Emerson Fisher FIELDVUE DVC6200 SIS Konfigurationshandbuch

www.Fisher.com

Fisher™FIELDVUE™DVC6200 SIS Digital Valve

Controller PST Calibration and Testing using

ValveLink™Software

The test procedure contained in this Instruction Manual Supplement is to be considered as a guideline only and should

be modified to address site‐specific requirements. Use this procedure in conjunction with the DVC6200 Series quick

start guide (D103556X012) and the DVC6200 SIS instruction manual (D103557X012). In addition, exercise good

engineering practices and abide by specific plant safety guidelines for safe operation.

WARNING

This document is not intended to be used as a stand‐alone document. It must be used in conjunction with the following

documents:

Safety Manual for FIELDVUE DVC6200 SIS Digital Valve Controller and Position Monitor (D103601X012)

Fisher FIELDVUE DVC6200 SIS Instruction Manual (D103557X012)

Failure to use this instruction manual supplement in conjunction with the above referenced manuals could result in

personal injury or property damage. If you have any questions regarding these instructions or need assistance in obtaining

any of these documents, contact your Emerson sales office.

For additional information on Partial Stroke Testing and associated parameters refer to Partial Stroke Test Information

on page 19.

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

PST Calibration

This document covers the basic PST calibration, as well as details for making adjustments to the normal end, using

Advanced Settings (see figure 11).

Figure 1. Calibration > Partial Stroke

Confirm SIS Tier

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 2. Set Instrument Out of Service and start Partial Stroke Test calibration

Refer to figure 11 for

information on Advanced

Settings

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 3. Enter the Desired Outgoing Ramp Rate

Supports separate ramp

rates for outing and

incoming strokes

Figure 4. Enter the Desired Incoming Ramp Rate

Additional ramp

rates for the

incoming stroke

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 5. Enter the Travel Target Movement

Target Travel Movement is the

percentage of travel from the

normal end

Figure 6. Partial Stroke Calibration progress

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 7. Partial Stroke Calibration progress

Will calibrate to 30% from

the normal end

Figure 8. Configuring SIS Triggers

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 9. Partial Stroke Calibration Progress

Figure 10. Calibration Procedure Complete

List of parameter values

being downloaded to the

device

If you need to make adjustments to the normal end default settings, select Advanced Settings, as shown in figure 11,

and make the necessary adjustments.

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 11. Select Advanced Settings to Make Adjustments to the Normal End

Select to define the

normal end

Figure 12. Set Travel High End

Defines the normal end of travel

(where the valve is when the

process is running normally)

The point at which valve

seating occurs will vary slightly

every time. Do not set this

higher than 99.5% or lower

than 0.5%.

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Figure 13. Enter Target Travel Movement

Figure 14. Partial Stroke Calibration Progress

Running a PST calibration will enable Short Duration PST. If this is not desired, refer to figure 24 for information on

disabling Short Duration PST.

Instruction Manual Supplement

D104299X012

DVC6200 SIS

October 2018

Configuration

After successfully calibrating the valve for PST go to the Detailed Setup SIS/Partial Stroke tab and verify the values for

the parameters in the Test Configuration group box are correct. Then go to the SIS Options group box and enable any

of the behaviors required for the PST.

Figure 15. Verify Test Configuration and Test Acceptance Criteria

Andere Handbücher für Fisher FIELDVUE DVC6200 SIS

Inhaltsverzeichnis

Andere Emerson Controller Handbücher

Emerson

Emerson Dixell XM670K Verdrahtungsschema

Emerson

Emerson Dixell XR44CX Verdrahtungsschema

Emerson

Emerson Bettis XTE3000 Bedienungsanleitung

Emerson

Emerson Fisher EZR Bedienungsanleitung

Emerson

Emerson DanLoad 6000 Kurzanleitung

Emerson

Emerson 2000LP Series Bedienungsanleitung

Emerson

Emerson Fisher FIELDVUE DVC6200 HW1 Bedienungsanleitung

Emerson

Emerson KEYSTONE FIGURE 79U Handbuch

Emerson

Emerson ECD-002 Bedienungsanleitung

Emerson

Emerson TESCOM Einrichtungshandbuch

Emerson

Emerson DL8000 Bedienungsanleitung

Emerson

Emerson EXD-HP1 Bedienungsanleitung

Emerson

Emerson XM678D Technisches Datenblatt

Emerson

Emerson FISHER SR8 Bedienungsanleitung

Emerson

Emerson Vilter Vission 20/20 Bedienungsanleitung

Emerson

Emerson AVENTICS NL1 Bedienungsanleitung

Emerson

Emerson Fisher Accu-Pressure Y693 Bedienungsanleitung

Emerson

Emerson TESCOM WegaMed Compact Series Bedienungsanleitung

Emerson

Emerson Fisher FIELDVUE DVC6200 SIS Bedienungsanleitung

Emerson

Emerson dixell XC650CX Bedienungsanleitung

Emerson

Emerson EZH Series Bedienungsanleitung

Emerson

Emerson Bettis Q series Gebrauchsanweisung

Emerson

Emerson dixell XC10CX Verdrahtungsschema

Emerson

Emerson DIXELL XR77CHC Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung

3M MicroTouch EX113 Bedienungsanleitung

KUHN

KUHN TKS Bedienungsanleitung

S&C

S&C PMH Bedienungs- und Wartungshandbuch

Regin

Regin CORRIGO L10 Bedienungsanleitung