Drive Rebel wheelchair Bedienungsanleitung

rebel wheelchair

silla de ruedas rebel

fauteuil roulant rebel

www.drivemedical.com

EU Authorized Representative

Drive Medical LTD

Ainley’s Industrial Estate

Elland, West Yorkshire,

United Kingdom HX5 9JP

1. Remove all contents from the carton. Unfold the wheelchair frame by pulling

outward on sides of frame until fully opened.

2. The Rebel Wheelchair is shipped with the back in the folded down position. Pull

upwards on the back upholstery until the back locks into position. Be sure the

back is securely locked before sitting in the wheelchair.

3. Insert the arm of the wheelchair into the frame receptacle as shown in figure A.

Repeat for the other arm.

assembly instructions

4. Insert the front casters by depressing the spring loaded pin on the shaft of the

caster and slide into the frame of the wheelchair. An audible “click” will be heard

when secure (figure B).

Figure A

Figure B

5. Slide the pin of the “E” Clip into the

receiving port on the outside of the

frame Take the thumb screw and

place into the receiving port on the

inside of the frame and turn

clockwise until tight. Repeat for the

other caster. (figure C)

Thumb

Screw

E-Clip

6. Locate the port for the rear axle on the bottom back of the frame (figure D).

Depress the spring loaded button on the center of the rear wheel and slide the

axle into the frame of the wheelchair. There is a spring loaded pin in the axle that

will “click” when the axle is securely positioned. Repeat for the other wheel.

assembly instructions

Rear Axle

Port

Figure C

Figure D

To remove wheel, depress spring

loaded button and slide wheel

out from axle port.

assembly instructions

7. Place the footrests on the wheelchair by locating the hanger bracket on the

front of the frame and inserting the footrest onto the pins as shown in figure E.

The footrests come with a release lever to swing the footrests away from the chair

to remove. Repeat for the other side.

Figure E

8. To adjust the height of the footplate, locate the lock clip on the footrest and pull

up on the tab. Slide the footplate to the desired height and lock the tab as

shown in figure F.

Figure F

assembly instructions

Figure G

9. The Rebel Wheelchair comes with a calf strap for additional support. Locate the

Velcro strips and roll the strap over the footrest and attach with the Velcro

closure (figure G).

Stability - Wheelchair is designed to be safe and stable as long as center of gravity is

maintained while going about normal activities. Care must be taken while performing

activities that shift your center of gravity in the chair. Never reach so far that require

you to shift in the seat or bend over out of the chair. When you have to reach for

objects that require you to lean, be certain front casters are pointing in a forward

position that extends the wheel base and will stabilize the chair.

Ramps - Be sure of your own capabilities, limitations and strength before attempting

to go up a ramp. Correct techniques on ramp negotiation should be shown to you by

a qualified professional. Assistance is recommended when going up or down inclines

greater than 10o. If you must stop on an incline, avoid sudden, abrupt movement

when you resume movement. Because of backward angle of the chair, sudden abrupt

movement could cause instability. Attempting to use the wheel lock brakes could

result in accidental locking, tipping to one side, or cause a sudden stop. Avoid changing

direction when going down an incline, as this could result in instability of tipping over.

caution

use and safety

Wheel Locks - Engage both wheel locks before getting in or out of chair, leaning

forward in chair, or while in an elevator or wheelchair lift. Proper adjustment of wheel

lock is at least 1/8” when locked. Locks are engaged by pushing handle completely

forward. Adjustments to locks are made by loosening or tightening nut on the carriage

bolt. Embed lock shoe at least 1/8” by sliding clamp toward rear wheel while handle is

engaged in locked position. Tighten nut and bolt to secure in position. Test for correct

locking action before actual use.

Tires - Solid rubber tires need minimal maintenance, but should be cleaned occasionally

with a damp cloth. Replace if tires become severely worn or cracking appears.

Removal of Swing-away Foot rests/Leg rests - Release lock by pushing on the front

rigging lever. Swing-away foot rest out and sideways. Lift to remove.

General Care - Wipe chrome parts with a clean, soft cloth at least once a week. All

metal parts can be cleaned with auto wax or similar poducts. If exposed to moisture, dry

immediately. Do not use an abrasive cleanser that will scratch the finish.

To Open Chair - Open wheelchair by tilting to one side and pushing down on seat rail

until fully opened.

To Close/Fold Chair - First fold foot plates to vertical position. Grab seat with both

hands at front and back edge and lift. Or, tilt chair to one side and lift up on seat rail.

Removable Arms - Remove arms by depressing spring button and lifting arms out of

front and rear sockets.

Do not attempt to adjust or operate wheelchair without reading carefully all

instructions in this manual.

This wheelchair has not been approved as a seat that can be used within vehicles of

any kind. Always transfer wheelchair user to a vehicle manufacturers approved seat

and use safety restraints available.

Do not operate this wheelchair on roadways, streets or any surfaces with vehicular

traffic.

Do not attempt to operate on inclines 10% or greater without proper assistance.

Be sure to completely engage wheel locks when getting in and out of wheelchair or

when in elevator or wheelchair lift.

Wheelchair should be on a smooth, stable and level area with wheel locks engaged

before transferring user in or out of wheelchair.

Do not adjust foot rests any lower than 2-1/2” from floor.

When getting in or out of wheelchair, do not stand on or apply weight to foot rests.

Before reaching or leaning forward, rotate casters to front of the wheelchair engage

wheel locks to help prevent wheelchair from tipping over.

Do not lean over or apply weight to the top of wheelchair back. This can cause

wheelchair to tip over. When trying to extend arms over back, only reach as far as

your arm can extend without having to alter your seating position.

DO NOT stand on wheelchair.

DO NOT use wheel locks to slow your descent down an incline.

Abruptly changing directions while going down an incline could cause instability or

possible tipping over.

WEIGHT CAPACITY 300 LBS

warning

1. Saque todas las partes de la caja. Desdoble el marco de la silla de ruedas al jalarlo

hacia afuera de los costados hasta que quede completamente abierto.

2. La Silla de Ruedas Rebel se envía con el respaldo doblado hacia abajo. Jale la

tapicería del respaldo hacia arriba hasta que el respaldo se bloquee en su

posición. Asegúrese de que el respaldo se haya enganchado de manera segura

antes de sentarse en la silla de ruedas.

3. Introduzca el brazo de la silla de ruedas dentro del receptáculo del marco, como

se indica en la figura A. Repita el mismo paso para el otro brazo.

instrucciones de armado

4. Introduzca las ruedas giratorias del frente al presionar la clavija de resorte que

está en el eje de la rueda giratoria y deslícela dentro del marco de la silla de

ruedas. Debe escuchar un “clic” cuando esté asegurada. (figura B)

Figura A

Figura B

5. Deslice la clavija del clip “E” dentro del

puerto receptor que está en la parte de

afuera del marco. Tome el tornillo y

colóquelo dentro del puerto receptor por

la parte de adentro del marco y gírelo

hacia la derecha hasta que quede

apretado, como se muestra en la figura C.

Repita la misma operación para la otra

rueda giratoria.

Tornillo

Clip “E”

6. Encuentre el puerto para el eje trasero que está en la parte de debajo de la parte

de atrás del marco (figura D). Presione el botón de resorte que está en el centro

de la rueda trasera y deslice el eje dentro del marco de la silla de ruedas. El eje

cuenta con una clavija de resorte que hará “clic” cuando el eje quede colocado de

manera segura. Repita lo mismo para la otra rueda.

instrucciones de armado

Puerto

Figura C

Figura D

Para quitar la rueda, presione

el botón de resorte y deslice la

rueda hacia afuera del eje.

instrucciones de armado

7. Coloque los estribos en la silla de ruedas, busque el soporte que está en frente

del marco e introduzca el estribo dentro de las clavijas como se muestra en la

figura E. Los estribos vienen con una palanca de liberación para girar los estribos

lejos de la silla y quitarlos. Repita lo mismo para el otro lado.

Figura E

8. Para ajustar la altura de los estribos, busque el clip de bloqueo del estribo y

jálelo hacia arriba de la lengüeta. Deslice el estribo a la altura deseada y

bloquee la lengüeta como se muestra en la figura F.

Figure F

Inhaltsverzeichnis

Andere Drive Rollstuhl Handbücher

Drive

Drive Enigma Bedienungsanleitung

Drive

Drive Blue Streak Bedienungsanleitung

Drive

Drive DINO Bedienungsanleitung

Drive

Drive Enigma Bedienungsanleitung

Drive

Drive Inspired Kanga Bedienungsanleitung

Drive

Drive DeVilbiss Healthcare LPHWCSP19SIL Bedienungsanleitung

Drive

Drive Teak RTL12350KDR Bedienungsanleitung

Drive

Drive EXP19RD Bedienungsanleitung

Drive

Drive Deluxe steel drop arm commode Bedienungsanleitung

Drive

Drive Kanga TS Bedienungsanleitung

Drive

Drive RTL12202KDR Bedienungsanleitung

Drive

Drive Sunfire Gladiator Bedienungsanleitung

Drive

Drive inspired POZIFORM P-CS180S Montageanleitung

Drive

Drive Sentra Bedienungsanleitung

Drive

Drive RTL12203KDR Bedienungsanleitung

Drive

Drive ASB-2109 Produkthandbuch

Drive

Drive silver sport 1 Bedienungsanleitung

Drive

Drive DuoMotion Bedienungsanleitung

Drive

Drive NRS185008 Bedienungsanleitung

Drive

Drive BES 120 Bedienungsanleitung

Drive

Drive 11120SV-1F Bedienungsanleitung

Drive

Drive KG A800 Bedienungsanleitung

Drive

Drive enigma steel Wheelchair Bedienungsanleitung

Drive

Drive 12202KD-4 Bedienungsanleitung

Beliebte Rollstuhl Handbücher anderer Marken

Otto Bock

Otto Bock Skippi plus Bedienungsanleitung

Invacare

Invacare Action 4NG series Bedienungsanleitung

SORG

SORG LoopSORG 802 Bedienungsanleitung

Designability

Designability WizzyBug Montageanleitung

Vermeiren

Vermeiren RAPIDO Bedienungsanleitung

Excel

Excel G5 KIDS 0285 Bedienungsanleitung

M. Bartels

M. Bartels SA-3 Bedienungsanleitung

Vermeiren

Vermeiren Turios Bedienungsanleitung

Invacare

Invacare Solara Spree GT Handbuch

nino robotics

nino robotics NIno Bedienungsanleitung

Invacare

Invacare MK5 EX Bedienungsanleitung

Nova

Nova TKW-12 Bedienungsanleitung

BCW

BCW Advantage Bedienungsanleitung

You-Q

You-Q Luca Bedienungsanleitung

interco

interco Ortolight Standard Bedienungsanleitung

Nova

Nova 7190L Bedienungsanleitung

Vermeiren

Vermeiren EZ1 Bedienungsanleitung

PaceSaver

PaceSaver Scout M-300 Bedienungsanleitung

Drive rebel wheelchair Bedienungsanleitung

Beliebte Rollstuhl Handbücher anderer Marken