Cadet LTX 1045 Bedienungsanleitung

Craftsman

Craftsman 917.378461 Bedienungsanleitung

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Bedienungsanleitung

Challenge

Challenge CH18V2 Betriebsanleitung

TALEN TOOLS

TALEN TOOLS AVR HGM30 Bedienungsanleitung

DEWEZE

DEWEZE ATM-725 Bedienungsanleitung

Weed Eater

Weed Eater 180083 Bedienungsanleitung

Husqvarna

Husqvarna Poulan Pro PP185A42 Bedienungsanleitung

Better Outdoor Products

Better Outdoor Products Quick Series Bedienungsanleitung

Cub Cadet

Cub Cadet 23HP Z-Force 60 Betriebsanleitung

MTD

MTD 795, 792, 791, 790 Bedienungsanleitung

Toro

Toro Groundsmaster 3505-D Bedienungsanleitung

Dennis

Dennis FT 610 Bedienungsanleitung

AIRFORCE

AIRFORCE F-15 Gen 3 Bedienungsanleitung

MTD

MTD 126-220-000 Bedienungsanleitung

Toro

Toro 74806 Bedienungsanleitung