Guidance
CLE-200
ELCOM-Türsprechanlagen
R
Hauskommunikation für Ihre Sicherheit
Zeichnungsnummer:
AN CLE-200
edition 04.04.2003
Code-Lock for mounting
Programming:
Note:
Switchcode 1:
The codes must be selected in such a way, that these are assigned clearly. (Not allowed: Code1=1234
Code2=123)
If no switchcode is programmed (code programming mode is terminated with the key former input
of a code) the switching contact may be activated by pushing of the key .
In order to activate the switch mode, the switch term =0 seconds has to be adjusted. By pushing of the key ,
the current procedure may be aborted.
- push and hold key , additionally key , pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key - .
- enter switchcode and push key -
without
audio signal sounds
audio signal sounds.
- push and hold key , additionally key , pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key - audio signal sounds.
- enter switchcode and push key - audio signal sounds.
- push and hold key , additionally key , pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key - audio signal sounds.
- enter switch trm in sec. (1-99 or 0) and push key - audio signal sounds.
- push and hold key , additionally key , pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key - audio signal sounds.
- enter switch trm in sec. (1-99 or 0) and push key - audio signal sounds.
- push and hold key , additionally key , pushed and held for 3 seconds, until audio signal sounds.
- enter current mastercode - audio signal sounds.
- push key - audio signal sounds.
- enter new mastercode and push key - audio signal sounds.
- audio signal sounds
Switchcode 2:
Switchterm 1:
Switchterm 2:
Mastercode:
restore/backup Mastercode:
If your mastercode has been lost, you may backup to factory setting (789) and restore.
- switch off voltage supply.
- push and hold keys + + simultaneousely.
- restart voltage supply .
factory settings: current attitudes:
switchcode 1: ................................................
switchcode 2: ................................................
switch term 1: Sek. .........................................sec..
switch term 2: Sek. .........................................sec.
Mastercode: ................................................
123
456
3
3
789
