Ekwb EK-Vector Radeon VII Backplate Bedienungsanleitung

INSTALLATION MANUAL

EK-Vector Radeon VII Backplate

BACKPLATE

- 2 -

This product is intended for installation only by expert users. Please

consult with a qualiﬁed technician for installation. Improper installation

may result in damage to your equipment. EK Water Blocks assumes no

liability whatsoever, expressed or implied, for the use of these products,

nor their installation. The following instructions are subject to change

without notice. Please visit our web site at www.ekwb.com for updates.

Before installation of this product please read important notice,

disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic

guidelines:

Please carefully read the manual thoroughly before beginning

with the installation process!

Please remove your graphics card from the computer to assure

safest mounting process in order to prevent any possible

damages to your GPU and/or graphics card circuit board (PCB).

This product is anticipated to be used exclusively with EK-

Vector Radeon VII GPU blocks and has not been tested with

any factory or aftermarket heatsinks and water blocks. EK does

not provide any assistance or support in the latter application.

- 3 -

TABLE OF CONTENT

INSTALLING THE BACKPLATE 4

IMPORTANT DISCLOSURES 6

REQUIRED TOOLS 6

SUPPORT AND SERVICE 7

SOCIAL MEDIA 7

- 4 -

INSTALLING THE BACKPLATE

STEP 1

PREPARING YOUR GRAPHICS CARD

EK-Vector Radeon VII Backplate is very simple to install, ﬁrst complete

the installation of your EK-Vector Radeon VII Water Block according

to its installation manual. Using a Phillips head screwdriver remove

the 7 screws and their PVC washers which are marked below.

STEP 1

STEP 2

CUTTING THERMAL PADS

Your backplate is supplied with thermals pads that need to be cut into

smaller pieces in order to cover all VRM components. PLEASE REMOVE

THE PROTECTIVE STICKER FROM BOTH SIDES OF THE TERMINAL

PADS PRIOR TO INSTALLATION.

Replacement thermal pads:

1. Thermal PAD F 1.0mm - (120x16mm) - (EAN: 3830046996732)

2. Thermal PAD F 1.5mm - (120x16mm) - (EAN: 3830046996749)

STEP 2

- 5 -

STEP 3

PLACING THERMAL PADS

Once cut to size the thermal pads should be applied to the backplate as

illustrated below. EK made sure to provide customers with more than

adequate quantity of thermal pads to complete this step.

STEP 4

ATTACHING THE BACKPLATE

Place the backplate onto the PCB aligning all of the holes. Position an

M2.5x7 AX1 screw in each of the seven (7) mounting holes marked below

and then tighten them evenly using a Phillips head screwdriver. Do not use

excessive screwing force.

1+2

STEP 4

STEP 3

- 6 -

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE

Once the installation is completed, it is a recommended practice to

test the cooling circuit for leaks prior to powering up the computer.

We recommend a 24 hour leak test prior to powering up the

computer. Do not test the water block using city water pressure. This

will rupture the top of the housing and render the block unusable

(and will void your warranty). While all efforts have been made to

provide the most comprehensive tutorial possible, EK Water Blocks

assumes no liability expressed or implied for any consequential

damage(s) occurring to your equipment as a result of using EK Water

Blocks cooling products, either due to errors or omissions on our

part in the above instructions, or due to failure or defect in the EK

Water Blocks cooling products.

WARRANTY

Our products are warranted against defects in materials or

workmanship for a period of 24 months beginning from the date of

delivery to the ﬁnal user. During this period, products will be repaired

or have parts replaced at our discretion provided that: (I) the product

is returned to the agent from whom it was purchased; (II) the product

has been purchased by an end user and has not used for commercial

purposes; (III) the product has not been misused, handled carelessly,

or used in a manner other than in accordance with the instructions

provided describing its installation and proper use. This warranty does

not confer rights other than those expressly set out above and does

not cover any claims for consequential loss or damage. This warranty

is offered as an extra beneﬁt and does not affect your statutory rights

as a consumer. This warranty is voided if the product comes in contact

with aggressive UV additives or other improper liquids. EK blocks are

sealed with warranty void circular label, which proves that the block

has withstood a pressure leak test. Removing it will void leak-free

guarantee and not the guarantee on the product itself. Any other RMA

issues can be reported to EK Support at www.ekwb.com/support for

further analysis.

REQUIRED TOOLS

Phillips-head screwdriver Scissors

For assistance please contact:

http://support.ekwb.com/

EKWB d.o.o.

Pod lipami 18

1218 Komenda

Slovenia - EU

EKWaterBlocks

@EKWaterBlocks

ekwaterblocks

EKWBofﬁcial

SUPPORT AND SERVICE

SOCIAL MEDIA

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-Loop Bedienungsanleitung

ekwb

ekwb EK-FB ASR Z77 Extreme11 Leitfaden

ekwb

ekwb EK-FB ASUS PRIME X299 Monoblock Bedienungsanleitung

ekwb

ekwb Vector 2 FTW3 RTX 3080/90 ABP Bedienungsanleitung

ekwb

ekwb EK-FB GA X299 GAMING Monoblock Bedienungsanleitung

ekwb

ekwb EK-Momentum MSI Z390 MEG GODLIKE Bedienungsanleitung

ekwb

ekwb EK-FC R9-295X2 Handbuch

ekwb

ekwb EK-XRES DCP 2.2 Reservoir Handbuch

ekwb

ekwb EK-FC770 GTX GW Leitfaden

ekwb

ekwb Classic D-RGB S240 Bedienungsanleitung

ekwb

ekwb EK-PRO GPU WB RTX A100 80GB Bedienungsanleitung

ekwb

ekwb EK-FC980 GTX Ti Classy KPE Series Handbuch

ekwb

ekwb EK-FC 5870 MSI Handbuch

ekwb

ekwb EK-FC560 GTX Handbuch

ekwb

ekwb EK-Vector Strix RTX 2070 Backplate Leitfaden

ekwb

ekwb Supremacy EVO Bedienungsanleitung

ekwb

ekwb EK-FB ASUS R5-E10 Leitfaden

ekwb

ekwb EK-FC980 GTX Ti Strix Handbuch

ekwb

ekwb EK-FC Titan X Original CSQ Handbuch

ekwb

ekwb EK-PRO GPU WB RTX 30x0 Bedienungsanleitung

ekwb

ekwb EK-FB KIT RE4 Handbuch

ekwb

ekwb EK-Momentum ROG Strix Z390I RGB Bedienungsanleitung

ekwb

ekwb EK-Classic 115x/20xx D-RGB Bedienungsanleitung

ekwb

ekwb EK-FB ASRock X299 RGB Monoblock Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

ekwb EK-Vector Radeon VII Backplate Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken