Drive 13085LN Bedienungsanleitung

seat lift

chair table

item # 13085LN

lifetime limited

warranty

Your Drive branded product is warrantied to be free

of defects in materials and workmanship for the

lifetime of the product for the original consumer

purchaser.

This device was built to exacting standards and

carefully inspected prior to shipment. This Lifetime

Limited Warranty is an expression of our confidence

in the materials and workmanship of our products

and our assurance to the consumer of years of

dependable service.

This warranty does not cover device failure due to

owner misuse or negligence, or normal wear and tear.

The warranty does not extend to non-durable compo-

nents, such as rubber accessories, casters, and grips,

which are subject to normal wear and need periodic

replacement.

If you have a question about your Drive device or

this warranty, please contact an authorized Drive

dealer.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

www.drivemedical.com

EU Authorized Representative

Drive Medical LTD

Ainley’s Industrial Estate

Elland, West Yorkshire,

United Kingdom HX5 9JP

www.drivemedical.com

Rev.6.05.15.14

THIS TABLE IS TO BE USED WITH

HEAVIER CHAIRS AND COUCHES.

INCORRECT POSITIONING OF

TABLE BASE (#7) UNDER THE

CHAIR OR COUCH MAY RESULT

IN THE TABLE TIPPING OVER.

(REF. ASSEMBLY STEP 1)

assembly instructions

CAUTION--SPRING LOADED ASSEMBLY

Do not remove the black shipping screw

before completing assembly steps 1- 5.

Removing the shipping screw before this can

result in personal injury and spring damage.

PRODUCT IS NOT TO BE USED AS A LIFT

ASSIST OR TO HOLD MORE THAN 25 LBS.

Tools Necessary For Assembly:

Phillips Screwdriver

(2) 7/16” Wrenches

FIGURE 1

FIGURE 2

FIGURE 3

TO ELEVATE THE TABLE:

Push upwards at any position on the underside

of the top, until the top has reached the desired

height.

TO LOWER THE TABLE:

Squeeze the trip handle up and push the top down

to the desired height. The table will operate best

if the downward pressure is placed at the column

end of the top.

Occasional application of light oil lubrication

between the inner and outer columns will help

keep your Table operating smoothly. Penetrating

oils with rust inhibitors are recommended.

The table will swing a full 360º around on the base

to be used as an end table or a lap tray as needed.

operating instructions

1. Place the base (#7) under the le side of chair

with the magazine rack opening facing the

rear of chair. Place the front le leg of the

chair on the positioning pad (#8) located near

the magazine rack.

2. Stand the Column (#6) on end, making sure

the Trip Rod is visible in the rectangular tube

but not protruding out of the top, as shown in

Fig. 1. If necessary, shake the Column (#6) until

the rod drops.

3. Insert Trip Handle (#4) into the Column (#6)

with the rounded side up. Be sure that the

Trip Handle (#4) rests on top of the rod inside

the Column (#6). Fig. 1

4. Place the Top (#1) on a ﬂat surface, with the

Top Bracket (#9) facing upward. Then, while

holding the Trip Handle (#4) in place so it

doesn’t fall out, insert the Column (#6) into the

Top Bracket (#9). Align the holes in the

Column foot (#6), the Trip Handle (#4) and the

Top Bracket (#9). Install both bolts (#2) and

both nuts (#5) thru these aligned holes with

the two (2) 7/16” wrenches. Fig. 2

5. Pick up the Top (#1) and Column (#6) and place

over the round tube on the Base (#7) inside of

the magazine rack. Be sure the Column (#6)

has dropped down all the way!

6. Remove the black shipping screw in the

column and replace it with the zinc plated

screw (#3), using a Phillips screwdriver. Fig. 3

Rev.6.05.15.14

seat lift

chair table

item # 13085RN

lifetime limited

warranty

Your Drive brand product is warranted to be free

of defects in materials and workmanship for the

lifetime of the original consumer purchaser.

This device was built to exacting standards

and carefully inspected prior to shipment. This

Lifetime Limited Warranty is an expression of our

confidence in the materials and workmanship of

our products and our assurance to the consumer

of years of dependable service.

This warranty does not cover device failure

due to owner misuse or negligence, or normal

wear and tear. The warranty does not extend to

non-durable components, such as rubber

accessories, casters, and grips, which are subject

to normal wear and need periodic replacement.

If you have a question about your Drive device or

this warranty, please contact an authorized Drive

dealer.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

www.drivemedical.com

EU Authorized Representative

Drive Medical LTD

Ainley’s Industrial Estate

Elland, West Yorkshire,

United Kingdom HX5 9JP

THIS TABLE IS TO BE USED WITH

HEAVIER CHAIRS AND COUCHES.

INCORRECT POSITIONING OF

TABLE BASE (#7) UNDER THE

CHAIR OR COUCH MAY RESULT

IN THE TABLE TIPPING OVER.

(REF. ASSEMBLY STEP 1)

assembly instructions

CAUTION--SPRING LOADED ASSEMBLY

Do not remove the black shipping screw

before completing assembly steps 1- 5.

Removing the shipping screw before this can

result in personal injury and spring damage.

