ElmoTech 1TRACK Betriebsanleitung
Installation and Operation Guide
Information in this documentation is subject to change without
notice and does not represent a commitment on part of
Elmo-Tech Ltd. The software described in this document is
subject to the license agreement that is included with the
product, which specifies the permitted and prohibited uses of
the product. Any unauthorized duplication or use of this
documentation, in whole or in part, in print, or in any other
storage or retrieval system is prohibited.
No part of this publication may be reproduced, transmitted,
transcribed, stored in a retrieval system, or translated into any
language in any form by any means for any purpose other than
the purchaser’s personal use without the permission of
Elmo-Tech Ltd.
© 2002-09 Elmo-Tech Ltd. All rights reserved.
Unless otherwise noted, all names of companies, products,
street addresses, and persons contained herein are part of a
completely fictitious scenario and are designed solely to
document the use of an Elmo-Tech product.
Contact Us
Corporate Headquarters
Elmo-Tech Ltd.
2 Ha-Barzel St.,
P.O. Box 13236,
61132 Tel Aviv, Israel
Tel: 972-3-7671800
Fax: 972-3-7671801
U.S.A Customers, call 1-800-313-1483
E-mail: [email protected]
Visit us at: www.elmotech.com
i
Table of Contents
1Introduction.................................................................... 1
Components..................................................................... 2
LED Indicators.................................................................. 2
2Installing the 1TRACK Unit ............................................. 5
Installation Equipment....................................................... 5
Installation Tools .............................................................. 6
Verifying Offender Information in the E3-MWS ...................... 6
Activating the 1TRACK Unit ................................................ 6
3Status Alerts ................................................................. 11
Low Battery ....................................................................11
Motion No GPS ................................................................12
Strap Tamper ..................................................................12
Device Tamper ................................................................12
Geographic Zone Alerts.....................................................13
4Dismantling the 1TRACK Unit........................................ 15
Before Dismantling...........................................................15
Performing an End of Service.............................................15
Removing the 1TRACK Unit ...............................................16
5Cleaning the 1TRACK Unit ............................................. 19
1TRACK Installation and Operation Guide
ii
List of Figures
Figure 1 1TRACK Components ................................................2
Figure 2 1TRACK LED Indicators .............................................3
1
1 Introduction
The 1TRACK wearable tracking unit was designed specifically for
Offender monitoring operations. With security redundancies and
anti-tamper mechanisms built-in across the platform, the
1TRACK unit provides a trustworthy and reliable tracking
system.
The 1TRACK unit operates on the E3 software platform and
benefits from over a decade of field experience.
The 1TRACK unit tracks Offenders outdoors utilizing GPS
technology and communicates the data to the monitoring center
via GPRS.
Each monitored Offender is assigned a tracking unit which
continuously tracks the Offender’s location in real-time. The
1TRACK unit stores and processes the tracking data and
communicates with the monitoring center or assigned Officers to
report locations or violations. Alerts are preset to the Offender’s
individual schedule and zone restrictions.
1TRACK Installation and Operation Guide
2
Components
The 1TRACK unit features the following components:
Figure 1 1TRACK Components
LED Indicators
The 1TRACK unit features three LED indicators on its top. Each
LED can flash green or red to inform the Offender of the unit’s
status. If vibration notification is enabled, the 1TRACK unit also
prompts the Offender to look at the LEDs by vibrating. The LEDs
are labeled as follows:
fPWR – see page 3
fGPS – see page 4
fZone – see page 4
1 Introduction
3
Figure 2 1TRACK LED Indicators
PWR
The PWR LED indicates the condition of the 1TRACK unit
battery.
fFlashing Green – The 1TRACK unit is activated or is in the
process of being activated, and the battery does not need to
be charged.
fFlashing Red – The 1TRACK unit is activated and the
battery needs to be charged.
fSolid Green – The 1TRACK unit is connected to the charger
and the battery has been completely recharged. You may
remove the 1TRACK unit from the charger.
1TRACK Installation and Operation Guide
4
fSolid Red – The 1TRACK unit is connected to the charger
and is not yet fully charged. The 1TRACK unit should not be
disconnected from the charger.
fOff – While the 1TRACK unit is on and active, a turned-off
PWR LED indicates that the unit has entered power save
mode.
GPS
The GPS LED indicates the condition of the GPS reception.
fFlashing Green – During activation, the GPS LED flashes
green once every second together with the Zone LED until
the unit completes its GPRS call to the monitoring center
and acquires a GPS signal.
fFlashing Red – The 1TRACK unit has accumulated 10
minutes of Offender motion in a 60 minute period without
receiving a signal from the GPS satellites. For more
information, see Motion No GPS on page 12.
fOff – The 1TRACK unit has a valid GPS signal.
Zone
The Zone LED indicates geographic zone violations.
fFlashing Green – During activation, the Zone LED flashes
green once every second together with the GPS LED until
the unit completes its GPRS call to the monitoring center
and acquires a GPS signal.
fFlashing Red – Indicates that the Offender has violated one
or more zone restrictions. For more information, see
Geographic Zone Alerts on page 13.
fOff – The Offender is compliant with all zone restrictions.
5
2 Installing the 1TRACK Unit
Installing the 1TRACK unit involves:
fCollecting the appropriate installation equipment and tools
fVerifying that the Offender is registered in the E3-MWS
software
fActivating the unit
Installation Equipment
The kit of installation equipment includes the following items:
f1TRACK unit
fPower adapter
f1 strap
f2 tamper plugs
f2 pin trays
Warning: The 1TRACK unit’s battery must be fully
charged.
Press and hold the Activation button (Figure 1) for one
second to check the battery’s status.
fIf the PWR LED flashes green, the battery is fully
charged.
fIf the PWER LED flashes red, the battery is not fully
charged and must be charged for up to two hours.
1TRACK Installation and Operation Guide
6
Installation Tools
Installation also requires the following tool:
fStrap cutter
Verifying Offender Information in the E3-MWS
Verify the following Offender details in the E3-MWS software
application:
fOffender’s name and address
fOffender’s program type – 1TRACK
fEquipment serial number – This must match the serial
number on the 1Track unit you are planning to activate
fSIM card details
For more information about working with the E3-MWS system,
refer to the E3-MWS Monitor Operator’s Manual.
Activating the 1TRACK Unit
To activate the 1TRACK unit:
1. Press and hold the
Activation button on the
front of the 1TRACK unit for
one second.
The PWR LED flashes green
once.
Note: If the PWR LED flashes red, or not at all, the
1TRACK unit needs to be charged.
Inhaltsverzeichnis
