EasyPro EPL20 Bedienungs- und Wartungshandbuch
Thank you for purchasing the EasyPro submersible pond
light. With this pond light you can make your fountain glow,
illuminate your pond from within, highlight your waterfall
and extend the enjoyment of your water feature in the eve-
ning hours. This light is full submersible and carries a three
year limited warranty. You can also change the bulb to a
different wattage if you need more illumination, by simply
changing the bulb. Replacement bulbs are available. The
EPL20 lights can be purchased individually or as a kit with
one or two lights and a transformer.
Safety and Electrical Connections:
1. Always disconnect the electrical supply before
handling, maintaining, repairing or installing any
pond equipment.
2. Light(s) must be attached to a 12 volt UL listed trans-
former.
3. Never hook the lights directly to a 110 volt or higher
outlet.
4. Connect the transformer only to a 110 volt receptacle that is protected by a Ground
Fault Circuit Interrupter.
5. Do not use this product in bathrooms or swimming pools.
6. All electrical work must be performed by a qualied technician. Always follow the National
Electrical Code (NEC) or the Canadian Electrical Code as well as all local, state and provincial
codes. Code questions should be directed to your local electrical inspector. Failure to follow
electrical codes and OSHA safety standards may result in personal injury or equipment dam-
age. Failure to follow manufacturer’s installation instructions may result in electrical shock, re
hazard, personal injury or death, damaged equipment, provide unsatisfactory performance and
may void manufacturer’s warranty.
EPL20 • EPLK1 • EPLK2 • RL20
20 Watt, 12 Volt, Submersible
Underwater Lights
Instructions for Operation • Safety • Warranty
1
Installation for EPL20 Lights:
1. Before installing the product make sure
to check in the box for damaged or miss-
ing parts. Contact EasyPro immediately if
pieces are missing or damaged.
2. Be sure the power is disconnected before
installing the lights.
3. Connect the light xture to its base by un-
threading the nut on the back of the light.
Slide the “C” shaped bracket onto the
back of the light and tighten nut.
4. Place the light in the desired location of
your water feature.
5. The submersible lights must be covered
with water at all times. Do not allow the water level to drop below the lights, as this can cause
the lens to crack and the bulbs to burn up due to excess heat.
6. To adjust the light angle, use a phillips screwdriver and a pair of pliers to tighten the screw un-
der the “C” bracket.
7. When installing the wires to the transformer, match up the corresponding color wires of each
light and connect the like colors to the transformer.
8. Run the cable back to the transformer.
9. Install transformer on a timer and enjoy.
10. Recommended 12 volt transformer for use with multiple lights is the EPT100/100 watt or larger.
Installation for RL20 Lights:
1. Before installing the product make sure to check
in the box for damaged or missing parts. Contact
EasyPro immediately if pieces are missing or dam-
aged.
2. Be sure the power is disconnected before install-
ing the lights.
3. Place the light in the desired location of your water
feature.
4. The submersible lights must be covered with
water at all times. Do not allow the water level to
drop below the lights, as this will cause the lenses
to crack and the bulbs to burn up due to excess
heat.
5. Run the cable back to the transformer.
6. When installing the wires to the transformer, match
up the corresponding color wires of each light and
connect the like colors to the transformer.
7. Install transformer on a timer and enjoy.
10. Recommended 12 volt transformer for use with multiple lights is the EPT100/100 watt or larger.
2
Replacement light w/lens ..................EPL20
Rock Shell without light .....................RL20R
Color LED bulb ..................................LEDB
Colored lens (4 pack) .........................EPL20C
Clear lens ...........................................EPL20L
20 watt bulb (2007 and newer) ..........SLKB20
35 watt bulb .......................................SLKB35
50 watt bulb .......................................SLKB50
100 watt transformer .........................EPT100
Replacement Parts for Underwater Lights - EPL20 & RL20
Service and Maintenance of Submersible Lights
1. Disconnect the transformer from the power supply before service.
2. All parts of the lighting system should be checked on a regular basis to make sure the system is
functioning properly.
3. To replace a bulb, bring the light to the surface. Unscrew the black plastic cover and remove.
Remove the clear glass wafe lens. Be sure not to loose the o-ring under the lens. Gently pull
out on the outer portion of the light bulb reector from the light housing. Gently pull the bulb
straight out of the ceramic socket.
4. When installing the new light, do not touch the bulb with your ngers. Insert the new bulb
into the ceramic socket by grasping the bulb and pushing the two prongs into the socket.
Make sure to hold on to the new bulb by the edges.
5. Insert the ceramic socket and the new bulb back into the light housing.
6. Install the clear wafe lens and screw the black plastic cover back on, do not over tighten.
7. When installing the colored lens, remove the lens from the package and push the three tabs
into the three pockets on the black plastic cover.
8. To remove or change colored lens, simply pull straight up gently on the colored lens.
3
Warranty:
This product is warrantied against any mechanical or material defects for a period of three years from
the date of purchase (bulbs are a wear item and are not covered by warranty). Warranty only covers
properly installed and maintained units.
The warranty does not cover normal wear and tear, nor any deterioration suffered through overloading,
improper use, negligence or accident. Similarly, any modication made by the purchaser to the prod-
uct will cause the warranty to be null and void.
All returned items will be inspected to determine cause of failure before warranty is approved.
Warranty does not cover any cost associated with the installation or removal of the product subject to
warranty claim.
An RA number must be obtained by calling EasyPro Pond Products at 800-448-3873. It is your re-
sponsibility to pay the return shipping charges. Be sure to include the RA number, original receipt (in
the form of an invoice or sales receipt), name, return address and phone number inside of the pack-
age. No warranty claims will be honored without the original receipt.
Ensure the product is properly packaged and insured for the replacement value. Damage due to im-
proper packaging is the responsibility of the sender.
The manufacturer or supplier shall not be held liable for any damages caused by defective compo-
nents or materials of this product; or for loss incurred because of the interruption of service; or any
consequential/incidental damages and expenses arising from the production, sale, use or misuse of
this product.
The manufacturer or supplier shall not be held liable for any loss of sh, plants or any other livestock
as a result of any failure or defect of this product.
800-448-3873 • Grant, Michigan
www.EasyProPondProducts.com • info@EasyProPondProducts.com
10-08
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere EasyPro Unterwasserbeleuchtung Handbücher
EasyPro
EasyPro LED2K Gebrauchs- und Pflegehandbuch
EasyPro
EasyPro LED11WW Bedienungs- und Wartungshandbuch
EasyPro
EasyPro SFL10 Bedienungs- und Wartungshandbuch
EasyPro
EasyPro LED6WP Gebrauchs- und Pflegehandbuch
EasyPro
EasyPro LED6WS Bedienungs- und Wartungshandbuch
EasyPro
EasyPro SOL1 Bedienungsanleitung
EasyPro
EasyPro BFL9 Gebrauchs- und Pflegehandbuch
EasyPro
EasyPro LED9WWK Bedienungs- und Wartungshandbuch
EasyPro
EasyPro LED4WW Gebrauchs- und Pflegehandbuch
EasyPro
EasyPro LED9WW Gebrauchs- und Pflegehandbuch
Beliebte Unterwasserbeleuchtung Handbücher anderer Marken
Keldan
Keldan VIDEO 18X 25000lm CRI82 Bedienungsanleitung
Oase
Oase ProfiLux Garden LED RGB Bedienungsanleitung
Oceanled
Oceanled DISCOVER D3 Bedienungsanleitung
NORBIT
NORBIT AQUA FCL600 Bedienungsanleitung
Keldan
Keldan VIDEO 8XR Ambient 18000lm Bedienungsanleitung
Ikelite
Ikelite PCm - LED Light Bedienungsanleitung
