Dynex DX-M1113 - Hands-Free Wireless Microphone Bedienungsanleitung

USER GUIDE

GUIDE DE L’UTILISATEUR • GUÍA DEL USUARIO

Dynex Hands-Free Wireless

Microphone

Microphone sans fil mains libres de

Dynex

Micrófono Inalámbrico de Manos

Libres de Dynex

DX-M1113

DX-M1113.fm Page 1 Tuesday, September 19, 2006 7:07 AM

2Contents

Dynex DX-M1113 Hands-Free

Wireless Microphone

Contents

Important safety instructions ...................................2

Wireless microphone components ............................3

Setting up your wireless microphone .......................6

Using your wireless microphone ...............................7

Troubleshooting .......................................................8

Specifications ...........................................................9

Legal notice ............................................................11

Français.......................................17

Español .......................................33

Important safety instructions

Location

• Do not use your receiver or transmitter in an area with a

high magnetic field.

• Make sure that the receiver is at least 10 feet (3 meters)

above the floor and 10 feet (3 meters) from surrounding

walls.

• Do not place the receiver or transmitter in direct sunlight.

Do not expose the receiver or transmitter to rain or

moisture.

Repairs

Do not try to repair your wireless microphone yourself. Opening the case

could expose you to high electrical voltage. Refer all service to qualified

service personnel.

DX-M1113.fm Page 2 Tuesday, September 19, 2006 7:07 AM

Wireless microphone components 3

Handling

• Do not drop the receiver or transmitter.

• Do not set anything on top of the receiver.

Wireless microphone components

Package contents

You wireless microphone comes with:

• Headset

•Transmitter

•Audiocable

• Receiver

• Volume adjustment tool

• Two AA batteries

• One 9 V battery

•Userguide

You wireless microphone features:

• High-frequency and mid-frequency narrow band filters to

reduce interference from stray signals

• Built-in headset antenna

• Quartz crystal oscillating circuits that insures a steady

frequency

• Audio compression and expansion technology that provide

rich sound at low volume

DX-M1113.fm Page 3 Tuesday, September 19, 2006 7:07 AM

4Wireless microphone components

Receiver

Component Description

1 Antenna Receives RF signals from the transmitter. Fully extend the

antenna for the best reception.

2 RF indicator Lights when receiving RF signals from the transmitter.

3 OFF ON Turns the receiver on and off.

4 POWER indicator Lights when the receiver is turned on.

5 AUDIO OUT jack Connect an external amplifier to this jack.

6Battery

compartment Insert two AA batteries into this compartment.

POWEROF N

DX-M1113.fm Page 4 Tuesday, September 19, 2006 7:07 AM

Wireless microphone components 5

Transmitter

Volume adjustment tool

Component Description

1 Power switch Turns the transmitter on and off.

2 Power indicator Lights when the transmitter is turned on.

3 Volume control Turn the volume control with the volume adjustment tool

to adjust the volume if you experience signal interference

from other devices.

4 AF input Plug theheadset into this jack.

DX-M1113.fm Page 5 Tuesday, September 19, 2006 7:07 AM

6Setting up your wireless microphone

Setting up your wireless

microphone

The following illustration shows two basic ways to connect your receiver

to an amplifier.

Note: When you install the receiver, make sure that it is at

least 10 feet (3 meters) off the floor and at least 10 feet (3

meters) away from surrounding walls.

To set up the receiver:

1Place the receiver on a flat, stable surface.

2Fully extend the antenna, and makesure it is perpendicular

to the receiver.

3Open thebattery compartment, install two AA batteries

into the battery compartment, then close the

compartment. Makesure that the + and – symbols on the

batteries align with the + and – symbols inside the battery

compartment.

4Plug one end of the audio cable into the AUDIO OUT jack on

the receiver.

Audio mixer

Receiver

Amplifier

Speaker

Karaoke amplifier

Speaker

DX-M1113.fm Page 6 Tuesday, September 19, 2006 7:07 AM

Using your wireless microphone 7

5Plug the other end of the audio cable into the MIX IN or

AUX IN on an external amplifier.

6Slide the power switch to the ON position. The POWER

indicator lights.

To install the transmitter battery:

1Slide the battery compartment cover to open the battery

compartment.

2Insert the 9 V battery into the battery compartment. Make

sure that the + and – symbols on the battery align with

the + and – symbols inside the battery compartment.

3Slide the cover to close the compartment.

Using your wireless microphone

Note: You can use your wireless microphone within a range of

164 feet (50 meters) of the receiver. The ideal range is 82 feet

(25 meters).

To use your wireless microphone:

1Turn on the receiver.

2Plug the headset into the AF input jack on the transmitter.

3Place the headset on your head.

4Turn on the transmitter.

5If you experience interference from nearby devices, use the

volume adjustment tool to adjust the volume.

DX-M1113.fm Page 7 Tuesday, September 19, 2006 7:07 AM

8Troubleshooting

Troubleshooting

Caution: Do not open the open the receiver or transmitter

cases. There are no user serviceable parts inside.

Symptom Possible solution

Receiver is turned on, but POWER

indicator does not light. • Make sure that the batteries are installed

correctly. You must match the + and –

symbols on the batteries with the + and –

symbols in the battery compartment.

• Make sure that the batteries have a charge.

Change the batteries, if necessary.

The RF indicator lights when

speaking into the headset, but

there is no sound.

• Make sure that the volume control is not

set too low.

• Make sure that the audio cable is

connected securely to the receiver and

amplifier.

The signal range is too small. • Make sure that the antenna is fully

extended.

• Make sure that the batteries are installed

correctly. You must match the + and –

symbols on the batteries with the + and –

symbols in the battery compartment.

• Make sure that the batteries have a charge.

Change the batteries, if necessary.

• Make sure that the receiver or transmitter

are not located within a magnetic field.

DX-M1113.fm Page 8 Tuesday, September 19, 2006 7:07 AM

Specifications 9

Specifications

Transmitter

Sound quality is poor. • Make sure that the batteries are installed

correctly. You must match the + and –

symbols on the batteries with the + and –

symbols in the battery compartment.

• Make sure that the batteries have a charge.

Change the batteries, if necessary.

• Make sure that no other devices in the area

are operating on the same frequency as

your wireless microphone. Devices using

the same frequency should be at least 328

feet (100 meters) apart.

Carrier Frequency VHF 170 to 270 MHz

Frequency stability < ± 30 PPM

Frequency response 50 Hz to 15 KHz ± 3 dB

Dynamic range > 90 dB

Total harmonic distortion < 0.5%

Audio output level Separate type: 0 to ± 400 mV

Mix type: 0 to ± 200 mV

RF power output 30 mW

Current loss 60 mA

Range 164 ft. (50 m) (max.)

Pickup Dynamic or condenser

Battery 9 V

Symptom Possible solution

DX-M1113.fm Page 9 Tuesday, September 19, 2006 7:07 AM

10 Specifications

Receiver

Transmitter power 8.5 mW

Modulation type FM

Maximum deviation ± 25 KHz

Spurious emission > 40 dB (with carrier)

Battery life 6 to 8 hours

Sensitivity 6 uV @ sinad=12 dB

Spurious rejection ≥85 dB (typical)

Image rejection > 75 dB (typical)

SNR > 90 dB

AF output 0 to 300 mV

Receiving channel 1 channel

Power DC 3 V

Power consumption 170 mW

De-emphasis 50 uS

Border on channel rejection >80dB

DX-M1113.fm Page 10 Tuesday, September 19, 2006 7:07 AM

Andere Handbücher für DX-M1113 - Hands-Free Wireless Microphone

Inhaltsverzeichnis

Sprachen:

Andere Dynex Mikrofon Handbücher

Dynex

Dynex DX-USBMIC13 Installations- und Betriebshandbuch

Dynex

Dynex DX-USBMIC Kurzanleitung

Dynex

Dynex DX-54 Bedienungsanleitung

Dynex

Dynex DX-M1113 - Hands-Free Wireless Microphone Bedienungsanleitung

Dynex

Dynex DX-USBMIC13 Bedienungsanleitung

Dynex

Dynex DX-M1114 Bedienungsanleitung

Dynex

Dynex DX-USBMIC Kurzanleitung

Dynex

Dynex DX-USBMIC13 Stücklistenhandbuch

Dynex

Dynex DX-USBMIC Bedienungsanleitung

Dynex

Dynex DX-M1114 Bedienungsanleitung

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung