2.4.4.1 SCALE AND OUTPUT INITIAL VALUE SETTINGS FOR GOVERNOR OUTPUT:
1-
2-
3-
4-
5-
6-
7-
8-
9-
10-
11-
12-
13-
Frequency Set Value Frequency
Actual Value Governor Output
Frequency Set Value
Governor Output Frequency Actual Value
Governor Output
Frequency Actual Value Frequency
Set Value Governor Output
Frequency Actual Value Governor Output
Frequency Actual Value
Frequency Set Value
Note:
Set to “09.01.001.Frequency Control” parameter as “ ”.
Set to “09.01.003.Minimum Output Value” parameter as “ ”, and set to
“09.01.004.Maximum Output Value” parameter as “ ”.
Set to “09.01.005.Initial Value” parameter as “ ”.
Set to “09.01.006.Output Direction” parameter as “ ” and run generator on Manual
mode.
The first thing to do is to determine the direction of the GOVERNOR. For this,
“09.01.005.Initial Value” parameter increases slightly, for example by making “ ”,
analyzing the changing frequency of the generator. Than, GOVERNOR is noted as “ ”
direction if there is increasing on the generator frequency, and it is noted as “ ”
direction if there is decreasing.
Ensure the running of the generator at “ ” frequency by changing “09.01.005.Initial
Value” parameter. When generator runs at “ ” frequency, percentage value of the
“09.01.005.Initial Value” parameter is noted as “ ” value.
Ensure the running of the generator at “ ” frequency again by changing
“09.01.005.Initial Value” parameter. When generator runs at “ ” frequency, percentage
value of the “09.01.005.Initial Value” parameter is noted as “ ” value and generator
stops.
Set to “09.01.001.Frequency Control” parameter as “ ”.
Set to “09.01.003.Minimum Output Value” as “ ” or “ ” which is smaller than
the percentage values are noted on steps 6th and 7th.
Set to “09.01.004.Maximum Output Value” as “ ” or “ ” which is bigger than
the percentage values are noted on steps 6th and 7th.
Set to “09.01.005. Initial Value” parameter as “ ”.
If GOVERNOR direction is find out as “ ” on the 5th step, set to “09.01.006.Output
Direction” parameter as “ ”, but if GOVERNOR direction is find out as “ ” on
the 5th step, set to “09.01.006.Output Direction” parameter as “ ”.
Run the generator on Manual mode again. Go to “GOVERNOR CONTROL” working
page. At that page, when “ ” is “ ”, is observed that “
” is “ ” and “ ” is approximately “ ”. Than, set to
“ ” as “ ” by increment/decrement buttons. It is observed
“ ” and “ ” are began to increasing. When
“ ” value reach to “ ” value by increasing, it is observed that
“ ” reach to “ ” by increasing too. After that, set to “
” as “ ” by increment/decrement buttons. It is observed “ ”
and “ ” are began to decreasing. When “ ” value
reach to “ ” value by decreasing, it is observed that “ ” reach to
“ ” by decreasing too. For the last time, set to “ ” as “ ”
again. That means, GOVERNOR setting made with success anymore.
It is recommended to fix the generator voltage to “ ” when setting the Governor.
Passive
0.0%
100.0%
60.0%
0-Positive
65.0%
48.0Hz
48.0Hz
52.0Hz
52.0Hz
Active
50.0Hz
50.0Hz 50.00%
52.0Hz
100.00%
52.0Hz
48.0Hz
0.00%
48.0Hz 50.0Hz
400Vac
Positive
Negative
Scale-1
Scale-2
Scale-1 Scale-2
Scale-1 Scale-2
50.0%
Positive
0-Positive Negative
1-Negative
10