1. Place the base (#7) under the right side of

chair with the magazine rack opening facing

the rear of chair. Place the front right leg of

the chair on the positioning pad (#8) located

near the magazine rack.

2. Stand the Column (#6) on end, making sure

the Trip Rod is visible in the rectangular tube

but not protruding out of the top, as shown in

Fig. 1. If necessary, shake the Column (#6) until

the rod drops.

3. Insert Trip Handle (#4) into the Column (#6)

with the rounded side up. Be sure the Trip

Handle (#4) rests on top of the rod inside the

Column foot (#6). Fig. 1

4. Place the Top (#1) on a ﬂat surface, with the

Top Bracket (#8) facing upward. Then, while

holding the Trip Handle (#4) in place so it

doesn’t fall out, insert the Column (#6) into the

Top Bracket (#8). Align the holes in the

Column foot (#6), the Trip Handle (#4) and the

Top Bracket (#8). Install both bolts (#2) and

both nuts (#5) thru these aligned holes with

the two (2) 7/16” wrenches. Fig. 2

5. Pick up the Top (#1) and Column (#6) and place

over the round tube on the Base (#7) inside of

the magazine rack. Be sure the Column (#6)

has dropped down all the way!

6. Remove the black shipping screw in the

column and replace it with the zinc plated

screw (#3), using a Phillips screwdriver. Fig. 3

Product is NOT to be used as a le assist or to

hold more than 25 lbs.

Tools Necessary For Assembly:

Phillips Screwdriver

(2) 7/16” Wrenches

TO ELEVATE THE TABLE:

Push upwards at any position on the underside

of the top, until the top has reached the desired

height.

TO LOWER THE TABLE:

Squeeze the trip handle up towards and push the

top down to the desired height. The table will

operate best if the downward pressure is placed at

the column end of the top.

Occasional application of light oil lubrication

between the inner and outer columns will help

keep your Over Bed Table operating smoothly.

Penetrating oils with rust inhibitors are

recommended.

The table will swing a full 360º around on the base

to be used as an end table or a lap tray as needed.

operating instructions

FIGURE 1

FIGURE 2

FIGURE 3

Dieses Handbuch passt für folgende Modelle

Andere Drive Mobilitätshilfe Handbücher

Drive

Drive ROOMBA Bedienungsanleitung

Drive

Drive Trekker TK 1000 Bedienungsanleitung

Drive

Drive PreserveTech RTL12C003-WH Bedienungsanleitung

Drive

Drive R6 Benutzerhandbuch

Drive

Drive ROOMBA Bedienungsanleitung

Drive

Drive Posterior Safety Roller Bedienungsanleitung

Drive

Drive 10215RD-1 Bedienungsanleitung

Drive

Drive TR 8023 Bedienungsanleitung

Drive

Drive GiGo Bedienungsanleitung

Drive

Drive PATRIOT Series Bedienungsanleitung

Drive

Drive RTL11158KDR Bedienungsanleitung

Drive

Drive D-Lite Bedienungsanleitung

Drive

Drive ROOMBA Bedienungsanleitung

Drive

Drive 10252BL Bedienungsanleitung

Drive

Drive 10220-1WW Bedienungsanleitung

Drive

Drive Delphi Bedienungsanleitung

Drive

Drive 10350-1 Bedienungsanleitung

Drive

Drive Diamond Deluxe Bedienungsanleitung

Drive

Drive Aluminium Triwalker Steel Triwalker Benutzerhandbuch

Drive

Drive 13031-1SV Bedienungsanleitung

Drive

Drive GiGo Bedienungsanleitung

Drive

Drive Nitro Rollator Bedienungsanleitung

Drive

Drive Devilbiss HEALTHCARE Cristallo Bedienungsanleitung

Drive

Drive Nitro RTL10266 Bedienungsanleitung

Beliebte Mobilitätshilfe Handbücher anderer Marken

Alber

Alber Scalamobil iQ Bedienungsanleitung

Ferno

Ferno CCT-PX Bedienungsanleitung

HEPRO

HEPRO Gripo Bedienungsanleitung

Otto Bock

Otto Bock Pheon 3R62 Bedienungsanleitung

NRS Healthcare

NRS Healthcare M11090 Bedienungsanleitung

Medline

Medline MDS86835DSHEC Installationsanleitung

Guldmann

Guldmann Twin Turner II Bedienungsanleitung

Gate

Gate Balder Bedienungsanleitung

Decon wheel

Decon wheel TNS Notos Bedienungsanleitung

ExoAtlet

ExoAtlet ExoAtlet-II Bedienungsanleitung

Invacare

Invacare Storm Series Bedienungsanleitung

Rhythm Healthcare

Rhythm Healthcare B3800F Bedienungsanleitung

AMF-BRUNS

AMF-BRUNS PROTEKTOR Bedienungsanleitung

Drive DeVilbiss Healthcare

Drive DeVilbiss Healthcare OTTER Bedienungsanleitung

Rhythm Healthcare

Rhythm Healthcare C500U Bedienungsanleitung

Lumex

Lumex RJ4200A Bedienungsanleitung

Rebotec

Rebotec Jumbo Bedienungsanleitung

Rehaforum MEDICAL

Rehaforum MEDICAL PR50548 Bedienungsanleitung