Ekwb EK-Momentum MSI Z390 MEG GODLIKE Bedienungsanleitung

All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Revision 1.0. Published on August 27th 2019

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no

liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates.

Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

1. Please carefully read the manual thoroughly before beginning with the installation process!

2. Please remove your motherboard from the computer to assure safest mounting process in order to prevent any possible damages to your CPU and/or motherboard’s circuit board (PCB).

3. The EK- Fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.

4. The use of quality, market proved corrosion inhibiting coolants is always strongly recommended for any liquid cooling system.

STEP 1: GENERAL INFORMATION Sample photo of motherboard:

BAG CONTENT: Bag content is universal for all water blocks, you may not need all screws.

STEP 1: PREPARING YOUR MOTHERBOARD

STEP 2: PREPARING YOUR MOTHERBOARD

REMOVING STOCK COOLER. Remove all (7) encircled screws. There are screws

on the back of the motherboard that need to be removed in order to remove the

factory installed MOSFET heat pipe cooling solution.

1. APPLYING THERMAL COMPOUND. Apply thermal compound on CPU heat

spreader (IHS) - see sample photo on right with enclosed EK-TIM Ectotherm

thermal grease.

The quantity of about two rice grains is just about right. There is no need to cover

the whole IHS. Applying too much thermal grease will have negative impact on the

cooling performance!

2.. CUTTING THERMAL PADS. Your block comes with thermal pads which needs to be trimmed in order to fit the voltage regulation area (MOSFET) on the

motherboard’s circuit board. WARNING: DIMENSIONS ON PICTURES BELOW ARE SCALED.

Replacement thermal pads @ EKWB web shop:

Thermal PAD F 1mm - (120x16mm) [EAN: 3830046996732]

Installation manual for EK-Momentum MSI Z390 MEG GODLIKE water block

1. Thermal pad F–1.0mm

(for mosfets and coils):

CPU SOCKET

MOSFETS

MSI Z390 MEG GODLIKE

CHIPSET HEATSINK

All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Revision 1.0. Published on August 27th 2019

3. PLACING THERMAL PADS ON MOTHERBOARD. Place thermal pads on PCB as shown on the picture below.

STEP 3: PLACING THE BLOCK ON TO MOTHERBOARD

Place the EK-Momentum Z390 MEG Godlike Monoblock series water block gently

to the motherboard or vice versa (as shown on photo below). Make sure that

mounting holes are aligned. There is no need for M2.5 adhesive PVC washer on

MSI Z390 MEG GODLIKE motherboard.

Plug the 3-pin connector from Water block’s D-RGB LED light to the D-RGB HEADER on

the motherboard. The LED will work if the pin layout on the header is as follows:

+5V digital, empty, Ground.

Please ensure that the arrow indicated on the connector is plugged into the

+5V line as indicated on your motherboard.

STEP 4: ATTACHING BLOCK ON TO THE MOTHERBOARD

Prior to fastening the screws please make sure the mounting holes on the

motherboard’s circuit board are aligned with the water block.

A) Mosfet part: Use four (4) M2,5x5 AX1 screws with M2.5(0.5mm) PVC

washers. Tighten the screws evenly. Do not use excessive force when tightening

the screws!

B) CPU part: Use four (4) M4x8 DIN7984 screws and M4(0.8mm) washers.

Tighten the screws using enclosed 2.5mm Allen key.

Use the enclosed screws and washers as shown in picture below:

For the EK-Momentum MSI Z390 MEG Godlike Monoblock series water block to operate

properly the G1/4 port nearest to the right edge of the water block MUST BE USED

AS THE INLET PORT. EK recommends the use of EK- Fittings. When using fittings

other than EK series please use hose clamps or appropriate substitute to secure the

tubing to the barb. The use of biocide containing and corrosion inhibiting coolant is

always recommended for any liquid cooling system.

REQUIRED TOOLS AND MOUNTING SCREWS:

Scissors Philips screwdriver Allen key

IMPORTANT: USE

THIS OPENING

AS AN INLET

PORT!

Plastic washer M4 0.8mm

M4X8 DIN7984 Screw

M2.5X5 AX1 Screw

PLEASE REMOVE THE

PROTECTIVE FOIL FROM BOTH

SIDES OF THE THERMAL PADS

PRIOR TO INSTALLATION!

Thermal Pad F.1.0mm

Dieses Handbuch passt für folgende Modelle

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FC R9-285 Handbuch

ekwb

ekwb EK-FC980 GTX Ti Strix Handbuch

ekwb

ekwb EK-FC1080 GTX FTW2 Bedienungsanleitung

ekwb

ekwb EK-FB KIT GA-X99 LE Leitfaden

ekwb

ekwb EK-FC460 GS/SONIC Handbuch

ekwb

ekwb EK-FB KIT ASUS R4BE Leitfaden

ekwb

ekwb EK-FC R9-290X Lightning Series Handbuch

ekwb

ekwb EK-FC980 GTX Ti XG Bedienungsanleitung

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Leitfaden

ekwb

ekwb EK-Classic AM4 D-RGB Bedienungsanleitung

ekwb

ekwb EK-PRO GPU WB RTX A4090 Bedienungsanleitung

ekwb

ekwb EK Series Bedienungsanleitung

ekwb

ekwb EK-FB ASUS CROSSHAIR 3 Handbuch

ekwb

ekwb EK-FC670 GTX DCII Leitfaden

ekwb

ekwb EK-MOSFET ASUS M6G Leitfaden

ekwb

ekwb EK-Quantum Kinetic FLT D5/DDC Body D-RGB Bedienungsanleitung

ekwb

ekwb EK-SBAY DDC Series Leitfaden

ekwb

ekwb EK-FC 5870 MSI Handbuch

ekwb

ekwb EK-FB MSI Z270 GAMING Monoblock Handbuch

ekwb

ekwb EK-FC780 GTX Ti Handbuch

ekwb

ekwb EK-Quantum Momentum Aorus Z490 Master D-RGB Bedienungsanleitung

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Bedienungsanleitung

ekwb

ekwb EK-SF3D Inflection Point EVO Bedienungsanleitung

ekwb

ekwb EK-Nucleus AIO CR360 Vision D-RGB Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-Momentum MSI Z390 MEG GODLIKE Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken