E-5 E-6
- WHEN OPENING THE CD-DOOR, ALWAYS ENSURE THE DISC IS NOT IN MOTION (NOT
SPINNING) WHEN YOU OPEN THE CD-DOOR. ALWAYS PRESS "STOP" KEY TO
STOP THE DISC SPINNING FIRST.
- PLACE A CD INTO THE COMPARTMENT WITH THE LABEL-SIDE (PRINTED SIDE OF
DISC) FACING UPWARDS. PRESS DOWN IN THE CENTER PART OF DISC UNTIL THE
DISC "LOCKS" ONTO THE CENTER SPINDLE.
- WHEN THE CD HAS BEEN PLACED ONTO THE CENTER SPINDLE, GENTLY LOWER
THE CD-DOOR DOWNWARDS UNTIL IT LOCKS SHUT.
- THE CD IS NOW READY TO BE PLAYED.
- TO REMOVE A DISC, FOLLOW THE SAME PROCEDURE AS DESCRIBED ABOVE,
EXCEPT TO REMOVE THE CD INSTEAD OF INSERTING IT INTO THE COMPARTMENT,
BY PLACING ONE FINGER AT THE MIDDLE OF DISC (CENTER SPINDLE) & THE OTHER
AT THE EDGE OF THE DISC & GENTLY PULLING UPWARDS.
- IMPORTANT : ALWAYS HOLD A CD BY ITS EDGES. AVOID GETTING ANY FINGER
PRINTS, SMUDGES OR DIRT ONTO THE SURFACE OF A DISC. IN CASE THIS
HAPPENS, USE A SPECIAL CD-CLEANING CLOTH OR CLEANING KIT TO REMOVE THE
DIRT OR SMUDGES.
PLEASE MAKE SURE TO ALWAYS FOLD DOWN THE HANDLE ALL THE WAY BEFORE
OPENING THE CD DOOR.
IMPORTANT:
INSERTION & REMOVAL OF DISCS
SIDE VIEW:
1
SIDE VIEW:
2
NORMAL CD OPERATION
- INSERT A CD AS DESCRIBED.
- SLIDE THE FUNCTION SWITCH TO "CD ". THE BLUE DISPLAY LIGHT WILL BE "ON".
- THE CD WILL SPIN MOMENTARILY AND THEN THE DISPLAY WILL SHOW THE TOTAL
NUMBER OF TRACKS (SONGS) OF THE DISC.
- PRESS THE "PLAY/ PAUSE" KEY TO START PLAYBACK. THE DISPLAY WILL
INDICATE THE CURRENT TRACK NO. ("cd01" FOR THE FIRST TRACK).
- AT ANYTIME DURING PLAYBACK, PRESS THE "PLAY/PAUSE" KEY TO PAUSE
OPERATION OF THE UNIT. PRESS PLAY/PAUSE KEY TO RESUME OPERATION AT
THE SAME TRACK & POSITION. THE SONG NUMBER WILL "FLASH" IN THE DISPLAY
DURING "PAUSE" MODE.
PROGRAMMING THE CD PLAYER
- THE CD PLAYER CAN BE PROGRAMMED TO PLAY ANY SEQUENCE AS DESIRED
(20 TRACKS FOR CD-AUDIO).
- ALWAYS PRESS THE STOP KEY BEFORE STARTING THE PROGRAMMING.
- PRESS THE "REPEAT" KEY, THE DISPLAY WILL SHOW "0101" AND
THE "PROGRAM" SYMBOL WILL BE SHOWN, TO INDICATE THAT THE SET IS
NOW IN "MEMORY PROGRAMMING MODE", AT THE FIRST MEMORY POSITION.
- REPEAT THE PREVIOUS 2 STEPS, EACH TIME SELECTING ANY TRACK NUMBER
OF YOUR CHOICE TO BE STORED IN THE SUCCESSIVE MEMORY (PROGRAM)
POSITIONS.
- WHEN YOU PRESS THE DISPLAY WILL
ADVANCE TO THE NEXT MEMORY POSITION (eg. "0200").
THE "PROGRAM" KEY
- PRESS THE BACK/NEXT KEYS OR TO SELECT THE TRACK (SONG)
NUMBER YOU WISH TO BE STORED IN THE FIRST MEMORY (PROGRAM)
POSITION, AND PRESS THE "PROGRAM" KEY TO CONFIRM YOUR
SELECTION.
- AFTER EACH TRACK NUMBER, REMEMBER TO PRESS THE "REPEAT" KEY.
- AFTER A MAXIMUM SONGS (OR LESS) HAVE BEEN SELECTED AS DESCRIBED
ABOVE, PRESS THE "PLAY/ PAUSE " KEY .
- THE "PROGRAM" SYMBOL WILL REMAIN "ON" TO INDICATE
THAT YOU HAVE SAVED A PROGRAM-MEMORY (SEQUENCE).
- PRESSING "PLAY/ PAUSE" STARTS PLAY BACK OF THE "SAVED SEQUENCE"
IN THE PROGRAM MEMORY.
- TO CLEAR (CANCEL) THE ENTIRE PROGRAM WHICH IS STORED IN THE MEMORY,
SIMPLY PRESS "STOP" ONCE, OR SWITCH "OFF" THE SET.
PROG
- AT ANYTIME DURING PLAYBACK, PRESS THE "STOP" KEY TO STOP
OPERATION OF THE SET. THIS WILL RESET THE CD PLAYER TO THE FIRST TRACK
(IF YOU PRESS PLAY AFTER STOP, THE FIRST TRACK WILL ALWAYS START PLAYING).
- AT ANYTIME DURING PLAYBACK, "PRESS AND RELEASE" THE BACK/NEXT
KEYS : OR TO SKIP BACKWARDS OR FORWARDS BY ONE TRACK, AS
DESIRED.
- AT ANYTIME DURING PLAYBACK, PRESS THE "REPEAT" KEY AS FOLLOWS:
PRESS ONCE = (REPEAT SYMBOL IS FLASHING), TO REPEAT THE CURRENT
TRACK
PRESS TWICE = (REPEAT SYMBOL IS CONTINUOUSLY "ON") TO REPEAT ALL
TRACKS (FULL CD)
PROG
THE "SAVED SEQUENCE" IN PROGRAM MEMORY CAN STORE UP TO 20 SONGS.
SONGS SAVED TO PROGRAM MEMORY AFTER THE 20TY SELECTION WILL BE
IN PLACE OF, AND REFRESH IN SEQUENCE, THOSE ALREADY SAVED AND
LOCATED FROM THE FIRST (PROGRAM) POSITION ONWARDS.
NOTE:
