- FCC COMPLIANCE -
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may
cause undesired operation. If the device is not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications and
void the user's authority to guarantee the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
FREQUENCY ANALYZER
RING MODULATOR
Congratulations You have just purchased one of the most sophisticated
and unusual musical accessories ever designed.
-OPERATING INSTRUCTIONS-
Your unit comes with a 40volt/100ma tip positive, external power adapter.
Use only the adapter supplied. Using the wrong adapter can cause serious
bodily injury. Using the wrong adapter may also damage your unit and will
void the warranty. Please note that this adapter is not interchangeable with
other Electro-Harmonix adapters.
The Frequency Analyzer gives you two additional notes beside the one you
play if you are playing chords. It’s harder to achieve control when you play
more than one note at a time because you’re getting two notes for every one
you play. Basically, you play a note… you get that note plus a note above it
and another one exactly as far below the main note as the other one is
above it.
But… by turning your BLEND dial CW you can filter out your original note.
As you turn the Blend control, the volume of the original note goes down or
up, but the overall volume remains constant. In other words, you can set it
so you get your original note plus two new ones… or two new notes with the
original… or a mixture of both.
The SHIFT control gives you basic frequency. It has a range of four to five
octaves. The FINE control permits fine tuning of the SHIFT control and
covers almost an octave with just a little twist.
On the front chassis panel is a filter which is a bass-treble control. With the
switch in the bass position the top note is filtered out giving you the original
note plus one bottom note.
It is easier to get good results fast by using the Frequency Analyzer with any
kind of amplified wind instrument. The more accustomed you are to playing
single note lines the more quickly you will adapt to using the accessory.
