Pairing the Camera
RVC-W1/RVC-W2
Wireless Camera & Receiver Kit
RVC-W1/RVC-W2
Wireless Camera & Receiver Kit
Introduction
Box Contents
uCamera (with built in TX)
uCamera Power Cable
u2 x Red Male Spades
u2 x Antenna Caps
Thank you for purchasing your EchoMaster Wireless Camera & Receiver.
This EchoMaster camera with receiver is designed to improve safety during
driving by providing high quality images of surrounding areas and obstacles in
the vicinity of the vehicle.
Please ensure you read and understand all aspects of this manual before
tting or using your EchoMaster camera. Choose a suitable mounting place
dependant on the application. Ensure that there are no wiring harnesses or
hoses/pipes located behind this panel before drilling.
uHole Saw
uReceiver (RX)
u2 x Red T-tap
u2 x 10mm screws
RVC-W1
uCamera (with built in TX)
uCamera Power Cable
uPower & Video Cable
(Length 150mm)
uReceiver Extension Cable
(Length 3657mm)
u2 x 10mm screws
u3 x Cable Ties
uDouble Sided Tape
uUser Manual
RVC-W2
u3 x Cable Ties
uDouble Sided Tape
uUser Manual
1. The Camera & Receiver are automatically paired. There is no need to pair
again unless you need to replace the receiver module or camera
2. The pairing code is needed in the event of losing connection due
to weak signal strength, but it this is rare.
How to pair:
When the message “Please press pair key on tx side” appears on the receiver (RX
screen) Press and hold the receiver (RX) Pair Code key for 1-3 seconds.
Within 30 seconds Press and Hold the transmitter (TX) Pair Code Button for
1-3 seconds. Pairing will then start.
Once pairing is complete ‘PAIR OK’ will appear on the receiver (RX screen)
Wiring Diagram & Pin-Out
Camera wiring
Red (Power) – Locate the +Parking Lamp wire in the vehicle/trailer. Connect this
wire to the camera red power cable
Black (Ground) – Locate a suitable location to ground (negative) the Black wire in
the wiring harness. You may connect this wire to a factory ground point in the vehicle,
or attach a ring terminal to the black wire and screw into the body of the vehicle/trailer.
If you choose to screw into the body, clean the area of any paint or adhesives to allow
for good metal-to-metal contact.
Wire connections are illustrated in the 2 diagrams on the next page.
u2 x Red Male Spades
u2 x Antenna Caps
uHole Saw
uReceiver (RX)
u2 x Red T-tap
