Edge-Core EAP101 Bedienungsanleitung

User Manual

www.edge-core.com

Wi-Fi 6 Access Point

Software Release 12.4.3

User Manual

Wi-Fi 6 Access Point

Cloud-Enabled Enterprise Access Points

EAP101

EAP102

EAP104

EAP104 (WL)

OAP101

OAP101-6E

E102023-CS-R12

– 3 –

How to Use This Guide

This guide includes detailed information on Edgecore access point (AP) software,

including how to operate and use the management functions of APs. To deploy APs

effectively and ensure trouble-free operation, you should first read the relevant

sections in this guide so that you are familiar with all software features.

Who Should Read

This Guide?

This guide is for network administrators who are responsible for operating and

maintaining network equipment. The guide assumes a basic working knowledge of

LANs (Local Area Networks) and the Internet Protocol (IP).

How This Guide

is Organized

The organization of this guide is based on the AP’s web management interface. An

introduction and initial configuration information is also provided.

The guide includes these sections:

Section I “Getting Started” — Includes an introduction to AP management and

initial configuration settings.

Section II “Web Configuration” — Includes all management options available

through the web interface.

Section III “Appendices” — Includes information on troubleshooting AP

management access.

Documentation

This guide focuses on AP software configuration, it does not cover hardware

installation of an AP. For specific information on how to install an AP, see the

following guide:

Quick Start Guide

For all safety information and regulatory statements, see the following documents:

Quick Start Guide

How to Use This Guide

– 4 –

Conventions The following conventions are used throughout this guide to show information:

Note:

Emphasizes important information or calls your attention to related features

or instructions.

Caution:

Alerts you to a potential hazard that could cause loss of data, or

damage the system or equipment.

Revision History This section summarizes the changes in each revision of this guide.

September 2023 Revision

This is the 12th revision of this guide. It is valid for software release v12.4.3 and

includes the following changes:

Added support for OAP101 and OAP101-6E

Added support for 6 GHz band

Added SSID isolation, see “Physical Radio Settings” on page 64

Multiple PSK enhancement, see “Wireless Networks — Security Settings” on

page 69

July 2023 Revision

This is the 11th revision of this guide. It is valid for software release v12.4.1 and

includes the following changes:

Added OpenRoaming, see “OpenRoaming” on page 57 and “Wireless

Networks — OpenRoaming” on page 76

Modified broadcast rate, see “Physical Radio Settings” on page 64

Access Control List enhancement, see “Wireless Networks — Security Settings”

on page 69

Hostname enhancement, see “System Settings” on page 81

Moved the language setting to the System page, see “System Settings” on

page 81

Firmware upgrade enhancement, see “Upgrading Firmware” on page 85

Account username enhancement, see “User Accounts” on page 87

How to Use This Guide

– 5 –

May 2023 Revision

This is the 10th revision of this guide. It is valid for software release v12.4.0 and

includes the following changes:

Added WAN port auto-detection to QR code Onboarding, see “QR Code

Onboarding” on page 26

Added automatic mesh AP configuration, see “Mesh AP Configuration” on

page 29

Removed Mark and Notrack from firewall rules, see “Firewall Rules” on

page 50

Modified Minimum Signal Allowed, see “Physical Radio Settings” on page 64

Added RF Isolation, see “Physical Radio Settings” on page 64

Modified Dynamic VLAN, see “Wireless Networks — Network Settings” on

page 74

Modified HotSpot 2.0 settings, see “Wireless Networks — Network Settings” on

page 74

Added Log Level, see “System Settings” on page 81

Added SNMPv3 User, see “SNMP” on page 92

Modified Diagnostics and added Speed Test, see “Diagnostics” on page 95

January 2023 Revision

This is the ninth revision of this guide. It is valid for software release v12.3.0 and

includes the following changes:

Updated QR code Onboarding, see “QR Code Onboarding” on page 26

Updated wireless status, see “Wireless Status” on page 37

Added support for dynamic PSK, see “Wireless Networks — Security Settings”

on page 69

Updated Hotspot 2.0 settings, see “Wireless Networks — Network Settings” on

page 74

Added CAPWAP Tunnel Interface to Ethernet Settings, see “Ethernet Settings”

on page 45

November 2022 Revision

This is the eighth revision of this guide. It is valid for software release v12.2.0 and

includes the following changes:

How to Use This Guide

– 6 –

Added Airtime Fairness, see “Physical Radio Settings” on page 64

Modified the value range of BSS Coloring, see “Physical Radio Settings” on

page 64

Modified wireless security default, see “Wireless Networks — Security Settings”

on page 69

Added 802.11v, see “Wireless Networks — Security Settings” on page 69

Added SNMP Trap, see “SNMP” on page 92

Added BLE Scan, see “BLE” on page 94

November 2022 Revision

This is the seventh revision of this guide. It is valid for software release v12.1.0 and

includes the following changes:

Updated SNMP read/write community settings, see “SNMP” on page 92

Added BLE radio Tx Power, see “BLE” on page 94

Added Interference Detection, see “Physical Radio Settings” on page 64

Added zero-touch provisioning information, see “Zero-Touch Provisioning” on

page 19

Modified the default value for Minimum Signal Allowed, see “Physical Radio

Settings” on page 64

Added 160MHz channel bandwidth option, see “Physical Radio Settings” on

page 64

Removed uCentral cloud option from the Setup Wizard.

July 2022 Revision

This is the sixth revision of this guide. It is valid for software release v12.0.0 and

includes the following changes:

Updated Setup Wizard for uCentral cloud, see “AP Setup Wizard” on page 21

Added Proxy ARP, see “Wireless Networks — Network Settings” on page 74

Added Multicast-to-Unicast Conversion, see “Wireless Networks — General

Settings” on page 68

Added Bandsteering, see “Physical Radio Settings” on page 64

How to Use This Guide

– 7 –

Added WPA3 Enterprise 192-bit and OWE security, see “Wireless Networks —

Security Settings” on page 69

Added multiple PSK keys, see “Wireless Networks — Security Settings” on

page 69

Added Short Guard Interval (SGI), see “Wireless Networks — Advanced Radio

Settings” on page 77

Added Multicast/Broadcast Rate, see “Physical Radio Settings” on page 64

Added UPnP, see “LAN Settings” on page 48

Added DHCP Snooping, see “DHCP Snooping” on page 59

Added ARP Inspection, see “ARP Inspection” on page 60

Added DHCP Relay, see “DHCP Relay” on page 61

Added IPv6 for Internet access, see “IPv6 Settings” on page 45

Added Hotspot 2.0, see “Wireless Networks — Network Settings” on page 74

Added Device Discovery Tool, see “Device Discovery” on page 96

Added Discovery Agent settings, see “Edgecore Networks Discovery Tool” on

page 88

Added Reset button and LED enable, see “System Settings” on page 81

Added PoE Out setting, see “Ethernet Settings” on page 45

Added caution on firmware upgrades in uCentral mode, see “Upgrading

Firmware” on page 85

April 2022 Revision

This is the fifth revision of this guide. It is valid for software release v11.6.0 and

includes the following changes:

Added Client mode, see “Physical Radio Settings” on page 64

Added Site Survey, see “Wireless Networks — General Settings” on page 68

Added Custom LAN, see “LAN Settings” on page 48

Added WME configuration, see “Physical Radio Settings” on page 64

Added BSS Coloring, see “Physical Radio Settings” on page 64

Added OFDMA, see “Physical Radio Settings” on page 64

How to Use This Guide

– 8 –

Added Target Wake Time, see “Physical Radio Settings” on page 64

Added HTTPS captive portal, see “Captive Portal Settings” on page 55

Added HTTPS certificate upload, see “Upload Certificate” on page 86

December 2021 Revision

This is the fourth revision of this guide. It is valid for software release v11.4.0 and

includes the following changes:

Updated QR code onboarding, see “QR Code Onboarding” on page 26

Added mesh traffic graph to the dashboard, see “Traffic Graphs” on page 39

Added MSP mode, see “System Settings” on page 81

November 2021 Revision

This is the third revision of this guide. It is valid for software release v11.3.1 and

includes the following changes:

Updated the Setup Wizard, see “AP Setup Wizard” on page 21

Updated the Dashboard, see “Status Information” on page 32

Added Smart Isolation, see “LAN Settings” on page 48

Added Hotspot Settings, see “Hotspot Settings” on page 52

Updated wireless network settings, see “Wireless Networks — Network

Settings” on page 74

Updated wireless open mesh settings, see “Wireless Networks — Open Mesh

Settings” on page 76

Added Telnet settings, see “Telnet” on page 88

Added web server settings, see “Web Server” on page 89

Added multicast DNS, see “Multicast DNS” on page 93

Added firewall settings, see “Firewall Rules” on page 50

Added a guest network, see “LAN Settings” on page 48

July 2021 Revision

This is the second revision of this guide. It is valid for software release v11.2.0 and

includes the following changes:

How to Use This Guide

– 9 –

Added WPA3-Personal transition, WPA3-Enterprise, and WPA3-Enterprise

transition. See “Wireless Networks — Security Settings” on page 69

Support for IEEE 802.11 k/r, see “Wireless Networks — Security Settings” on

page 69

Added Minimum signal allowed (RSSI Threshold), see “Physical Radio Settings”

on page 64

Support for Open Mesh, see “Wireless Networks — Open Mesh Settings” on

page 76

SNMP v2 support, see “SNMP” on page 92

Support for remote Syslog, see “Remote System Log Setup” on page 90

Support for LLDP, see “LLDP” on page 93

Support for management by an EWS-Series Controller, see “System Settings”

on page 81

April 2021 Revision

This is the first revision of this guide. It is valid for software release v11.1.1.

– 10 –

Contents

How to Use This Guide 3

Contents 10

Figures 13

Tables 16

Section I Getting Started 17

1 Introduction 18

Configuration Options 19

Zero-Touch Provisioning 19

Connecting to the Web Interface 20

LAN Port Connection 20

AP Setup Wizard 21

QR Code Onboarding 26

Mesh AP Configuration 29

Main Menu 29

Dashboard 30

Common Web Page Buttons 30

Section II Web Configuration 31

2 Status Information 32

General Status 33

Network Status 35

Wireless Status 37

Traffic Graphs 39

Services 39

Andere Handbücher für EAP101

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Edge-Core Drahtloser Zugangspunkt Handbücher

Edge-Core

Edge-Core OAP6626A Bedienungsanleitung

Edge-Core

Edge-Core EAP101 Bedienungsanleitung

Edge-Core

Edge-Core MLTG-CN Bedienungsanleitung

Edge-Core

Edge-Core ECWO3320-L Bedienungsanleitung

Edge-Core

Edge-Core OAP101 Bedienungsanleitung

Edge-Core

Edge-Core ECW7210-L Bedienungsanleitung

Edge-Core

Edge-Core EAP102 Bedienungsanleitung

Edge-Core

Edge-Core EAP2316A Bedienungsanleitung

Edge-Core

Edge-Core ECWO4320 Bedienungsanleitung

Edge-Core

Edge-Core ECW5211-L Bedienungsanleitung

Edge-Core

Edge-Core ECWO3220 Programmierhandbuch

Edge-Core

Edge-Core EAP104 Bedienungsanleitung

Edge-Core

Edge-Core ECW7212-L Bedienungsanleitung

Edge-Core

Edge-Core ECWO7211-L Bedienungsanleitung

Edge-Core

Edge-Core ECWO5211-L Bedienungsanleitung

Edge-Core

Edge-Core ECW5410-L Bedienungsanleitung

Edge-Core

Edge-Core EAP102 Bedienungsanleitung

Edge-Core

Edge-Core OAP100e Bedienungsanleitung

Edge-Core

Edge-Core ECWO5110-L Bedienungsanleitung

Edge-Core

Edge-Core EAP8518 Bedienungsanleitung

Edge-Core

Edge-Core ECW7220-L Bedienungsanleitung

Edge-Core

Edge-Core EAP101 Bedienungsanleitung

Edge-Core

Edge-Core ECW7220-L Bedienungsanleitung

Edge-Core

Edge-Core ECW5320 Programmierhandbuch

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung