Drive Heavy Duty Suction Device Bedienungsanleitung

heavy duty suction device

bomba de succión de uso pesado

pompe aspiratrice robuste

USER’S MANUAL

MANUAL DEL USUARIO

GUIDE DE L’UTILISATEUR

18600

Rev3.07.27.15

index

CAUTION

Federal law restricts this device to sale by or on order of a physician, or any other practitioner

licensed by the law of the State in which he practices to use or order the use of this device.

NOTE

Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact medi-

cal equipment provider for further instruction.

1. Safety Information...........................................................3

2. AC Power Source..............................................................4

3. Electrical.............................................................................3-4

4. Introduction........................................................................5

5. Illustration of Important Parts.......................................6

6. Set-Up...................................................................................7

7. How to Operate Your Heavy Duty Suction Pump ....7-8

8. Cleaning Instructions........................................................8

9. Maintenance.......................................................................9-10

10. Troubleshooting..................................................................10

11. Speciﬁcations/Classiﬁcations........................................11

12. Warranty...............................................................................12

safety information

1. SAFETY INFORMATION

When using electrical products, especially when children are present, basic safety precautions

should always be followed. Read all instructions before using.

Important information is highlighted by these terms:

DANGER

Urgent safety information for hazards that will cause serious injury or death.

WARNING

Important safety information for hazards that might cause serious injury.

CAUTION

Information for preventing damage to the product.

NOTE

Information to which you should pay special aention.

read all user’s manual before using.

save user’s manual

DANGER

To reduce the risk of electrocution:

1. Do not use while bathing.

2. Do not place or store product where it can fall or be pulled into a tub or sink.

3. Do not place in or drop into water or other liquid.

4. Do not reach for a product that has fallen into water. Unplug immediately.

WARNING

To reduce the risk of burns, electrocution, ﬁre or injury to persons:

1. Close supervision is necessary when this product is used by, on, or near children or invalids.

2. Use this product only for its intended use as described in this guide.

3. Never operate this product if:

a. It has a damaged power cord or plug.

b. It is not working properly.

c. It has been dropped or damaged.

d. It has been dropped into water.

4. Return the product to an authorized Drive medical equipment service

center for examination and repair.

5. Keep the power cord away from heated surfaces.

6. Never use while drowsy or asleep.

SPECIFIC WARNINGS

TO REDUCE THE RISK OF ELECTRICAL SHOCK OR INJURY TO PERSONS, DO NOT

DISASSEMBLE THIS UNIT. DISASSEMBLY OR ATTEMPTED REPAIRS IF ACCOMPLISHED

INCORRECTLY CAN CREATE ELECTRICAL SHOCK HAZARD. ONLY QUALIFIED

TECHNICIANS SHOULD PERFORM SERVICING OF THIS SUCTION UNIT.

DANGER

The Heavy Duty Suction Pump is a vacuum suction device designed for the collection of nonﬂam-

mable ﬂuid materials in medical applications only. Improper use during medical applications can

cause injury or death.

For all medical applications:

1. All suctioning should be done in strict accordance with appropriate procedures that have been

established by a licensed medical authority.

2. Some aachments or accessories may not ﬁt the tubing supplied. All aachments or accesso-

ries should be checked prior to use to assure proper ﬁt.

2. AC POWER SOURCE

CAUTION

Item # 18600 is used with a power supply allowing operation on AC voltage (115 VAC, 60 Hz).

However the correct power source must be used to connect to adaptable wall power.

3. ELECTRICAL

Compressor

If the overload protector shuts oﬀ the motor frequently, you may have a low voltage situation.

Low voltage can also be suspected when:

1. The motor does not get up to full power or speed.

2. Other motor operated appliances fail to operate properly. Too many motor operated appli-

ances on same circuit.

NOTE

The motor of this compressor has a thermal overload protector. If the motor overheats, the over-

load protector will shut oﬀ the motor. If this occurs, turn the ON/OFF switch to the OFF position

and allow the motor to cool (approximately 5 minutes). Restart compressor. If the compressor

fails to start, wait an additional 5 minutes before aempting to restart. If this fails, inspect the

fuses on your suction unit. If the unit still does not restart, call your medical equipment provider

immediately.

safety information

WARNING

Proper operation of this product is necessary to avoid physical harm. Improper use can cause

personal injury and/or tissue damage. This product should not be used unless the operator has

been instructed by a physician or other qualiﬁed health care professional.

1. Familiarize yourself with this unit.

2. Place unit on table and push down hard so that suction feet hold unit ﬁrmly in place.

3. Before plugging power cord into electrical outlet, check if the ON/OFF switch is in the OFF

position.

NOTE

Before aempting to start a cold unit, let the unit reach room temperature in a heated area.

introduction

Your Heavy Duty Suction Pump is a professional medical suctioning device that produces a maxi-

mum vacuum of 560 mmHg. The unit is equipped with an 800cc collection bole and has been

designed for convenient and reliable usages.

Features:

New anti-bacteria ﬁlter design helps prevent contamination.

High quality vacuum regulator and anti-vibration vacuum gauge seing.

Oil-less, permanent lubrication.

Collection bole with overﬂow protection.

Superior performance and high reliability for continuous operation design.

Easy carry and easy cleaning.

Following the recommended operating and maintenance procedures outlined in this user’s

manual will maximize the life of this product. Refer to the diagrams on page 6.

NOTE

This unit complies with electromagnetic compatibility standards as deﬁned in the aached

declaration of conformity.

Item # 18600

1. Vacuum Gauge

2. Vacuum Adjust Knob

3. Bacteria Filter

4. Cord Caddy

5. Base

6. 800cc Collection Bottle

7. Patient Tubing

8. Cover

9. Connection Tubing

10. Power Switch

11. Power Cord

12. Fuse

illustration of important parts

set up & operation

1. Connect either end of the connecting tubing (item# 9) to the top of collection bottle connector

then connect the other end to the bacteria ﬁlter.

2. The patient tubing should be connected to collection bottle at the outlet labeled (patient).

Please assure that all connections are secure and without leaks before using.

7. HOW TO OPERATE YOUR HEAVY DUTY SUCTION PUMP

1. Before use, check the speciﬁcation label on the side of the suction unit to ensure that the volt-

age and current indicated on the unit correspond with the voltage and current available. Make

sure the power switch located on the side of the unit is in the “Off” position before connecting

the unit to a power source.

2. Switch the power switch to “I” position (on), the unit start running.

1. Off position 2. On position

3. Adjust the vacuum level from 0 to 560 mmHg (0 to 56 cmHg) by turning the vacuum adjust

knob (clockwise to increase vacuum and counter-clockwise to decrease vacuum). Referring to

the vacuum gauge while setting the desired level of vacuum. To accurately read the gauge, block

the patient end of the hose or cap off the collection bottle and allow the gauge to reach a stable

vacuum reading.

set up & operation

4. Place the patient tubing to the appropriate position of patient and start to suck sputum.

5. When the sputum reaches the safe full level of collection bole (800cc), the suctioning will

stop sucking automatically (ﬂoat shut-oﬀ).

6. Switch the power switch to “O” position (oﬀ), shut oﬀ the suction motor.

7. Remove the sputum from collection bole aer the motor stops turning completely. (Please

refer to the section “CLEAN INSTRUCTIONS” on page 9 for the directions of how to clean the

collection bole).

8. Turn on the unit and start to run the suction unit again.

NOTE

1. If the unit sustains a severe drop, validity of the gauge must be checked. Inspect if the ﬂoat

shut-oﬀ is still functioning properly when the liquid in the collection bole reaches the safe full

level.

2. Always transport unit with vacuum adjust knob rotated fully clockwise in case unit is dropped.

CAUTION

1. When automatic ﬂoat shut-oﬀ is activated, contents of the collection boles should be emp-

tied. Further suctioning could cause damage to the vacuum pump.

2. Should ﬂuid be aspirated back into the unit, send your suction to an authorized service center

for a detailed inspection as the vacuum pump may have been damaged.

Clean Collection Bole:

1. Turn oﬀ the suction unit and allow vacuum to drop, then disconnect AC power source.

2. With the collection bole still in the holder, remove the collection bole lid. The bole can now

be taken out of the holder to be emptied.

NOTE

Collection bole should be emptied aer each use.

3. Collection bole should be thoroughly cleaned aer each use by one of the following three

methods:

a. Wash in a hot water/dishwashing detergent solution and rinse with clean, hot tap water.

Then wash in one part vinegar to three parts hot water solution. Rinse with hot tap water

and air dry.

b. Wash with rubbing alcohol and air dry

c. Wash with a commercial (bacterial-germicidal) disinfectant, follow disinfectant manufacturer’s

recommended instructions and dilution rates carefully.

cleaning

cleaning & maintenance

Clean Suction Unit and Collection Bole Lid:

1. Disconnect the suction unit from all external power sources.

2. Wipe the suction unit housing and collection bole lid with a clean cloth and any commercial

(bacterial-germicidal) disinfectant.

CAUTION

Do not submerge in water as this will result in severe damage to the vacuum pump.

Clean Tubing:

1. Disconnect the tubing from the unit.

2. Tubing should be rinsed thoroughly aer every use by running hot tap water through it

followed by a solution of one part vinegar to three parts hot water.

3. Rinse with hot tap water and air dry.

4. Keep the outer surface of the tubing clean by wiping with a clean, damp cloth.

WARNING

The waste in collection bole may cause respiratory infection which must be handled according

to medical waste disposing regulation. Operator must wear gloves and medical class mask be-

fore cleaning the collection bole, tubing and handle the wasting unit and/or accessories.

MAINTENANCE

Inspect suction tubing and collection bole for leaks, cracks, etc. before each use.

DANGER

Electric shock hazard

Do not aempt to open or remove the suction cabinet. If a service is required, return your

suction to an authorized service center. Opening or tampering with the unit will void warranty.

Bacteria Filter Change:

1. Bacteria ﬁlter should be replaced as needed. If overﬂow occurs, change the ﬁlter immediately.

2. Remove ﬁlter by disconnecting it from tubing connected to pressure adjusting valve and tubing

connected to collection bole lid assembly.

3. Replace with a new Drive bacteria ﬁlter and connect to above two tubing. Additional ﬁlters

can be purchased from an authorized dealer.

NOTE

Use only Drive ﬁlters. Do not substitute any other material for this bacteria ﬁlter. Improper

substitution may lead to contamination or poor performance;

Fuse Change:

1. Use only the same type of fuse to replace the broken fuse.

2. Fuse speciﬁcation: Miniature Glass Fuse 5x20mm, Fast Blow (Quick Acting), F2A/250V.

WARNING

When this unit or accessories reach the end of their useful lives (depends on using conditions),

residues in collection bole, tubing and ﬁlter may cause respiratory infection. Dump the wasting

collection bole, tubing and ﬁlter into a speciﬁc waste bin labeled with medical waste.

Your Heavy Duty Suction Pump contains no user-serviceable parts. If you believe your unit is

not working properly, BEFORE YOU RETURN IT TO THE MEDICAL EQUIPMENT PROVIDER

WHERE YOU PURCHASED IT, please take a few moments to check for these possible causes:

PROBLEM ACTION

Unit does not turn on 1. Check power source and connection

2. Ensure that the wall outlet is live

3. Check power cord is not damage

Motor runs, no vacuum 1. Verify tubing connection security

2. Check for leaks or tubing kinks

3. Ensure that ﬂoat shut-oﬀ is not activated

4. Check for bole leaks and cracks

Low Vacuum 1. Use vacuum adjust knob to increase vacuum level

2. Check system for leaks

3. Rotate vacuum adjust knob counter clockwise

and release

maintenance

troubleshooting

Inhaltsverzeichnis

Sprachen:

Andere Drive Wasserpumpe Handbücher

Drive

Drive 14001E Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung