4
Installation and Operation of: Tri-Channel Cold Pan
EXTERNAL EQUIPOTENTIAL BONDING TERMINAL (EXPORT ONLY)
1. This equipment has supplemental bonding terminal. The terminal provides an external
bonding connection used in addition to the earthing prong on the plug. The terminal
provides a connection for bonding to the equipment enclosure. The external equipotential
bonding terminal located on the rear outside surface of the unit, the terminal is marked
with the symbol to the right.
ELECTRICAL SHOCK HAZARD UNIT MUST BE SAFETY GROUNDED, EARTHED.
DO NOT MODIFY, DEFEAT ELECTRICAL CONNECTIONS OR ALTER PLUG.
ELECTRICAL CONNECTIONS
BEFORE CONNECTING THE UNIT TO THE POWER SOURCE, VERIFY THAT THE
VOLTAGE AND PHASE OF THE POWER SOURCE ARE IDENTICAL TO THE VOLTAGE AND
PHASE INFORMATION ON THE DATA LABEL.
ALL MAINS DISCONNET MUST BE INCORPORATED IN THE FIXED WIRING IN ACCORDANCE
WITH LOCAL WIRING RULES
EARTHING INSTRUCTIONS
1. THE UNIT MUST BE GROUNDED. Grounding reduces risk of electric shock by providing an escape wire
for the electric current if an electrical short occurs. This unit is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into a receptacle that is properly installed and
grounded.
2. Consult a qualied electrician or service agent if grounding instructions are not completely understood,
or if doubt exists as to whether the unit is properly grounded.
3. DO NOT USE AN EXTENSION CORD. If the product power cord is too short, have a qualied electrician
install a three-slot receptacle (or the country specic receptacle for International Units). This unit should
be plugged into a dedicated circuit with the electrical rating as provided on the product data plate.
INSTALLATION CODES AND STANDARDS
In the United States, the Unit must be installed in accordance with the following:
1. State and local codes.
2. National Electrical Code (ANSI/NFPA No. 70, latest edition) available from the National Fire Protection
Association, Batterymarch Park, Quincy, MA 02269.
3. Vapor Removal from Cooking Equipment, (NFPA-96, latest edition) available from NFPA.
4. Sealed to the counter upon which the equipment is placed per NSF/ANSI 4 standard.
In Canada, the Unit must be installed in accordance with the following:
1. Local codes.
2. Canadian Electrical Code (CSA C22.2 No. 3, latest edition) available from the Canadian Standards
Association, 5060 Spectrum Way, Mississauga, Ontario, Canada L4W 5N6.
“For CE Units, the Unit must be installed in accordance with the following:
1. Local codes.
2. European (IEC/CENELEC) Electrical Code
