Dosatron D25 Series Betriebsanleitung

Troubleshooting for D25 Series

Symptom Cause Solution

Piston

Piston is not clicking The unit is installed in the wrong

direction The arrow on the unit should point in the same

direction as the water flow. Water supply and

demand valves should be open.

Piston locked up/not clicking Reset piston. See instructions.

Broken actuator spring Replaced both actuator springs.

Excessive water flow 1. Reduce the flow rate and slowly restart the

unit.

2. Remove the lid, pull out the piston and check

if the O-rings around the piston valves are

missing or dislodged.

3. Reset piston (see instructions) screw lid back

on.

Water hammer Reset piston (see instructions) and install water

hammer arrestor in the appropriate location.

In-line water filter is clogged Clean the in line water filter.

Worn, scratched/scored piston shell and/

or body Do piston “fit” test (see instructions). replace

piston shell and/or body. Make sure your

installation has a 200 mesh filter before the

Dosatron.

Dosing

Water flowing back into

solution container Check valve dirty, worn, assembled

incorrectly or missing. Clean or replace the check valve assembly. Be

sure the check valveseal is in proper position.

No suction of solution Piston locked up/not clicking Reset piston. See instructions.

Air leak in the suction tube

Check suction tube connection. Inspect suction

tube for pin holes or cracks.

Check tightness of connection nuts.

Cut ½” of top of the hose and reattach it

correctly.

Suction tube or strainer clogged Clean suction tube and strainer or replace hose

assembly.

Raise strainer 2” off the bottom of stock tank

solution.

Check valve worn, improperly

assembled, dirty or damaged Clean or replace check valve assembly. Be sure

the check valve seal is in proper position.

Plunger seal is damaged, swollen or

missing Clean or replace plunger seal.

If plunger seal is missing, check incoming water

pressure; refer to unit manual for specifications.

Page 1

Symptom Cause Solution

Dosing

No suction of solution (cont.) Worn, scratched/scored piston shell and/or

body Do piston “fit” test (see instructions). If neces-

sary replace piston shell and/or body. Make

sure your installation has a 200 mesh filter

before the Dosatron.

Suction of air Check suction tube connection. Inspect

suction tube for pin holes or cracks.

Check tightness of connection nuts.

Cut ½” off top of the hose and reattach it

correctly.

Excessive water flow Listen to the unit clicking, count the

individual clicks, shouldnot exceed 46 clicks

in 15 seconds otherwise is

excessive flow. If excessive flow reduce the

flow rate and restart the unit slowly.

Worn plunger seal Replace plunger seal.

Worn or cracked injection stem (inside and

outside) . Replace injection stem.

Check valve worn, improperly assembled,

dirty or damaged Clean or replace check valve assembly. Be

sure the check valveseal is in proper position.

Leaks

Leaks near the metal collar

under the body. Sleeve O-ring damaged, improperly posi-

tioned or missing Replace sleeve O-ring.

Leaks between adjusting nut

and the anti-lock ring. Dosing stem O-ring damaged, improperly

positioned or missing Clean and replace dosing stem O-ring.

Leaks between body and lid. Lid O-ring damaged, improperly positioned

or missing Clean the seating surface of the O-ring and

position O-ring correctly or replace the lid O

-ring.

Troubleshooting for D25 Series

Page 2

D25 Series Piston “Fit” Test

Insert piston into the body half way down, suspend the unit from the

valve support ONLY

ONLY, then lift it. The piston should be snug in the body

and the body should not fall off. If it does, the piston shell needs to be

replaced. Also inspect the inside of the body and look for deep

vertical scratches. If this is the case, the body needs to be replaced.

Page 3

Reset D25 Series Piston

To reset the piston, remove the lid and push the piston all the way

down. It may click. Pull the piston all the way up. Holding it in the

up position, push down on the vertical rod and it should click.

Push the piston back all the way down and it should click again.

Screw the lid on.

Page 4 2007-39-MAINT003

Andere dosatron Wasserpumpe Handbücher

dosatron

dosatron D40MZ3000 Bedienungsanleitung

dosatron

dosatron D9 Green Line Bedienungsanleitung

dosatron

dosatron INDUSTRY Series Bedienungsanleitung

dosatron

dosatron D9 Green Line Bedienerhandbuch

dosatron

dosatron D25RE09 Betriebsanleitung

dosatron

dosatron GENUINE D14MZ5VVFII Bedienungsanleitung

dosatron

dosatron D14MZ520 Bedienerhandbuch

dosatron

dosatron D3WL Bedienerhandbuch

dosatron

dosatron D14MZ10AFII Bedienungsanleitung

dosatron

dosatron D14WL3000IE Bedienungsanleitung

dosatron

dosatron D 45 RE 3000 Bedienungsanleitung

dosatron

dosatron Dilution MDE0110MF1.5KIT Bedienungsanleitung

dosatron

dosatron D 07 RE 5 Bedienungsanleitung

dosatron

dosatron D 25 F Bedienungsanleitung

dosatron

dosatron Green Line D90 GL Bedienerhandbuch

dosatron

dosatron GREEN LINE D30GL02 Bedienerhandbuch

dosatron

dosatron D40 Bedienungsanleitung

dosatron

dosatron D3 TRE 3000 Bedienungsanleitung

dosatron

dosatron D3 Series Bedienungsanleitung

dosatron

dosatron D8IL EX Bedienungsanleitung

dosatron

dosatron D25+ Series Bedienungsanleitung

dosatron

dosatron ANIMAL HEALTH D25AL2-N Bedienungsanleitung

dosatron

dosatron D14MZ5VFII Bedienungsanleitung

dosatron

dosatron D3 RE 3000 Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

moyno

moyno 2000 CC Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

dosatron D25 Series Betriebsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken