Eaton VORAD Always Alert Versionshinweis
For the most current information, visit www.vorad.com.
Driver Instructions VODR-0035 February 2005
Eaton VORAD Always Alert
Eaton
Eaton VORAD BlindSpotter
VORAD SmartCruise
VORAD = Vehicle Onboard RADar
Warnings and Cautions
Warnings and Cautions
Read the entire Driver Instruction Manual before operating a vehicle with
the VORAD system. Pay particular attention to the safety messages below.
Limitations of Collision Warning Systems
The Eaton VORAD system is intended solely as an aid for an alert and consci-
entious driver. The system should be used in conjunction with side-view mir-
rors and other instrumentation to maintain safe operation. A vehicle equipped
with the VORAD system should be operated in the same safe manner as if the
VORAD system were not installed. The system is not a substitute for normal
safe driving procedures.
The Eaton VORAD system may provide little or no warning for some hazards,
such as pedestrians, animals, oncoming vehicles, and cross traffic.
The system will not sense objects if the sensor view is obstructed. There-
fore, do not place objects in front of the system sensors. Remove heavy
buildups of mud, dirt, ice, and other materials.
Proper radar antenna alignment is critical to correct operation of the sys-
tem.
WARNING
WARNING
Table of Contents
Safety Information ................................................................................. i
Product Overview.................................................................................. 1
System Features.................................................................................... 2
Components.......................................................................................... 3
Control and Indicator Overview............................................................. 4
System Tracking ................................................................................. 11
In Case of an Accident......................................................................... 14
Maintenance / Diagnostic.................................................................... 15
Federal Communications Commission
This device is sold under a waiver of FCC (Federal Communications Commis-
sion) rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must be able to
accept any interference received, including interference that may cause
undesired operation. Any interference that may be caused should be reported
to the local FCC field office or to the Federal Communications Commission;
Field Operation Bureau; 1919 M Street, N.W.; Room 73, Mail Stop 1500;
Washington, D.C. 20554-0001.
Any changes or modifications made by the user to this equipment that are not
expressly approved by Eaton Corporation could void the user’s authority to
operate the equipment.
Every effort has been made to ensure the accuracy of all information in this
brochure. However, Eaton Corporation makes no expressed or implied war-
ranty or representation based on the enclosed information. Errors or omission
should be reported to: Technical Services, Eaton Corporation, 13100 E. Michi-
gan Ave., Galesburg, MI 49053, 1-886-RV-VORAD (788-6723).
1
Overview
Product Overview
The Eaton VORAD system is a sophisticated, computerized device that uses
forward-looking radar and optional side-looking radar to constantly monitor
vehicles ahead and in the blind spot area, respectively.
Always Alert
The radar signals determine the distance and relative speed between the vehi-
cle and objects in front. This information is used to warn the driver of poten-
tially dangerous situations through visual and audible alerts. The system can
perform in adverse conditions, but objects must be within the field of view of
the radar beam and must provide a surface that can reflect the radar beam
back for detection.
BlindSpotter
The optional Side Sensor is a radar transmitter and receiver mounted on the
side of the vehicle to detect objects from one (1) to twelve (12) feet from the
side of the vehicle. The Side Sensor can detect vehicles or objects unseen by
the driver, moving or stationary, provided the vehicle or object is in the radar
coverage area adjacent to the vehicle.
SmartCruise
The VORAD system also has the ability to operate in a mode called “Smart-
Cruise”. SmartCruise is an optional feature offered as a convenience to the
driver in conjunction with the standard vehicle cruise control. The Smart-
Cruise feature automatically maintains a preset following distance to traffic
ahead.
SmartCruise cannot replace a driver and will not be able to ensure safe fol-
lowing distances under all road conditions. The driver must stay alert at all
times and use the vehicle brakes when required to avoid an accident.
WARNING
2
Features
System Features
Always Alert
• Collision Warning - Audible and visual warnings when the potential
for a collision is detected even in rain, snow, fog, smoke, sun glare,
or total darkness.
• Tail Gating - Audible alerts when within one half (1/2) second of
another vehicle.
• Slow Moving Vehicle - Audible and visual alerts issued.
• Fog Mode - Visual display indicating when objects are detected
within 500 feet in front of the vehicle.
• Distance and Sensitivity Control - Sets forward object detection dis-
tance.
• Proximity Alerts - Audible and visual alerts issued below 5 mph.
• Display Intensity Adjustment - Display light intensity adjusts accord-
ing to light conditions.
• Object Tracking - Simultaneously tracks up to 20 moving or station-
ary objects within its range.
• Accident Reconstruction - Stores vehicle accident data.
• System Problems - Notifies the driver when a failure is indicated.
• Self-Troubleshooting - Onboard fault codes.
BlindSpotter
• Lane Change Assistance - Reduces lane change and merge colli-
sions.
• Visual Display - Display inside vehicle visually indicates whether an
object is in the detection area.
• Audible Alert - Sounds when turn indicator is activated indicating an
object is in the detection area.
SmartCruise
• Following Speed - Electronically communicates with electronic diesel
engines to match following speed with traffic flow.
• Following Interval Control - Sets the desired following distance.
• Engine Retarder - Engages automatically when engine braking is
required to maintain safe following distances.
• Set Speed - Returns to set speed automatically when traffic clears.
3
Component Description
Components
The Eaton VORAD system is comprised of four main components: the
Antenna Assembly, Central Processing Unit, Driver Display, and the Intercon-
necting Harness. The Side Sensor(s) and the Side Sensor Display(s), are
optional components. Each of the components are shown in their approximate
location on a vehicle (see Figure 1 below).
Note: Additional side sensors may be added to the vehicle to provide
enhanced detection zones.
Figure 1
Central Processing UnitDriver Display
Side Sensor Display Side Sensor
Antenna Assembly
P2
P2
4
Indicator Overview
Control and Indicator Overview
All controls for the VORAD system are located on the Driver Display.
Figure 2
Item Description
Volume Control
and Power On/
Off
Power can be turned on or off by pushing in the control knob.
Volume level can be adjusted by rotating the control knob.
Activates “Failure Display Mode” when the knob is pressed in
and held for five (5) seconds and then released. (See Figure 2)
Range Control
and Accident
Recorder
The control knob provides distance adjustment of the Always
Alert warnings. When SmartCruise is active, rotation of the
knob will also change the following interval from 3 to 2 sec-
onds. Accident data is stored by pushing and holding this
knob for 5 seconds thereby freezing the most recent event
data in half of the allocated memory.
Red,
System Fault
Illuminates when a problem has been detected in the
forward-looking radar system. A pattern of flashes blink
out the faults that are stored in memory when activated
by holding in the volume control knob for five seconds.
(See page 15.)
Green,
SmartCruise
Green light comes on when SmartCruise is actively controlling
the vehicle speed.
FAIL
ON S/C
Warning Level Range
Volume
Green, SmartCruise
Light Sensor
Red
Orange
Yellow
Red, System
Failure
Green,
Power ON
Volume Control
Power ON/OFF
Speaker
Range Control/
Accident Recorder
EATON VORAD
5
Always Alert
Always Alert
• Warnings are received only on a vehicle in your lane.
• Range is reduced on curved roads.
• Warnings are disabled in sharp turns.
As you approach a slower vehicle ahead:
• If within 350 ft. to the vehicle and immediate braking is required to
avoid a collision, all three lights will illuminate and a continuous
warning tone will sound until the danger no longer exists.
• At approximately 3 seconds to the vehicle ahead, the yellow indicator
lights.
• At approximately 2 seconds to the vehicle ahead, the orange indica-
tor lights.
• At approximately 1 second to the vehicle ahead, the red indicator
lights.
• Less than 1 second to the vehicle ahead, the continuous double beep
indicates a tail gating situation.
Proximity Alert
If your vehicle rolls very slowly toward any stationary object, the yellow indi-
cator lights and a warning double beep sounds.
Stationary Object
If a stopped vehicle is within 220 feet, a warning tone sounds and all three
lights illuminate when less than 3 seconds away.
Fog Mode
Rotating the range knob to the full clockwise position will place the Always
Alert system into Fog Mode. The yellow light will illuminate and track vehicles
up to 500 feet ahead. In poor visibility conditions, this can provide the driver
with additional warning time.
6
BlindSpotter
BlindSpotter
Figure 3
Light/Tones Description
Red/Triple Tone Indicator light illuminates after objects have been
detected by the Side Sensor(s). When the turn signal is
activated and the Side Sensor detects an object, a single
warning tone will be issue.
Yellow Power indicator light stays on when no objects are
detected by the Side Sensor(s).
Red and Yellow Indicates the Side Sensor is performing a start-up self-
test or there is a failure in the Side Sensor system.
Yellow,
No Object Detected
Indicator Light
Red,
Object Detected
Indicator Light
Light Sensor
EATON VORAD
7
SmartCruise
SmartCruise
SmartCruise is an optional enhancement to the Eaton VORAD system. Smart-
Cruise will maintain a selected following interval between the host vehicle and
the vehicle ahead. SmartCruise is activated whenever the vehicle’s standard
cruise control system is activated, the system is turned on, and a vehicle is
detected within 3 seconds ahead in the lane of travel of the host vehicle. When
SmartCruise begins to actively adjust the host vehicle speed, the green “S/C”
(SmartCruise) light on the Driver Display will illuminate.
SmartCruise will not react to stationary objects and it does not have the
capability to bring the vehicle to a stop.
SmartCruise may operate the engine brake without warning. Do not operate
this feature in slippery or wet conditions where sudden braking could cause
loss of control.
Note the warning below in your vehicle. It is there to remind you of the safe
use of SmartCruise.
WARNING
WARNING
!
Vehicle is equipped with an Eaton VORAD SmartCruise system which operates
when Cruise Control is on.
Improper use of SmartCruise can lead to a serious accident.
Do not use SmartCruise in:
* slippery conditions (wet, snow, ice, mud) or fog.
* stop-and-go traffic.
* winding roads.
* any situation where your vehicle manual advises against using Cruise Control.
SmartCruise does not replace an alert driver!
R
R
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Beliebte Radar Handbücher anderer Marken
SAW D2L
SAW D2L Valentine One Gen2 Bedienungsanleitung
Raymarine
Raymarine Raytheon R20X Bedienungsanleitung
Simrad
Simrad CA34 Bedienungsanleitung
Endress+Hauser
Endress+Hauser Micropilot FMR67B Technische Daten
Endress+Hauser
Endress+Hauser Levelflex M FMP45 Bedienungsanleitung
ECHOMAX
ECHOMAX Active-X-Band Bedienungsanleitung
