Electrolux DF7190 Bedienungsanleitung

DF7190

DF7290

Einbau-Flachschirm-Dunstabzugshaube

Built-In- Flat-Screen Fume Extractor Hood

Hottes aspirantes encastrables à visière plate

Cappa aspirante da incasso con schermo piatto

estraibile

Inbouw-wasemkappen met plat scherm

Campana empotrable de aspiración de vahos con

visiera plana

Montage- und Gebrauchsanweisung

Installation and Operating Instructions

Instructions de montage et mode d'emploi

Istruzioni di montaggio e per l'uso

Montage- en gebruiksaanwijzing

Instrucciones de montaje y para el uso

DE 2

Bedienungsanleitung

INHALTSVERZEICHNIS

EMPFEHLUNGEN UND HINWEISE......................................................................................................................................8

CHARAKTERISTIKEN...........................................................................................................................................................9

MONTAGE............................................................................................................................................................................10

BEDIENUNG........................................................................................................................................................................12

WARTUNG...........................................................................................................................................................................13

EN 1

RECOMMENDATIONS AND SUGGESTIONS

INSTALLATION

• The manufacturer will not be held liable for any damages resulting

from incorrect or improper installation.

• The minimum safety distance between the cooker top and the extrac-

tor hood is 650 mm.

• Check that the mains voltage corresponds to that indicated on the

rating plate fixed to the inside of the hood.

• For Class I appliances, check that the domestic power supply guaran-

tees adequate earthing.

Connect the extractor to the exhaust flue through a pipe of minimum

diameter 120 mm. The route of the flue must be as short as possible.

• Do not connect the extractor hood to exhaust ducts carrying combus-

tion fumes (boilers, fireplaces, etc.).

• If the extractor is used in conjunction with non-electrical appliances

(e.g. gas burning appliances), a sufficient degree of aeration must be

guaranteed in the room in order to prevent the backflow of exhaust

gas. The kitchen must have an opening communicating directly with

the open air in order to guarantee the entry of clean air.

USE

• The extractor hood has been designed exclusively for domestic use to

eliminate kitchen smells.

• Never use the hood for purposes other than for which it has ben de-

signed.

• Never leave high naked flames under the hood when it is in operation.

• Adjust the flame intensity to direct it onto the bottom of the pan only,

making sure that it does not engulf the sides.

• Deep fat fryers must be continuously monitored during use: over-

heated oil can burst into flames.

• The hood should not be used by children or persons not instructed in

its correct use.

MAINTENANCE

• Switch off or unplug the appliance from the mains supply before carry-

ing out any maintenance work.

• Clean and/or replace the Filters after the specified time period.

• Clean the hood using a damp cloth and a neutral liquid detergent.

650 mm min.

EN 1

CHARACTERISTICS

Dimensions

Components

Ref. Q.ty Product Components

11 Hood Body, complete with: Controls, Light, Blower,

Filters

81 Directional Air Outlet grille

91 Flange ø 150 mm

10a 1 Flange ø 120 mm

10b 1 Adapting ring ø120-125mm

20 1 Closing element

Ref. Q.ty Installation Components

7.1 2 Hood BodyFixingBrackets

12a 8 Screws 3,5 x 16

12e 2 Screws 2,9 x 12,7

12f 5 Screws 2,9 x9,5

Q.ty Documentation

1 Instruction Manual

12e

12a

12f

10a

10b

12a

7.1

12a

7.1

EN 1

INSTALLATION

Drilling the Support surface and Fitting the Hood

• The Hood can be fitted directly on the

lower surface of the Wall Units (650 mm

min. above the Cooker Top) using the snap-

on Side Supports.

