Emerson Rosemount 2460 Bedienungsanleitung

Quick Start Guide

00825-0100-2460, Rev AA

September 2020

Rosemount™ 2460 System Hub

Contents

About this guide...........................................................................................................................3

Overview......................................................................................................................................5

General information...................................................................................................................11

Installation................................................................................................................................. 12

Configuration.............................................................................................................................35

Operation...................................................................................................................................58

Product certifications................................................................................................................. 59

Quick Start Guide September 2020

2 Rosemount 2460 Tank Hub

1 About this guide

This Quick Start Guide provides basic guidelines for installation and

configuration of the Rosemount 2460 System Hub.

NOTICE

Read this manual before working with the product. For personal and system

safety, and for optimum product performance, ensure you thoroughly

understand the contents before installing, using, or maintaining this

product.

For equipment service or support needs, contact your local Emerson

Automation Solutions/Rosemount Tank Gauging representative.

Spare Parts

Any substitution of non-recognized spare parts may jeopardize safety.

Repair, e.g. substitution of components etc, may also jeopardize safety and

is under no circumstances allowed.

Rosemount Tank Radar AB will not take any responsibility for faults,

accidents, etc caused by non-recognized spare parts or any repair which is

not made by Rosemount Tank Radar AB.

CAUTION

Make sure that there is no water or snow on top of the lid when it is opened.

This may damage the electronics inside the housing.

CAUTION

Be careful when opening the lid in very low temperatures. High humidity and

temperatures far below the freezing point may cause the gasket to get stuck

to the lid. In that case you may use a heating fan to warm the housing in

order to release the gasket. Be careful not to use excess heat which may

damage the housing and electronics.

CAUTION

The products described in this document are NOT designed for nuclear-

qualified applications. Using non-nuclear qualified products in applications

that require nuclear-qualified hardware or products may cause inaccurate

readings. For information on Rosemount nuclear-qualified products, contact

your local Emerson Sales Representative.

September 2020 Quick Start Guide

Quick Start Guide 3

WARNING

Failure to follow safe installation and servicing guidelines could result in

death or serious injury.

•Ensure only qualified personnel perform the installation.

•Use the equipment only as specified in this manual. Failure to do so may

impair the protection provided by the equipment.

•Do not perform any service other than those contained in this manual

unless you are qualified.

•Substitution of components may impair Intrinsic Safety.

Explosions could result in death or serious injury.

•Verify that the operating atmosphere of the transmitter is consistent

with the appropriate hazardous locations certifications.

•Do not remove the gauge cover in explosive atmospheres when the

circuit is alive.

High voltage that may be present on leads could cause electrical shock.

•Avoid contact with the leads and terminals.

•Ensure the mains power to the device is off and the lines to any other

external power source are disconnected or not powered while wiring the

device.

Electrical shock could cause death or serious injury.

•Use extreme caution when making contact with the leads and terminals.

WARNING

Physical access

Unauthorized personnel may potentially cause significant damage to and/or

misconfiguration of end users’ equipment. This could be intentional or

unintentional and needs to be protected against.

Physical security is an important part of any security program and

fundamental to protecting your system. Restrict physical access by

unauthorized personnel to protect end users’ assets. This is true for all

systems used within the facility.

Quick Start Guide September 2020

4 Rosemount 2460 Tank Hub

2 Overview

2.1 Communication

The Rosemount Tank Gauging system supports various communication

interfaces for field devices, TankMaster PC and other host computers.

Figure 2-1: Typical Configuration of a Rosemount 2460 System Hub

A I

J J

A. TankMaster

B. USB, RS232

C. Modem

D. Ethernet (Modbus TCP), RS232, RS485

E. TRL2, RS485

F. DCS/Other hosts (TRL2, RS485, RS232)

G. Rosemount 2460 System Hub

H. Modbus RTU/TCP

I. Other hosts

J. Field devices

K. Tankbus

L. Rosemount 2410 Tank Hub

M. Primary bus: TRL2, RS485

N. TRL2, RS485, other vendors

O. Secondary bus: Enraf, Whessoe and others, HART 4-20 mA analog

output/input

September 2020 Quick Start Guide

Quick Start Guide 5

The Rosemount 2460 System Hub collects measurement data from field

devices and transmits the data to a host system. It also handles

communication from a host to the field devices.

The Rosemount 2460 supports a number of host communication interface

standards such as Ethernet, TRL2, RS485, and RS232. TRL2 and RS485 are

supported for field device communication also, as well as other standards

such as Enraf and Digital Current Loop (Whessoe).

Quick Start Guide September 2020

6 Rosemount 2460 Tank Hub

2.2 Components

This section shows the various parts of the Rosemount 2460 System Hub.

Note

The Rosemount 2460 is designed for use in non-hazardous areas.

Figure 2-2: Rosemount 2460 System Hub Front and Top View

A. Main label

B. Locking ring for securing lid

C. External ground terminal (M5 screw, flat, lug dimension max. 10 x 4

mm)

D. LEDs for status and error messages

E. Cable entries (Nine (9) M20 x 1.5, Two (2) M25 x 1.5)

F. Lid (can be removed by removing the locking ring)

G. Terminal compartment with communication boards and ports

September 2020 Quick Start Guide

Quick Start Guide 7

Figure 2-3: Cable Entries

E F G

A. Cable entry M25

B. Cable entries (6 x M20 x 1.5)

C. Cable entry M25 (power)

D. Membrane

E. Cable entries (3 x M20 x 1.5)

F. Cable entry for Ethernet connection ETH 1

G. Cable entry for Ethernet connection ETH 2

Quick Start Guide September 2020

8 Rosemount 2460 Tank Hub

Figure 2-4: Inside the Rosemount 2460 System Hub

A. Communication boards

B. Write protection switch

C. Terminal board / ports (1 to 8)

D. Ethernet ports

E. USB port

F. SD memory card slot

G. LEDs (power=green, status=yellow, error=red)

H. Power input connector (IEC C16)

I. Fuses

J. Ground bar

Note

For signal/shield wire ground only.

September 2020 Quick Start Guide

Quick Start Guide 9

2.2.1 Write protection switch

The Rosemount 2460 System Hub is equipped with a write protection switch

for preventing unauthorized changes of the 2460 configuration database.

Figure 2-5: Write protection

OFF

A. Write protection switch

In addition to the switch, the Rosemount 2460 supports software write

protection.

Quick Start Guide September 2020

10 Rosemount 2460 Tank Hub

Andere Handbücher für Rosemount 2460

Inhaltsverzeichnis

Andere Emerson Schalten Handbücher

Emerson

Emerson ASCO 3ATS Bedienungsanleitung

Emerson

Emerson SCKM120 Bedienungsanleitung

Emerson

Emerson Avocent SV 220D Bedienungsanleitung

Emerson

Emerson SM-ETHERCAT 0471-0128-02 Bedienungsanleitung

Emerson

Emerson Rosemount 2521 Series Bedienungsanleitung

Emerson

Emerson PACSystems SLM042 Bedienungsanleitung

Emerson

Emerson PENBERTHY MGS-314L Series Handbuch

Emerson

Emerson Liebert STS2 Bedienungsanleitung

Emerson

Emerson DWM COPELAND OPS2 Handbuch

Emerson

Emerson Rosemount 2130 Gebrauchsanweisung

Emerson

Emerson XWEB300D Bedienungsanleitung

Emerson

Emerson 80 Series GO Switch Bedienungsanleitung

Emerson

Emerson Rosemount 2410 Bedienungsanleitung

Emerson

Emerson Liebert NPS Bedienungsanleitung

Emerson

Emerson Rosemount 2130 Bedienungsanleitung

Emerson

Emerson TARTARINI V/31-2-AP-E Series Bedienungsanleitung

Emerson

Emerson SmartSwitch Bedienungsanleitung

Emerson

Emerson Rosemount 2110 Bedienungsanleitung

Emerson

Emerson Rosemount 2410 Konfigurationshandbuch

Emerson

Emerson Rosemount 2120 Bedienungsanleitung

Emerson

Emerson Rosemount 2140 Bedienungsanleitung

Emerson

Emerson Rosemount 2160 Bedienungsanleitung

Emerson

Emerson Cybex SCM120 Bedienungsanleitung

Emerson

Emerson VLS**435A Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch