- 5 -
PARTS DESCRIPTION
1. Thermostat knob
2. Air outlet
3. Power switch (750W; 1250W; 2000W)
ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied
separately in the box) must be fitted to the unit.
These are to be attached to the base of the heater using the 4 self-tapping screws
provided, taking care to ensure that they are located correctly in the bottom ends
of the heater side moldings.
OPERATION OF THE HEATER
Note: When the heater is turned on for the first time, or when it is turned on
after a longer period of storage, it is normal that the heater may emit some smell
and fumes. This will disappear when the heater has been on a short while.
Set the thermostat to the minimal position and insert the plug to the power supply.
Turn on the power switch: 750W, 1250W, 2000W.
Turn the thermostat knob in a clockwise direction to the max position.
Once the room temperature has reached the desired value, turn the thermostat knob slowly in
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting, and switch off if it is above the setting.
SAFETY SYSTEM
The appliance has a resumable safety system which automatically switches off the unit when overheated, for
example, due to the total or partial obstruction of the vents. In this case, switch off the appliance, remove the
plug from the socket. Let it cool down for about 30 minutes and remove the object which is obstructing the
vents. Then put the plug in the socket and switch on the heater. It should now operate normally.
Irretrievable safety system: When overheat happened, if above resumable safety system is out of order or if
resumable safety system switches off the appliance, but the internal temperature continues to rise,
irretrievable safety system will work. If this situation happens, the appliance shall be send to repair.
CLEANING THE HEATER
1. Always unplug the heater from the wall socket and allow it to cool down completely before cleaning.
2. Clean the outside of the heater by wiping with a damp cloth and with a dry cloth.
3. Do not use any detergents or abrasives and do not allow any water to penetrate the heater.
STORING THE HEATER
When the heater is not used for a long time it should be protected from dust and stored in a clean dry place.
TECHNICAL DATA
Supply voltage: 220-240V ~ 50-60Hz
Power consumption: 1800-2000W