• Make an opening on the lower surface of

the Wall Unit, as indicated. (fig.1)

• If the cabinet is without bottom, fix the two

brackets at a distance Bof minimum 30mm

and maximum 60mm. (fig.2)

• Before carrying out the installation, the

wooden transportation protections screwed

on the visor and on the canopy body must

be removed. (fig.3)

• Choose the correct flange measure basing

on the air outlet diameter and insert it to the

upper air outlet opening. (fig.4)

• Screw the closing profile 20 onto the rear

part of the hood, using the screws 12f (2.9

x 9.5) provided. (fig.5)

• Open the sliding suction panel.

• Remove the metal grease filters one by one

by turning the hooks provided.

• Close the sliding suction panel again.

• Insert the Hood until the snap-on side sup-

ports click into place. (fig.6)

• Open the sliding suction panel.

• Lock in position by tightening the screws

Vf from underneath the Hood. (fig.6)

• If necessary, adjust the whole filter holder

unit and proceed as follows:

• Loosen the four adjustment screws Vr

and close the sliding panel again. (fig.7)

• Move the entire filter holder unit until it

is properly aligned with the wall unit.

(fig.8)

• Keeping the hood canopy still, remove

the sliding panel and lock the adjustment

screws again. (fig.7)

• The hood can now be fastened to the

wall unit using the four screws 12a (3.5

x 16) provided. (fig.9)

• Replace the metal grease filters.

• Close the sliding suction panel again.

523

162

10a

10b

12a

EN 1

Connections

DUCTING VERSION AIR EXHAUST SYSTEM

When installing the hood in ducting version, a rigid or a

flexible pipe with the diameter corresponding to the

flange diameter is used in order to connect the hood to

the air outlet piping.

• Fix the pipe with an adequate quantity of pipe

clamps (not supplied).

• Remove possible charcoal filters.

RECIRCULATION VERSION AIR OUTLET

• Cut a hole ø 125 mm in any shelf that may be posi-

tioned over the hood.

• Insert the flange 10a on the hood body outlet.

• Connect the flange to the outlet on the shelf over the

hood using a flexible or rigid pipe ø120 mm.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Fix the directional grille 8on the recirculation air

outlet using the 2 screws 12e (2,9 x 12,7) provided.

• Ensure that the activated charcoal filters have been

inserted.

12e

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole switch having a contact gap of at least 3

mm..

EN 1

USE

By pulling out the sliding panel it is possible to automatically activate all the hood functions.

By simply closing the sliding panel all the functions are switched off.

SWITCH FUNCTIONS

LLight Switches the lighting system on and off

MMotor Switches the extractor motor on and off

1. Low speed, used for a continuous and silent air change in the presence

of light cooking vapour.

2. Medium speed, suitable for most operating conditions, thanks to an op-

timum relation between hood performance and noise.

3. Maximum speed, suitable when the highest cooking vapour emission

has to be eliminated for longer periods.

i. Intensive speed, suitable for the strongest cooking vapours and odours.

EN 1

MAINTENANCE

Grease filters

CLEANING METAL CASSETTE GREASE FILTERS

• The filters must be cleaned every 2 months, or more frequently

in case of particularly heavy use of the hood. Filters can be

washed in a dishwasher.

• Pull out the sliding suction panel.

• Remove the filters one by one, after having disconnected the

relative fastening elements.

• Wash the filters, taking care not to bend them. Let them get dry

before refitting them. (The colour of the filter surface may

change throughout the time but this has no influence to the fil-

ter efficiency).

• When refitting the filters, make sure that the handle is visible

on the outside.

• Close the sliding suction panel.

Charcoal filter (Recycling version)

REPLACING CHARCOAL FILTERS

• These filters are not washable and cannot be regenerated, and

must be replaced approximately every four months or more

frequently by particularly heavy use.

• Pull out the sliding suction panel.

• Remove the grease filters.

• Remove the saturated carbon filter by releasing the fixing

hooks

• Replace the grease filters.

• Close the sliding suction panel.

Lighting

LIGHT REPLACEMENT

11 W fluorescent light.

• Remove the metal terminals fixing the glass.

• Slide the glass cover to the right until the left hand is free.

Lower it slightly and slide it to the left to free it completely.

• Replace the light with a new one of the same type and rating.

• Replace the glass cover in reverse order.

436002988_ver2

Bitte geben Sie unserem Kundendienst folgende Angaben bei einer

Störung an:

If your appliance has a fault, please contact our service engineer and

state the following numbers:

Veuillez donner les indications suivantes à notre service après-vente en

cas de panne:

Qualora constataste un difetto vi preghiamo di comunicare i seguenti

dati al nostro servizio tecnico assistenza clienti:

Geef onze klantenservice bij een storing de volgende gegevens op:

Por favor suministre a nuestro Servicio Postventa los datos siguientes

al haber ocurrido una avería:

E-Nr. 610

F-Nr.

AEG Hausgeräte GmbH

Postfach 1036

D-90327 Nürnberg

Dir. 89/336/CEE

73/23/CEE

93/68/CEE

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Electrolux Dunstabzugshaube Handbücher

Electrolux

Electrolux EFG 535 Bedienungsanleitung

Electrolux

Electrolux EI36PC60GS Bedienungsanleitung

Electrolux

Electrolux WHGL9040CN Bedienungsanleitung

Electrolux

Electrolux ICON RH36WCT6GS Bedienungsanleitung

Electrolux

Electrolux DBGL1032CN Bedienungsanleitung

Electrolux

Electrolux DD 8625 Bedienungsanleitung

Electrolux

Electrolux EI30DD10KS Bedienungsanleitung

Electrolux

Electrolux EFC 1420 Bedienungsanleitung

Electrolux

Electrolux EFT7540OX Bedienungsanleitung

Electrolux

Electrolux EFP 60310 Bedienungsanleitung

Electrolux

Electrolux EFV55464OW Bedienungsanleitung

Electrolux

Electrolux MCH 660 Bedienungsanleitung

Electrolux

Electrolux EFC90420 Bedienungsanleitung

Electrolux

Electrolux CH120 Bedienungsanleitung

Electrolux

Electrolux ICON RH42PC60GS Bedienungsanleitung

Electrolux

Electrolux EFC70011 Bedienungsanleitung

Electrolux

Electrolux EFC 9418 Bedienungsanleitung

Electrolux

Electrolux DBE6980HM Bedienungsanleitung

Electrolux

Electrolux DAK5535SW Bedienungsanleitung

Electrolux

Electrolux EFI711X Bedienungsanleitung

Electrolux

Electrolux EFV539K Bedienungsanleitung

Electrolux

Electrolux CH 1200 Bedienungsanleitung

Electrolux

Electrolux EFC6422 Bedienungsanleitung

Electrolux

Electrolux WHGL9040CN Bedienungsanleitung

Beliebte Dunstabzugshaube Handbücher anderer Marken

emmeti

emmeti RECUPA MED A-140 Leitfaden

Nibe

Nibe F135 Bedienungsanleitung

Kuppersberg

Kuppersberg INTRO 60 Montage- und Wartungsanleitung

Zephyr

Zephyr Spruce AK9834BS Installationsanleitung

Hisense

Hisense MH6INBG Bedienungsanleitung

Miele

Miele DA 1255 Bedienungsanleitung

Broan

Broan 46000 Bedienungsanleitung

GE Profile PV977 Originalbetriebsanleitung

FALMEC

FALMEC FFRIA24W5FS Bedienungsanleitung

Whirlpool

Whirlpool RH2600XL-1 SERIES Bedienungsanleitung

Küppersbusch

Küppersbusch DX ISLA Bedienungsanleitung

ETNA

ETNA AV360RVS Bedienungsanleitung

JUNO

JUNO JDF603E6 Bedienungsanleitung

Miele

Miele DA 6708 D Bedienungsanleitung

Tricity Bendix

Tricity Bendix LE 150 Handbuch

AEG

AEG X68163BV1 Bedienungsanleitung

AEG

AEG 125 D Bedienungsanleitung

Smeg

Smeg KSEV97X Bedienungsanleitung