Dunlop MXR CSP099 PHASE 99 Handbuch

92503014502revA

CSP099 PHASE 99

SAMPLE SETTINGS

CSP099 PHASE 99

POWER

The MXR Phase 99 is powered

by one 9-volt battery (remove

bottom plate to install), a 9-volt

AC adapter such as the Dunlop

ECB003/ECB003E, or a DC Brick™

power supply.

DESCRIPTION

• Two Phase 90 circuits in one

Phase 90-sized pedal

• Run both circuits independently

or feed one into the other

• Toggle between modern and

vintage phase sounds

DUNLOP MANUFACTURING, INC.

P.O. BOX 846 BENICIA, CA 94510 U.S.A.

TEL: 1-707-745-2722 FAX: 1-707-745-2658

CONTROLS

SPEED 1 knob controls rate of

Phase 1 circuit (indicated by

ashing red left-side LED)

P/S switch toggles signal ow

of phase circuits from parallel

(bluish purple LED) to series

(blue LED)

SYNC switch sweeps both

phase circuits at the rate of

the SPEED 1 control

VINTAGE switch engages

vintage phase voice

(indicated by yellow LED)

5SPEED 2 knob controls rate of

Phase 2 circuit (indicated by

ashing red right-side LED)

6FOOTSWITCH toggles

effect on/bypass (red LED

indicates on)

DIRECTIONS

• Run a cable from your guitar to

the Phase 99’s IN jack and run

another cable from the Phase

99’s OUT 1 jack to your amplier.

Optional: Run another cable from

the Phase 99’s OUT 2 jack to a

separate amplier to run each

phase circuit in stereo (Parallel

Mode).

• Start with all controls at

12 o’clock.

• Turn the effect on by

depressing the footswitch.

• Rotate the SPEED 1 knob

clockwise to increase the

rate of the Phase 1 circuit or

counterclockwise to decrease it.

• Rotate the SPEED 2 knob

clockwise to increase the

rate of the Phase 2 circuit or

counterclockwise to decrease it.

INTERNAL SW6 SWITCH

SW6 toggles Phase 1 and 2 mixing

on/off when OUT 2 is unplugged

(mono) and Parallel Mode is

selected. To mix both phase signals

and send them to OUT 1, set the

SW6 switch to its “down” position.

This is the default factory setting.

When SW6 is “up,” only Phase 1

will be heard from OUT 1, and the

Parallel Mode LED will become red.

Plugging into both OUT 1 and OUT

2 (stereo) in Parallel Mode results

in Phase 1 going to OUT 1 and

Phase 2 going to OUT 2, regardless

of SW6’s position. In Series Mode,

SW6 has no effect.

Note: SW5 switch should always

be left in its “up” position.

• To synchronize the sweep rate

of both phase circuits, push the

SYNC switch. The SPEED 1 knob

will then control the rate of both

circuits, and the SPEED 2 knob

will be inactive.

• To run both phase circuits in

Parallel Mode, set the P/S switch

to its “up” position (bluish purple

LED). To run Phase 1 and Phase 2

in Series Mode and create a more

intense effect with exaggerated

frequency cuts and peaks, set the

P/S switch to its “down” position

(blue LED).

• To change the tonal character

of the phase circuits from

modern to vintage, push

the VINTAGE switch.

SPECIFICATIONS

Input Impedance 450 kΩ

Output Impedance 2 kΩ

Nominal Input 20 dBV

Max Output 20 dBV

Noise Floor

Series Mode -95 dBV

Parallel Mode -101 dBV

Bypass Hardwire

Current Draw 24 mA

Power Supply 9 volts DC

NOTE: Actual measured values are

with a 10% add on to worse case

condition.

SW6 SW5

INTERNAL CONTROLS

(factory settings)

SUBTLE PHASE DEEP VIBE REVOLVING HORN

& DRUM (stereo outs)

(OUT) (IN)

(IN) (OUT) (OUT)

(IN) (OUT) (OUT)(OUT)

Andere Dunlop Musikpedal Handbücher

Dunlop

Dunlop CRY BABY WULDE WAH ZW-45 Bedienungsanleitung

Dunlop

Dunlop MXR PHASE 95 Bedienungsanleitung

Dunlop

Dunlop CRY BABY Q ZONE QZ1 Bedienungsanleitung

Dunlop

Dunlop JHF3 BAND OF GYPSYS FUZZ FACE Bedienungsanleitung

Dunlop

Dunlop JERRY CANTRELL CRY BABY Bedienungsanleitung

Dunlop

Dunlop Uni-Vibe UV-1SC Bedienungsanleitung

Dunlop

Dunlop Authentic Hendrix ’69 Psych Series Bedienungsanleitung

Dunlop

Dunlop VOLUME (X) MINI Bedienungsanleitung

Dunlop

Dunlop MXR SIX BAND GRAPHIC EQ M109 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Dunlop

Dunlop MC404 CAE WAH Bedienungsanleitung

Dunlop

Dunlop MXR Phase 90 Bedienungsanleitung

Dunlop

Dunlop AUTHENTIC HENDRIX 69 PSYCH SERIES BAND OF GYPPSYS... Bedienungsanleitung

Dunlop

Dunlop AUTHENTIC HENDRIX 69 PSYCH SERIES OCTAVIO... Bedienungsanleitung

Dunlop

Dunlop CryBaby 535 series Bedienungsanleitung

Dunlop

Dunlop FUZZ FACE FFM1 Bedienungsanleitung

Dunlop

Dunlop Fuzz Face JHM1 Bedienungsanleitung

Dunlop

Dunlop Authentic Hendrix 68 Shrine Series Bedienungsanleitung

Dunlop

Dunlop univibe jhm3 Bedienungsanleitung

Dunlop

Dunlop 105Q BASS WAH Bedienungsanleitung

Dunlop

Dunlop Billy Duffy Cry baby BD95 Bedienungsanleitung

Dunlop

Dunlop MXR M133 Bedienungsanleitung

Dunlop

Dunlop CBM95 Cry Baby Mini Wah Handbuch

Dunlop

Dunlop Cry Baby CBM105Q Handbuch

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung

Tube Works

Tube Works 310 Bedienungsanleitung